I have been having a problem with my wizard. I flashed an amp rom and it was fine for a few months. Then it was randomly shutting on and off for no reason. If it was charged it wouldnt do this. Then it wouldnt barely turn on and it would turn on off on off on off. I tried flashing tnt 20273 rom and it got to 100% and then showed an error 302. Now it when i try turning it on the bootloader screen comes on off on off on off and it wont even turn on. If i remove the battery for a little while it will stay on longer. Any ideas?
It could be that your battery is finished - and time to be replaced. When my battery went, it would charge to 100% - be okay in stand by mode, but if it rang - the battery would drain and start to loop at the start up screen.
Phone would boot - get to the splash screen - then turn off - boot again, get to the splash screen - turn off. All on its own, without even having to touch a button.
I purchased a new battery - installed it in the phone - did not turn it on, attached it to the oem wall charger until the light turned green.
Once battery was fully charged - turned the phone on - and have had no problems since. Regardless of which rom I am running, or my inability to stop flashing every new rom that is posted - have had no problems
Good luck
I think this poor wizard has kicked the bucket. Now when i turn it on the screen is white with some black lines going across it. O well gives me an excuse to get a tilt.
Related
My photon was on 5% about an hour ago... then it turned itself off. I plugged it in to the charger and a "white/faint yellow" LED comes on. Normally the photon doesn't have a charge LED so this certainly struck me as odd.
It has been sitting for almost an hour and still won't turn on.
I took the battery out and reconnected the charger and the white/faint yellow LED comes back on, even with the battery pulled out.
What is happening here? Has anyone seen this?
I've see green/orange/red LED flashes for diff things but never white.
Well I found this thread: http://forums.androidcentral.com/sprint-photon/107931-led-not-working.html#post1147045
Looks like white means very low battery and charging. Now the white light has gone off while plugged in... But it still will not turn on
Turns out, I was plugging it into a PC usb that didn't have the drivers installed. The phone won't charge if the moto drivers are not installed, regardless of the light
I plugged it into a wall charger and viola... its back and running.
False alarm!
Lol, exact same thing happened to me! I totally freaked out, but plugged it in a wall and started working.
same thing happened to me yesterday. I plugged into the wall, NOTHING. I started freaking out, until I pulled the battery and re installed it. LED charge light then came on and all was good. Weird.
Can someone help me i have a photon also but when i plug it up it says failed to boot 2 starting rsd mode battery too low to flash and it wont boot up when plugged up to a computer. also when i plug it into the wall it just boot to the m sign
rodre12 said:
Can someone help me i have a photon also but when i plug it up it says failed to boot 2 starting rsd mode battery too low to flash and it wont boot up when plugged up to a computer. also when i plug it into the wall it just boot to the m sign
Click to expand...
Click to collapse
- Pull battery
- Put it back in so it's off
- Keep it plugged into the wall to charge it
- Once charged, power into RSD mode (power+vol up)
- Plug into computer and start RSD and flash 154_5 SBF to get back to stock
- then flash 198_7 SBF for good measure.
- Reboot
When i try that nothing works, it just stays on the white led light
I just bought mine from best buy and it did the same thing..they exchanged the phone since it was defective..
Sent from my MB855 using xda premium
Photon won't turn on anymore. White LED when plugged in
i have a refurbished replacement photon from best buy geek squad that i got last month. within a few days it was acting strange and randomly/often turning itself off. the battery was fully charged yet the unit would often times power down. this happened a lot the first few weeks. then last week the issue seemed to stop and it stayed on 24/7 as i charged it frequently. all was well until yesterday.
i dropped my phone from about 2 feet. the phone turned off and only the "m" boot up screen appeared after i powered on, then it went black. i had a fully charged battery in the unit when this happened. i plugged the charging cable into the phone and it kept booting up to this static "m" screen then turning off. the LED notification light went red and after numerous times powering on and off and resetting the battery (and sim card) i finally got a "5%" battery screen. a few seconds later it showed 100% battery then kept rebooting to the static "m" screen and shutting off again. then i started getting a "?" screen for the battery a few times and back to the 5% and it changed to 80%/100% very quickly and back to the blank screen. i left it plugged in overnight.
now the LED notification light turned white and the phone cannot be powered on. i tried another battery without any success so that shouldn't be the issue.
any ideas what to try next?
same thing happened to me.
thevaporz said:
i have a refurbished replacement photon from best buy geek squad that i got last month. within a few days it was acting strange and randomly/often turning itself off. the battery was fully charged yet the unit would often times power down. this happened a lot the first few weeks. then last week the issue seemed to stop and it stayed on 24/7 as i charged it frequently. all was well until yesterday.
i dropped my phone from about 2 feet. the phone turned off and only the "m" boot up screen appeared after i powered on, then it went black. i had a fully charged battery in the unit when this happened. i plugged the charging cable into the phone and it kept booting up to this static "m" screen then turning off. the LED notification light went red and after numerous times powering on and off and resetting the battery (and sim card) i finally got a "5%" battery screen. a few seconds later it showed 100% battery then kept rebooting to the static "m" screen and shutting off again. then i started getting a "?" screen for the battery a few times and back to the 5% and it changed to 80%/100% very quickly and back to the blank screen. i left it plugged in overnight.
now the LED notification light turned white and the phone cannot be powered on. i tried another battery without any success so that shouldn't be the issue.
any ideas what to try next?
Click to expand...
Click to collapse
Try to fully charge your battery using portable battery charger.
When battery full charge, try to entering recovery mode. From off condition, press both power and volume down, press down until you find android recovery and press volume up button. After you see exclamation logos, press both volume up and down. Then select wipe data. Hope fully you can still entering recovery mode.
If you cannot enter recovery mode, try to enter RSD protocol.
step is, connect your photon to PC using cable data, press both volume up and power, wait until it show RSD Protocol, than flash it again.
How to flash using RSDLite is in development section, you can read there.
Hopefully its can work
DssTrainer said:
Turns out, I was plugging it into a PC usb that didn't have the drivers installed. The phone won't charge if the moto drivers are not installed, regardless of the light
I plugged it into a wall charger and viola... its back and running.
False alarm!
Click to expand...
Click to collapse
I just had a mini-anxiety attack until I found your post. Thank you!
The first time I've allowed my battery to get very low since installing CM7 on my HTC Merge and I'm now having all sorts of problems.
Firstly my screen won't light up. It's just completely black. The phone is on and the 4 buttons at the bottom light up but that's all. The phone is still responding to my touch as I can load apps and hear noises if I happen to touch the correct parts of the screen. It's almost as if the brightness has been turned way down, but I'm unable to see the controls to try turning it up again. I have tried booting to recovery mode but that doesn't display either.
Secondly the battery won't charge. Since the battery is drained I can only get the phone on when it is plugged in, but the orange "charging" led at the top of the phone never lights up. It just casually flashes like it ordinarily would have done when it was running from the battery. I have two batteries and they're both doing this.
I can't be 100% sure that these problems are due to the installation of CM7 but I've never experienced it before so i'm guessing they're connected.
Does anybody have any suggestions on how I can get my phone working again.
It's also worth mentioning that it is also no longer recognised by my computer
Sounds like a hardware fault, if you have the same issues in recovery as you do in your os then its very unlikely its ROM/software related
I don't your device nor have I taken it apart so its only guesses I could give you on which component needs to be replaced, LCD or flex cable are best guesses
Sent from my Nexus 4 using Tapatalk 2
Want to update on this as I've just had another look at it after a while.
With the battery having completely drained, I connected the phone to charge via my PC and the orange charge light lit up and the phone went into recovery mode without any assistance from me. After about 2 seconds the screen went off again.
When the battery has charged sufficiently, I am once again able to turn the phone on and it boots up... but the screen remains blank.
If I discharge the battery and then plug it into my PC, I am able to repeat the appearance of the recovery screen, but it always vanishes before I am able to do anything.
The screen must be surely be functional or how would I get those 2 seconds of display ?
Does anybody have any ideas of what I can do to get the phone working again?
I acquired a new battery and after fitting it the phone immediately worked again. The battery was completely without charge but the phone charged it up without any problems. However, as soon as the power ran low the same thing happened; the screen has stopped working and the battery doesn't seem to charge anymore.
Phone has been running fine for months, then all of a sudden, it won't boot. Wife said she hasn't dropped it or anything. It is an SCH-i545 with the latest PhoenixROM.
When I turn it on, it briefly shows 'Samsung Galaxy S4', then that disappears and left with a blank black screen from which I can't reboot or shut off without taking out the battery. If I try download mode, I get the warning screen but it goes black before I can hit VolUp to continue. If i try recovery, I see the blue recovery starting text but then the screen goes black. Also, if I plug in the charging cable with battery out, then insert the battery, it won't turn on.
My phone did this. All efforts to get it to boot were futile. Samsung, and then dark. And then just never booted again. Even trying to charge it, the charging screen never showed. Not a vibrate or anything, I even shined a flashlight on the LCD to see if maybe the backlight just died, and again nothing. That was 4 months ago, and today for ****s and giggles I plugged it into my Anker battery to charge and the charging screen came up!!!!! I let it fully charge and then booted the phone and it works again!!!!
Now I just have to fix the screwup I did a long time ago with the radio, I did the "Golden Backup" improperly and my radio quit working on CDMA altogether. No documentation to be found, even Samsung upper tier support has no idea how to resolve it or even what the hell I'm talking about. I'm guessing there is no support but maybe flashing a modem will resolve it.
Graymayre said:
My phone did this. All efforts to get it to boot were futile. Samsung, and then dark. And then just never booted again. Even trying to charge it, the charging screen never showed. Not a vibrate or anything, I even shined a flashlight on the LCD to see if maybe the backlight just died, and again nothing. That was 4 months ago, and today for ****s and giggles I plugged it into my Anker battery to charge and the charging screen came up!!!!! I let it fully charge and then booted the phone and it works again!!!!
Now I just have to fix the screwup I did a long time ago with the radio, I did the "Golden Backup" improperly and my radio quit working on CDMA altogether. No documentation to be found, even Samsung upper tier support has no idea how to resolve it or even what the hell I'm talking about. I'm guessing there is no support but maybe flashing a modem will resolve it.
Click to expand...
Click to collapse
Same radio issue, I get no signal on the phone, just a circle with a diagonal line inside
This is sick
If you can get it to boot into fastboot, just reflash the full OEM rom which should include the modem image
Hey, so, firstly I have a blue life one x. I love the phone and haven't had any problems until now.
I got an android update and my phone restarted, which has happened with the last two updates I got, so I didn't think anything of it. However, my phone was practically dead when this started and it restarted and got to the screen where it says "Android is starting... Optimizing application 1 of 143"
It would get to around 100 and turn off, restart and get to about 100 and turn off again.
I googled around and found a thing called bootloop. By what now seems to be a stroke of luck, my phone eventaully charged to about 40% and I got it to turn on and everything was fine but a few days ago, it died again and I ran into the same problem.
I went back to the boot loop instructions and tried it to no avail.
My phone has a fixed battery, so removing it wasn't an option. I left of the phone off the charger for 30 minutes and held the power button for two minutes(to discharge any remaining power?). Plugged it back in and it went right back to trying to boot back up and optimize apps.
I then removed the case, detached the ribbon that connects the battery to the board, held the power button for two minutes and let it sit for 3 hours. I connected the ribbon, plugged the charger back in and it instantly tried to boot up back into the optimizing screen and turned off.
I did all this again but left it for the past two days and now its back to rebooting over and over...
Things of note:
The light indicator turns red when the phone is connected to a charger, whether the battery ribbon is connected or not.
When it displays the blu splash screen, the optimizing applications screen, or recovery mode, the light indicator is off.
I can get into recovery mode, but I can't do anything before the phone turns off and reboots again.
Any help would be appreciated!
So I picked my Umidigi phone up with bleach covered gloves and a bit must have got inside.
The phone now, when the battery has charge, repeatedly shows the boot screen (the logo) for a couple of seconds, and then goes dark for about 5 seconds. This repeats until the battery is completely dead.
When I plug it in to charge, the red light comes on - and then into the same boot loop.
If I play with the volume controls while this is going on, I can get the boot selection screen to appear - normal/bootloader/something else - I can even choose different options on there, but then the phone goes off again.
If I plug into my Pc, it connects and disconnects repeatedly - the connection doesn't last long enough (2 secs) for the Pc to identify the device.
So, I'm not interested in saving the phone, just the data - the camera was broken anyway. I've taken the back off (no easy feat) and left it in rice for several days - made no difference.
Any suggestions on what I can try next?