Hello
I tried to root my D620r with the lg root script v1.2 by avicooh but my cell phone has been stuck @ "Firmware Update - do not unplug" screen for +40 minutes, what do i do?
the command terminal is stuck too, showing:
special command: enter, leave
##_
Help, please.
Related
I've been trying to flash my p768 device since the update for JB p768 came out.
So I started flashing the KDZ file, followed all the necessary steps and finally when the process is at 17 percent, flashing stopped saying there is a problem between connection of pc and phone. So i did the workoaround, remove the usb cable and wait for at least 10 secs and reconnect, then waited for all the drivers to install. After restarting the whole process it got stack still at 17 percent. Now I cannot get out of Software update mode even if I remove the battery and start the device again. I know I made a newbie mistake..:crying:
Any help is appreciated, thanks a lot.
Hello,
If you were on ICS, you can use this method to unbreak your device :
http://forum.xda-developers.com/showthread.php?t=2085344
If you were on JB, the phone won't be recognized on "S/W Update" screen by the offline method. You must use the online method :
- Remove the lines you put in your "hosts" file ("127.0.0.1 csmg.lgmobile.com" and "127.0.0.1 csmgdl.lgmobile.com") then reboot your computer
- Connect your phone (on the "S/W Update" mode)
- Directly start "B2CAppSetup.exe" : it should detect your phone
- Click on "Customer Support" then "Recovery Phone" (see screenshot on http://forum.xda-developers.com/showthread.php?t=2217710)
- Wait and pray... It can be long because it downloads the last KDZ file from official LG servers
Good luck
EDIT : Important detail : while your phone is in "S/W Upgrade" mode, put back your battery (not empty) inside your phone or else your phone will probably stop during the recovery process.
OperationNT said:
Hello,
If you were on ICS, you can use this method to unbreak your device :
http://forum.xda-developers.com/showthread.php?t=2085344
If you were on JB, the phone won't be recognized on "S/W Update" screen by the offline method. You must use the online method :
- Remove the lines you put in your "hosts" file ("127.0.0.1 csmg.lgmobile.com" and "127.0.0.1 csmgdl.lgmobile.com") then reboot your computer
- Connect your phone (on the "S/W Update" mode)
- Directly start "B2CAppSetup.exe" : it should detect your phone
- Click on "Customer Support" then "Recovery Phone" (see screenshot on http://forum.xda-developers.com/showthread.php?t=2217710)
- Wait and pray... It can be long because it downloads the last KDZ file from official LG servers
Good luck
Click to expand...
Click to collapse
:good: Done! i was on ICS and used cmahendra's method on a different computer and it works! Maybe the first computer i've used is the problem and somehow doesn't communicate well with phone..
Great help mate!:victory:
Hey folks,
its bricked due to FOTA (I think it stands for: firmware over the air) update. This means the phone downloads a firmware update without computer connection or further PC-Software. Alas it didn't work.
Situation:
Phone starts, displays LG Logo and after that an 'updating firmware' screen for about 1 sec before rebooting and doing it all over again.
What I tried to solve this:
set up a new Win 7 32 bit machine to try to unbrick it. (drivers didn't work correctly on 64 bit) at least the MCCI driver update didn't)
connected the phone with the PC in Emergency Mode (holding VOL_UP + VOL_DOWN + PWR while USB is connected)
downloaded B2CApp (LGSupport Tool) and installed the device drivers for Emergency mode.
disabled the Android(Modem) dirver
downloaded V10D_00.kdz from LG home page
using the phones IMEI and this link:
http://csmg.lgmobile.com:9002/csmg/b2c/client/auth_model_check2.jsp?esn=IMEI_NUMBER_GOES_HERE
This gave me this link
http://csmgdl.lgmobile.com/swdata/WDLSW/LGE720/ADEUBK/V10d_00/V10D_00.kdz
I'm German so this seems all right, but I'm no expert​
installed msxml
ran KDZ_FW_UPD_EN and tried CDMA in CS_EMERGENCY Mode
A bunch of magic happend until the phone restarts during the process and is right back where we started, if I put it back to Emergency Mode while KDZ_FW_UPD_EN is still running the process finishes, but to no avail.
The log of this try is attached.
Where I am stuck now:
phone:
runs in Emergency Mode
is recognized by KDZ_FW_UPD_EN as well es LG Support Tool
Flashing via KDZ_FW_UPD_EN finishes
Flashing yields no result.
What else did I try
download V10C_00.kdz, as well as V10A_00.kdz from LG site and tried those with same result as with V10D_00.kdz
tried 3GQCT Type instead of CDMA
Wild guesses by me:
I need a different KDZ_FW_UPD_EN version, maybe different dll. I got it from here somewhre in a LG P500 related topic.
I messed up the driver install or need a different driver
LG hates me personally and planted this whole brick specifically to get to me.
The device really is permanently bricked, so I did all I could and there is nothing more to do? That would be sad, I hope I'm wrong here.
Additional Info:
The phone is not rooted and has never before been flashed. It ran with the same stock firmware since it was unwrapped.
The phone was not interrupted by power-loss during FOTA update.
The [read phone information] tool from KDZ_FW_UDP_EN crashes every time, maybe this tells somebody where things go wrong
Any help is appreciated. Ask for more info, if you need it.
Update - What else did I try:
I got the LG Support Tool to flash the Emergency Recovery all by itself runs till 99% --> reboots --> still stuck in same ol' bootloop
reentering Emergency Mode from the bootloop makes the Emergency Recovery finish with 100%, no error, but still bricked.
Regards
gimmeg
I Have a LG-F200k...
It has no recovery now ( all i see is a dead android lying with a red triangle)
It is shown as a device in "adb devices"
It is not shown in "fastboot devices"
It will not go past Ollah Logo after LG logo is displayed...
The Phone can go into "Download Mode"..
in desperation, i tried every possible way to flash it....followed every tutorial
The KDZ_FW_UPD gives this error
Upgrade Error
WParam : 100
LParam : 5000
If I use the UpTestEX_mod2_marwin, it will go 10% and then give an error..
Can someone help please ???
LG F200K fastboot mode started
I have lg f200k
help me my phone [870]Fastboot mode started [870] udc_start()
Hello, i acidentaly flashed the wrong aboot.img on my D620r whit flashify and rebooted, now it only goes in fastboot,
this is what it shows me when i boot my phone on top left and whit lg logo.
[420] fastboot_init()
[520] USB init ept @ 0xffe0000
[540]udc_start()
and when i plug it in, i can see it has simmple android device in windows like this: http://imgur.com/adFaSrY
and this is what ADB shows me : http://imgur.com/pOkKqE5
cans someone plese tell me what to do, i wnated to try this: http://forum.xda-developers.com/showthread.php?t=2800115
but the likns are broken.
EDIT: FIXED IT BY USING RECOVERY MODE IN LG SUPPORT TOOL!
Dear all
I just got v10 [H901] t-mobile ver from friend its info:
Android:5.1.1
Build no.:LMY47V
Software version:H90110c
Root:yes (rly!!)
BL: dunno [can't enter ]
Recovery: stuck at stock
1. Tried to use LG bridge to update stuck at remove battery and retry bla bla
2. Tried to use LGUP all ver model is unknown
3. Tried to enter BL using fastboot phone boots normal adb works perfect but don't boot to BL ever
4. Tried to use power+vol down phone boots normal as i said wtf that phone
5. Tried to flash twrp using flashify shows error scure boot error 1002 modifed then boots normal
Please guys help me or tell me way to damage that phone
Btw i loved that phone but its so hard to modify!!
Thanks in advance
BR
3andala said:
Dear all
I just got v10 [H901] t-mobile ver from friend its info:
Android:5.1.1
Build no.:LMY47V
Software version:H90110c
Root:yes (rly!!)
BL: dunno [can't enter ]
Recovery: stuck at stock
1. Tried to use LG bridge to update stuck at remove battery and retry bla bla
2. Tried to use LGUP all ver model is unknown
3. Tried to enter BL using fastboot phone boots normal adb works perfect but don't boot to BL ever
4. Tried to use power+vol down phone boots normal as i said wtf that phone
5. Tried to flash twrp using flashify shows error scure boot error 1002 modifed then boots normal
Please guys help me or tell me way to damage that phone
Click to expand...
Click to collapse
you may read here just for more information about h901 : https://forum.xda-developers.com/tmobile-lg-v10/general/unbrick-h901-f600l-board-2017-t3635697
samy2015 said:
you may read here just for more information about h901 : https://forum.xda-developers.com/tmobile-lg-v10/general/unbrick-h901-f600l-board-2017-t3635697
Click to expand...
Click to collapse
Many thanks bro but my v10 boots normal np
I just can't update or enter bootloader dunno why
But download mode boots & recovery boots os boots perfect too
Any help please ?