I just flash one custom rom and it says emergency calls only and after i install the original rom from xperia but its still emergency calls only it detect my sim ask for pin but after nothing i need help fast
Phone is from Tim Italy and came to me hung on Tim logo
I flashed with U32 recovery and firmware because I could not find u21 recovery
Phone boots up but is dual sim firmware, but phone is single sim
I can see only emergency calls and no network
Any one with a solution? Maybe u21 recovery if it exists?
Can I flash a custom rom to this phone?
Regards and thanks in advance
Hlw..!! i have a kitkat 4.4.2 device . Iv tried to install cm12.1 based lollipop 5.1 custom rom on it.Everything works just fine but after flashing it shows invalid imei and no network..so i flashed my imei nd after that i can see it by dialing *#06# but after all that a exclamatory symbol appears beside network icon and i cant use data by sim and network often comes nd goes . Though i can make / get calls nd sms but not service sms from sim operator .after activating WiFi the exclamatory sign get vanish. nd also during call on sim 1 sim 2 gets to 0 network....!!!
pls gys help me out here iv been trying to solve ths for almost a mnth........
I have 3GB RN3 pro. I have installed official TWRP 3.3.1. I have tried to flash most of the pie roms available for kenzo but I face the same problem.
First I flash the latest available firmware 'fw_kenzo_miui_HMNote3ProGlobal_V10.2.1.0.MHOMIXM_36c0f5ded3_6.0.zip', then ROM zip , after that I flash opengapps pico for arm64 android 9. After the first boot, I setup my device, both the sims get detected, 1st sim on 2g & 2nd on LTE. But the problem starts when I restart it again , after second boot, only 1st sim gets detected, 2nd sim shows 'Emergency call only' status. Resetting network settings, subsequent reboots do not help. Due to this issue , I am unable to use any PIE ROM.
jonny789 said:
I have 3GB RN3 pro. I have installed official TWRP 3.3.1. I have tried to flash most of the pie roms available for kenzo but I face the same problem.
First I flash the latest available firmware 'fw_kenzo_miui_HMNote3ProGlobal_V10.2.1.0.MHOMIXM_36c0f5ded3_6.0.zip', then ROM zip , after that I flash opengapps pico for arm64 android 9. After the first boot, I setup my device, both the sims get detected, 1st sim on 2g & 2nd on LTE. But the problem starts when I restart it again , after second boot, only 1st sim gets detected, 2nd sim shows 'Emergency call only' status. Resetting network settings, subsequent reboots do not help. Due to this issue , I am unable to use any PIE ROM.
Click to expand...
Click to collapse
R u using jio volte sim ?
Use volte sim for sim1
And non-volte sim in sim2.
Keep sim1 as default for data and calls.
And keep sim2 only for calls.
Black_Stark said:
R u using jio volte sim ?
Use volte sim for sim1
And non-volte sim in sim2.
Keep sim1 as default for data and calls.
And keep sim2 only for calls.
Click to expand...
Click to collapse
Yes.
Thank you, I'll try.
I want to crossflash g8x rom to my v50s for the dual sim, but how can i know if my v50s model can be dual sim after flashing
i crossflashed but no luck. everything is ok but no signal issue occurred. in network selection it shows 22 and cannot change network mode. when make call it shows "radio off" and says "turn off airplane mode"