I really hope anyone could help me somehow.
So i wanted to install magisk on my leeco le 2 pro because i cannot play pokemon go and use bank apps.
downloaded the manager installed it and downloaded the newest magisk through the manager.
Got the adb bootloader on my pc . flashed the twrp 3.0.1.2 (something) version for my phone. worked fine and booted into recovery..and there comes the problem. The logo says recovery but it doesnt boot into TWRP. after like 15 secs screen goes black and it boots back into usual.
idk whats wrong or need to be done else. without TWRP i cannot fully install magisk..anyone got an idea?
(android 6.0)
Related
Hello everyone,
I have a problem with my leeco Le max 2 - 6gb/64gb (x820).
I installed the ROM EUi cuoco92 and I would like to install a new rom (lineageOS 7.1.2 for LeEco MAX2)
I installed a new recovery on the official site, I followed the steps (install adb, drivers, unlock the boot loader ok and install Twrp)
When I finish it is not going to start on the twrp at startup there's marked recovery then a black screen and it vibrates several times to finally start normally on the old ROM)
Trwp no loadind or booting same for recovery Eui ! :crying:
I responded to the manipulation several times, I do not know what to do
Thank you and your help :good:
You'd be better off installing cuocos recovery. I had trouble with flashing roms with official twrp. You can find the file on cuocos thread
Sent from my Le X820 using Tapatalk
it's good with twrp recovery cuocos...thank you very much
luisoman2000 said:
You'd be better off installing cuocos recovery. I had trouble with flashing roms with official twrp. You can find the file on cuocos thread
Sent from my Le X820 using Tapatalk
Click to expand...
Click to collapse
it's good thank you very much.
sorry for my english i'm french...
Installing twrp on me Max 2
Ok, not sure if this is your problem - when trying to install twrp, that the installation all goes through correctly, but when rebooting - twrp has not loaded.
I have had the same problem on two Le Max phones now. I originally found the solution on xda ( or another site ) but only just remembered it just now .....
The solution is - after the install of twrp has completed on the phone you will be left with a screen with an image of 3gears, Chinese writing and in English - you've entered Fastboot Mode etc... , you need to hold the lower ( smaller ) power button down to make it reboot
But Immediately as it starts to reboot release the power button and quickly push and HOLD the volume button top ( up ) , then quickly do the same with the power button. The phone will beep a couple of times, release the buttons and the phone will boot into twrp.
It appears that if you don't carry out this sequence then the original startup sequence restarts and wipes the new twrp install, meaning that you have to go through the whole twrp sequence again. ( I've done it so many times now i've got really fast .... )
It was completely fine before that. It has been 3 weeks since I rooted the phone and it has been working perfectly. There was a pending update though (couldn't install it because it was leading to TWRP recovery mode at boot for some reason).
The battery was low, I connected the charger (not PC) and now the phone is not booting up. Just stuck on the logo. I can go into recovery mode and fastboot but that's it. I have no idea how to proceed.
8.2.4.0 (MHOMIDL)
Android version 6.0.1
I followed this guide to root my phone - r/Xiaomi/wiki/advanced/root (on reddit.com) (I can't link the link)
I would appreciate any help
Try to flash miui with my flash or something custom with twrp, if you need to backup data, you can do it with twrp.
its soft bricked....use mi flash tool to fladh fadtboot rom
Hello and Servus,
I recently got a Homtom from my neighboor to look at because its full of bloatsoftware and seems to have battery issuses.
First I tried to install TWRP by this guide "https://romprovider.com/2018/10/homtom-zoji-z7-root/" and this one "https://www.getdroidtips.com/twrp-recovery-zoji-z7/"
I was able to "install" twrp using adb but I was stucked in a bootloop after this, couldnt even get to recovery /twrp, so I tried my way with the Smart Phone Flash Tool.
Some problems where persistent and I couldnt connect my phone with the tool until I had to format it via.
After formating the phone and installing the stock rom I got from here "https://rootmygalaxy.net/stock-rom-on-zoji-z7-official-firmware/" I am now stuck even worse. I dont even have a bootloop, the phone just starts and goes off.
Even worse was it, after I tried to flash to a "higher" version I got from this post "https://forum.xda-developers.com/general/general/zoji-z7-4g-smartphone-t3613364" - I just got a display bug and couldn't do anything, so I flashed the stock rom again.
Right now the only thing that works is fastboot. If I try to boot it in recovery or else it just goes off.
Is there someone who can help me there ?
Hello,
the last two days I try to get TWRP working so I can install magisk. I installed TWRP via Odin and I can access TWRP.
But when I try to reboot into the normal system my phone gets into a bootloop. It starts shows the logo goes black starts again and so on. I can still enter TWRP through the button combination.
Any ideas what went wrong?
Device: Samsung S7 edge SM-G935F with Android 8.0.
Phone is on factory settings
Thanks in advance
Try reflashing the boot. Check if it works. If not try flashing the stock recovery back and then check.
If that also dont solve your problem. reflash things using ODIN.
I was installing TWRP but something went wrong so I couldn't boot into the operating system then I tried installing the stock ROM with XiaoMiTool V2. it installed the wrong but it still did not work then I tried installing it with MI flash while using all the latest files but this also doesn't seems to be working whenever I try to flash my phone it takes forever and never complete the flash it just goes to 100% and keeps on going I have left it for about an hour did not work then I tried other versions of the same software but for some reason it just shows flash done within 3 seconds and then nothing happens to the phone everything remains the same any idea what can I do