My ipaq 3660 died after charging and i'm looking for schematic diagram for it. Can anyone help?
Related
Experts,
Probably a newbie question, would my old iPaq 3950 power dongle work on my iMate PDA2k?
It fits in smoothly. What I'm not sure about is the pin assignment.
What I need to do is charge my Blue Angel in the car using the iPaq 3950 power dongle and a generic 5V / 1.5 Amp car charger.
The other alternative I have is to buy an O2 XDA car charger and modify it to fit in the Blue Angel connector.
Your help will be very much appreciated...
Is this what you also call a Wallaby?? need assistance. My qtek 1010 is not charging is there any other way I can charge the battery? An Ipaq 12v adapter was put into it by mistake I was told it was dead but I reset a couple of times and now it's working but it doesn't charge.
thanks.........bigdin
Charging Problems
I had the same problem with my old Wallaby (Qtek 1010). I had to hard reset the device and re-setup it to get it to charge again.
Could be that the fuse is blown up.....
Stefan
I flash my MDA Compact II to WM6 essential and i instal bateriiFIX and now i have a problem with charging my MDA in my car by charge 12V in my car. My MDA isn`t charge but show on screan charging.
sorry for my english
Read that
http://forum.xda-developers.com/showpost.php?p=1548598&postcount=237
Should help and explain you why...
Quick solution: connect the car charger and soft reset your charmer.
brgds
Andi
Hi,
My qtek 2020 don't charge width the car charger adapter or with an USB cable.
At this moment it only charges in the cradle.
Does anybody knows why?
Regards
Mário
bad connector?
hi my hermes battery is dead it i a,lways runing out of charger. but does anyone know if the kaiser batteries fit into hermes because the biggest one you can get without it doubling the size of the phone is only 1500mah but the kaiser are about 1750mah
thx chester