Is the GND of RS232 on pin 5 the same of Charge on Pin 2 o 16, 15, etc?
Thanx.., M.
yes
Hi.
What other chargers can I use for charging the GTab?
Am I right all chargers providing 5 Volts and minimum 2 Amps with USB connector are suitable - using the original Samsung cable?
Can I use my CubieBoard Charger - 5 Volts, USB connector but 3 AMPS?
nobody?
Hi!
After upgrading to Note 3 I had to put up with crappy charging experience if not using n3 charger and cable (which is silly short and stiff).
Note3: N3 charger and a micro USB cable (both N2 cable and regular micro USB ) = ~300mA charging rate.
Note3: Note2 charger + any micro USB = 300mA
Note3: Oem 2A charger + any micro USB = 450mA
Note3: any charger + USB3 micro = 300mA
Note2: N2 charger + micro USB = ~1600mA
Note2: oem 2A + most micro USB cables = ~1600mA
With Note 2 most combination of chargers and cables just worked for high speed charging, but with Note 3 it just an epic fail.
I'm not expecting highest charging rate any all chargers, but 300mA with original 2A Samsung Note 2 charger (or any other 2A and 1A chargers) is stupid.
Is there any way to get at least 1A charging rate with regular 5v chargers over micro USB?
if you look at the Note 3 original charger, it outputs 5.3V and 2amp, the Note 2 charger is only 5v and 2amp. Maybe that has an effect on the charging.
Hi,
could someone tell me what the pinout of amazfit stratos 2 charging dock is?
I know the internal two pins are D+ and D-, but which one is GND and 5V from the external one?
Could someone measure and post a picture - I lost my charging dock and want to build a new one.
Thank you very much.
As it is with probably all chargers out there, left is +5V, right is GND (pins on top of charger, of course).
Code:
+5V D+ D- GND
( )
lfom said:
As it is with probably all chargers out there, left is +5V, right is GND (pins on top of charger, of course).
Code:
+5V D+ D- GND
( )
Click to expand...
Click to collapse
thank you.
If you are here looking for the same question, but your watch is STRATOS 3. Bear in mind that pinout is opposite from STRATOS 2!
cheers.
tyjollo said:
If you are here looking for the same question, but your watch is STRATOS 3. Bear in mind that pinout is opposite from STRATOS 2!
cheers.
Click to expand...
Click to collapse
Means that D+/D- are Changes Position, right?
Hello
I need to solder charging wires directly to my motherboard in a Nexus 7 2012- I put it into my car and I just don't have enough space for the USB plug.
So here is what I have done now:
The brown wire is +5V and I will solder the GND wire somewhere, but the real question is, which pins should I short? I heard shorting D+ and D- can help with my slow charging but I have no idea which pins these are on the picture. Can someone tell me which ones to short with a solder blob? Right now the connection I made draws 0.8A of current.