Hi all,
I have problem with my SX56 speakers. The speaker doesn't work (No sound). But, when i put it on the cradle, it works perfectly good.
I tried to soft & hard reset, problem still there. Then, I try to run diagnostic using wallaby 5.22 boot loader, everthing are great including the sound part.
Anyone has the same problem ? Any idea to fix it ?.
Thanks a lot.
Related
I posted this over at PPCPassion too, and someone suggested I try here...just really looking for help. Here's what happened. I woke up, and my phone (TMo XDA with PPCTechs 64MB upgrade, 128SD card), which had been left on all night, doesn't work as follows:
-When I dial a call, I can't hear the other phone ringing through the speaker...and when the person answers, I can't hear them...nor can they hear me. The phone indicates 'Dialing' and then the duration time starts when they answer
-When I get a call, my phone rings, but when I answer, same as above, they can't hear me and I don't hear them
-But the speaker and mic DO work...I tested this using a voice memo.
-Also, same symptoms whether using spkr phone on or off
Any thoughts on this? It 'fixed itself' yesterday after I performed a back up (I was going to do a hard reset/restore). THen today same problem. Did the backup just to see if somehow that solved it, but this time it's not working. Before I do the hard reset I want to see if anyone else has any thoughts.
I really dont want to have to send this to TMo since my unit has 64MB from the upgrade...
Any help would be greatly appreciated. FWIW I'm not a developer so if you recommend technical things please explain them thoroughly :0
And THANK YOU in advance!
TM
Had the same thing happen to me. Thought of hardware failure at first, tried similar things and came to similar conclusions. Tried SD Backup, then hard reset. Not solved. Înteresting that during backup one dll file seemed to be stuck (think it was a dll, although dont remember name).
In my case solved itself when I remapped the RECORD action to the left button. Very strange......
Any permanent solution or reason would be welcome....
Phil
How did you go - the symptoms are the same as dropping pin 19 to ground (for a car kit), you lose speaker and built in mic so make sure 19 isn,t shorting with 18, Steve
Speaker & Microphone not working
I encounterd the same problem - from one day to the other mic and speaker stopped working. When I connect power to the device using a USB sync cable mic and speaker are turned on again. It really seems that the XDA is set into car mode. :?
Assuming that pins 18/19 were shorted, I have cleaned the connector but this didn't help.
There's another thing which has happened to people: it appears the connector for the headphones isn't all that sturdy, so after a while the device thinks the connector always stays in. Not sure that would explain this behaviour, but just thought I'd mention it.
Same problem happened to me... help
How do you solve this problem? I have tried to plug and unplug the headset and did a reset... still the only thing that comes out of the speaker is the ring. The only want I can use the phone or hear anything is to use the hands free... Please help.
Re: Same problem happened to me... help
adboom said:
How do you solve this problem? I have tried to plug and unplug the headset and did a reset... still the only thing that comes out of the speaker is the ring. The only want I can use the phone or hear anything is to use the hands free... Please help.
Click to expand...
Click to collapse
Fortunately, my device was still under warranty. I had to return it to O2.
Headphone Mode?
XDA developer Peter Poelman said:
There's another thing which has happened to people: it appears the connector for the headphones isn't all that sturdy, so after a while the device thinks the connector always stays in. Not sure that would explain this behaviour, but just thought I'd mention it.
Click to expand...
Click to collapse
Hi
My Qtek seems to be similarly stuck in the headphone mode. Any idea how to get out of it? Would removing the headphone socket entirely help?
Sands
Hi,
the speaker dosn't work anymore. But the strange thing is, that it is working in the bootstrap selftest.
Any help welcome
cu
Mal
Hey folks,
isn't there anybody who can help me?
cu
Jürgen
You could do a complete backup, then hard reset then see if it works.
It is probably due to a bad contact in your phone headset jack. Try plugging in your headset to check if your phone or pda works with the headset. If so, then try plugging-in and unplugging the headset plug to switch the jack connections back to the speaker. If this does not work try putting a drop of WD40 on the end of the headset plug and insert it in the jack a couple of times. (Do not spray directly into the jack). It might just clean up the contacts and get the sound back to the speaker. If all this fails, you may need to open up the phone to fix the jack.
I hope that you do not have to do the latter.
Best of Luck
hi all,
nothing of this worked.
But the Speaker works in the boot-menu Hardware-Test
ah
Hi mate. I've just had the same problem as you, tried repeatedly inserting and removing the jack - no luck. Used WD40 on the jack - no luck. Resigned to taking it to bits I removed the battery cover and noticed the little gap which leads through to a gold-looking connector by the headphone socket. I stuck my stylus in there and gave it a big wiggle and hey presto! Sound returned. Give it a go, you never know. Hope you get as lucky as I did.
Ant
Mal,
It seems that your problem is not a hardware one because your speaker actually works on boot-up. Do a search on this forum using the keyword "sound". There are a couple of posts on Aug 21, from other people having the same problem and one of them managed to get sound back by reverting to an earlier version of a software that was causing the problem.
Maybe you have a similar kind of problem.
Pat
Hi,
do you have a link to the topic. I only found articles to sound problems of the XDA-II.
thanx
MAL
Dear all,
Please help me out. My bro brought a second hand XDAII and when I upgraded his rom to WM2005, there has been NO whatsoever SOUND on his XDAII. The touch screen, phone calls, and any other sounds are totally mute (without any further software installation). My guess is that I had messed up something with the registry or with the system files. Any1 knows how to check this out?
BTW, I have been up-downgrading between different ROM versions and nothing helps!
Please, any kind souls, help me before my bro starts choking me to death.
Thank you in advance
Ken
Any audio coming from headset when plugged in??
cruisin-thru said:
Any audio coming from headset when plugged in??
Click to expand...
Click to collapse
Dear,
Yeah, that's strange, when the headset is plugged in, all the audio comes back to life again. Why is that?
Try inserting the headset and pulling it out sharply a few times, I think maybe the socket is stuck in headset mode, I may be wrong but it might be the answer.
It still doesn't work
I've tried that a few times, but it still doesn't work
Thank you anyway.
BTW, any other possible solutions to this
Thanks in advance
Ken
Finally it's resolved
Thanks to cruisin-thru, I finally managed my XDA to play audio sound. My trick was exaclty like what cruisin-thru suggested, except for that I did a little twist when I inserted the headphone into the socket :lol:
Now that I am assured it is hardware-related problem, I will try my best to have it exchanged for other device
Thank you cruisin-thru.
Ken
I've same problem but audio function just Mute (not after upgrade)
I do all Softreset and Hardreset not thing change
The finaly I do and the all audio came back is "Remove Battery" :wink:
from device then put it back.
Ake
Folks, Anyone having issues with factory provided stereo headphones (wired) after the latest ROM upgrade? My phone at times fails to recognise that the headphones are removed (FM keeps working, I can't take calls etc). O2 service fixed it once; however, problem keeps repeating (goes away after i remove and insert the headphones few times). Just wondering whether there is any issue due to upgrade. Did not have this problem before upgrade though.
Hi I face the same problem, I had mine coming from Hong-Kong without backlit, send back and got a new one today. Working this time, have tried all the stuff, last thing I did was put headset in to test radio and was ok but now there is no sound anymore !!! It seems the connector believes the earphone is still plugged. Even doing like you in and out several times, no sound coming back and the radio always start as if headset was in. I do not want to send it back again, pay customs for the third time....
Very disappointed, I would better keep my wizard or s100.
If anyone have an idea ? Do someone know where to find a step by step instruction to disassemble the atom ? May be it is just the contact in the connector staying closed??
Thanks Stéphane
no solution
I had to send it back for replacement :-(
I've an atom pure white instead and is working OK
Hi all,
I need help please, my phone falled in water but taken very quickly and opened and entirely dry, now it is working all fine but only one weired problem, the external speaker won't work, jack is working with headphones, bluetooth audio is working great also, I have changed the speaker itself (tried three different pieces) then changed completely the usb charging board but it does not work at all, any idea is really welcome please help me.
Thanks