I have just turnd my S310 on after not being used since September when I upgraded to an S710 to check if I had got any messages to my unused Orange number and the screen is blank even though it boots up fully and the Homescreen can be seen on my laptop using Jeyo mobile Companion 2.0, even a hard reset will not bring the screen back to life. Does this mean that my S310 can no longer be used as a Mobile?
Roland
Related
hi to all , Ive apear to have a terminal problem with my xda , for those who will need alead up to the failure here goes ,I was trying to connect to www.streetmole.co.uk just to dem the silver machine and i got a connection error displayed. I came out of data connection tapped the signal icon and it reverted to the icon for the phone without a signal strength ( not unusual on this phone ) and was unable to switch off the phone link also unable to acess the file to reboot the network provider manually at this time the display starts to flash the back light on and off .
Tried to extract my phone nos to a paper note pad but the contact listing of 100+ numbers tracked from end to end managed to recover 30 , so tried a soft reset ( no loss of my details ) to no avail decided to cold reset and loos my personal details and start from scratch , did not reload and now shows a static screen with microsoft mobile logo and srenn is flashing back light then reverts to O2 logo then after some time bleeps and reverts to microsoft logo , then repeats , O2 do not seem to advertise this xda and carphone ware house do not have it on display and are trying to find a replacement as they havnt sent it off for repair , is this unit being withdrawn as i read your forum pages it seems beset with problems was the 64 replacement any better ???
Warranty job
Hi
Using a recently purchased used Xda (64mb version). Trying to amend settings for Ornage SIM (machine was supplied already unlocked) the screen froze. Have tried soft and hard resets but nothing. All I have is the Microsoft Pocket PC 2002 screen which doesn't react to anything it appears. Even the battery light doesn't flash although I have fully charged it. Any offers of help out there??
Did you have the xda working with your orange sim? Have you tried unscrewing the top of the stylus and pushing it once in to the hole at bottom right of your xda, then wait one minute and press one time again? You will lose all data.
Yes, I had it working quite well with Orange. Had web browser plus using POP 3 to receive all incoming e mails. Couldn't send e mails though, hence trying to change seetings which is when it all went wrong. Tried soft reset first, followed by hard reset but still nothing other than the welcome screen
And this happens even with the sim removed? Sorry I should have asked that before. It seems to be exhibiting radio stack problems, but if you havent messed with that I dont know if its possible for it to corrupt spontaneously.
Yu, happens with SIM removed
I upgraded to WM 6.1 Professional V2 by Erofich yesterday. Phone works fine, except it will not sync. When the PC is connecting, the phone will lock. Sometimes the screen will go dark and the keys will light up, other times screen is just froze. Remove back cover and phone will restart.
Any ideas?
I had the dame issue before, go to this thread: http://forum.xda-developers.com/showpost.php?p=2406929&postcount=21
I hope this helps...
Thanks, but I don't get that far. As soon as Vista connects, the phone hangs.
It seems that a lot of people are having the same problem as we did with Vista. Have you tried it with a pc running XP? That's what I'm using right now and so far I don't have any issues that I used to have with Vista.
No, I will try that tomorrow night. All machines have various versions of Vista.
Trying this
Windows Mobile Device Center 6.1 for Windows Vista
This new version of the Windows Mobile Device Center contains key improvements and new features to support Windows Mobile 6 devices.
Update:
I tried all day at work and was finally able to get it to connect as Guest. The last thing I did was to turn off all the items on the Today screen. Flashed it back to ver 5 for now.
Hello Guys,
Ive got a problem with my HD2.
The Story: a few months ago, my HD2 switching automatically, between Standy and normal Mode. It Looks As somebody push the the standby Button every few seconds. Last Time the problem dissapering quitly As it appears. Yesterday the Effect came back.
Its a Europe HD2 Originally from HTC, without Software from any Provider.
EDIT: this Effect also Appears during normal use, e.g. Write a sms. The Display Turns off and the hd2 is in standby few seconds later the display go on and Show the lock screen.
Im sorry for my spelling, the stupid iPod trys to German Text because im from GER.
Hi,
A few days ago, I updated my HTC Titan (bought in 2011 in France as a sim-unlocked device) to the official Tango update (+ firmware update) through Zune.
Then, after doing a hard reset, the usual setup assistant is displayed, but at the end of it there is a new step that wasn't there before the update (titled "Almost Done") telling me that the phone is going to launch some kind of htc specific utility in order to configure my data connection for my carrier. Then after clicking on "continue", I see a black screen for about 15 seconds (like when an app doesn't manage to load properly and WP7 kills it because it took too long to start), then the start screen appears (but I don't receive the usual fake welcome SMS from Windows Phone).
I can launch apps, but the capacitive Back button, Start button, Search button don't react (they cause the phone to vibrate, but WP doesn't react to these commands).
After shutting down the phone and restarting it, I'm greeted by the setup recovering screen (titled "Welcome Back") telling me that Windows Phone will resume my setup where I left it (that explains why the capacitive buttons don't react: they were software disabled because Windows Phone considered it was still in first setup mode. Same for the fake welcome sms I didn't receive). Of course the same problem happens again when I tap on continue, and when I restart my phone.
I tried several hard reset through the usual methods (either through the about menu, or through the menu displayed using VolUp+VolDown at startup). Still the same problem. I guess it's a bug that should happen on many Titan devices. I contacted the HTC support and they told me to send my phone back to HTC for repair
Of course Zune won't let me restore the backup because of the firmware update not longer compatible with the backup.
Did anybody have the same problem with a stock htc titan rom?
I'm also wondering what is the new "HTC Log disable" command on the "CUST APPSBL" screen? I'm sure it wasn't there before the update. Is there some kind of htc specific logging that is enabled by default (since it is a "disable" command). What is being logged?
Also, the red diode (indicating when the battery is charging) is being lit during startup, which didn't happen before the update. Does that mean something?
Hi,
It is quite normal for the new Tango ROM to display that extra HTC specific step, even though it doesn't work!
I experimented with the Titan a bit and found that as soon as the Start screen appears after setup, before doing anything else, long press the Connection setup app in the app list and uninstall it.
It will enable normal functionality.
If needed you can always download it again from Marketplace.
「 Jai Hind 」
Sent from my GT-N7000 using xda app-developers app
It happened to me too!!!
Moreover, after a hard-reset the HTC Market disappeared in the market!
I disabled the pin to the sim re-formatted, and connected to electricity, and aftew few times HTC market reappeared (!), immediately updated ALL the htc software (even the connection wizard) and everything is OK now... exept the possibility to install INSIDER (by Microsoft)... it is said that the app is not available for my device (!!!) ... I used it until yesterday on my Titan with Mango... I REALLY DO NOT KNOW
BYE
link8506 said:
Hi,
A few days ago, I updated my HTC Titan (bought in 2011 in France as a sim-unlocked device) to the official Tango update (+ firmware update) through Zune.
Then, after doing a hard reset, the usual setup assistant is displayed, but at the end of it there is a new step that wasn't there before the update (titled "Almost Done") telling me that the phone is going to launch some kind of htc specific utility in order to configure my data connection for my carrier. Then after clicking on "continue", I see a black screen for about 15 seconds (like when an app doesn't manage to load properly and WP7 kills it because it took too long to start), then the start screen appears (but I don't receive the usual fake welcome SMS from Windows Phone).
I can launch apps, but the capacitive Back button, Start button, Search button don't react (they cause the phone to vibrate, but WP doesn't react to these commands).
After shutting down the phone and restarting it, I'm greeted by the setup recovering screen (titled "Welcome Back") telling me that Windows Phone will resume my setup where I left it (that explains why the capacitive buttons don't react: they were software disabled because Windows Phone considered it was still in first setup mode. Same for the fake welcome sms I didn't receive). Of course the same problem happens again when I tap on continue, and when I restart my phone.
I tried several hard reset through the usual methods (either through the about menu, or through the menu displayed using VolUp+VolDown at startup). Still the same problem. I guess it's a bug that should happen on many Titan devices. I contacted the HTC support and they told me to send my phone back to HTC for repair
Of course Zune won't let me restore the backup because of the firmware update not longer compatible with the backup.
Did anybody have the same problem with a stock htc titan rom?
I'm also wondering what is the new "HTC Log disable" command on the "CUST APPSBL" screen? I'm sure it wasn't there before the update. Is there some kind of htc specific logging that is enabled by default (since it is a "disable" command). What is being logged?
Also, the red diode (indicating when the battery is charging) is being lit during startup, which didn't happen before the update. Does that mean something?
Click to expand...
Click to collapse
Yes, exactly the same problem happened after hard-resetting on tango. I simply waited a bit with the phone on the main menu and the softkeys not working. After a while, I received the WP7 welcome text, and the softkeys started to work again.
maTTeo
Hi all,
I made a new hard-reset.
As suggested by maTTeo I simply waited even with softkeys not working... I only disactivated the pin on sim so that the Titan could find an internet connection.
After receiving the SMS of woelcome on WP7, I immediately upgraded all the HTC apps
Everythings seems fine for the moment...
BYE