My xperia x10 mini (no pro) have a bricked, i have 3 days tryng to revive, but nothing: I use: Byn4ri flash, Seus, Pc Companion, Diferent mode of install original roms, and now, in the flash tool dont detect my phone? what happen? HELP PLEASE I NEED OF ALL OF YOU.
Does the led of your phone flash the red colour three times? The red led flash three times because your phones battery is dead. So you plug in your phone with usb cable to the computer and let it remain for two or more hour (this means that you're charging your phone )During this time the phone would not turn on and you can do nothing with your phone during this time. You will only see the red led . After two hours of charging disconnect and run seus and Follow the onscreen instruction. I followed the above mentioned procedure and I got my mini back .
Sent from my stunning x10mini !
[MINICM 1.0.2 with CWM]
(Any problem ? Feel free to contact me - [email protected] , +919033451101)
Related
Hi,
Last night, i tried to root my Xperia x10i phone, following the steps in this article:
http://forum.xda-developers.com/showthread.php?t=711907
After completing the 1st step, i tried to boot my phone. I get the usual vibration when booting, and after a second or two, the phone had started vibrating endlessly.
Then i tried to recover it using PC Companion (Connected in flash mode). It downloaded the firmware and installed it to the phone flawlessly.
I disconnected the phone, in switch on. Get the usual vibration, and then the screen backlight starts to turn on and off constantly. As the PC Companion says this could happens for a few minutes at first boot after update, i waited, but it simply remains doing the same thing, and never show the SE logo.
I tried to repair again, this time using SEUS, following all the instruction, with same result.
I dont know what else can i do... Please Help!!!
this will help you http://www.youtube.com/watch?v=HmX-IYNYqL8
You mean try to flash it to 2.1? Or to 1.6?
flash it to 2.1
Ok. I've just tried to flash with a 2.1 x10i generic rom and a 2.3 x10i generic rom, following the steps in the video. Dont work...
hmm.. weird, any1 can help here?
Yesterday, i left the phone in the office, with the battery out, hoping that something i read in a forum, about this could work, was true. Today i take the phone, put the battery back, and turn on the phone, and... No luck... My xperia is still dead...
Try using SEUS instead of PC Companion.
Follow the instructions ins SEUS and make sure that the phone is off and hold down the BACK button before you plug in the USB cable and make sure you keep it pressed down until the software tells you otherwise.
I've done so, but still dont work... But i'll try again...
I've just tried with SEUS, which download the 2.3 update. SEUS run all the way, and says disconect and turn on. Same result...
Any sugestion?? I almost give up on this... =(
I have the same problem, i have tried to flash my phone like 30 times i have bought a new battery and still no go, it continuasly vibrates.
And i don't even have to pres the back button to put it to flash it always on startup stayes in flash mode.
i hv diff problem , i m stuck on sony ericsson text phn isnt even booting
nw
i hv tried this one and tbhaaanmmmmm ITS FINE NOW
http://forum.xda-developers.com/showthread.php?t=1196421&highlight=root+2.3.3
Nope done that and nothing it only vibrates and doesn't stop
Hi would appreciate some help as i seem to of exhausted all avenues...
Was loading a new rom with xrecovery and twice it would'nt load so without any thought took out cable when it rebooted was left with just SONY ERRICSSON in white screen.
It appears no rom is on at all now and will not recognise on superoneclick, flashtool or seus!!
I've tried many times but to no avail HELP!!!
lounger64 said:
Hi would appreciate some help as i seem to of exhausted all avenues...
Was loading a new rom with xrecovery and twice it would'nt load so without any thought took out cable when it rebooted was left with just SONY ERRICSSON in white screen.
It appears no rom is on at all now and will not recognise on superoneclick, flashtool or seus!!
I've tried many times but to no avail HELP!!!
Click to expand...
Click to collapse
Can you still access xrecovery at all?
If not, what can you when you try to flash something via flashtool?
Did you try PC Companion instead?
Flash the stock SE firmware (I would recommend the 2.3.3 one to save yourself trouble) from Flashtool. If that doesn't work, you're pretty much screwed.
DL firmware from here : http://forum.xda-developers.com/showthread.php?t=920746
Best option is given by Panzerfaust101
Another option is as follows:
Remove the battery.
Connect your phone to system with the battery still out.
Now hold the back button and put the battery on, green led will glow.
Now you are on flash mode and this would stay for not more than 10 secs, install the latest firmware and then try accessing Xrecovery.
Its should do the trick!!
hey guys while I was falshing my rom of xperia x10 via flashing tool follwed the procedures given after it completed and asked me to unplug the device and switch it on... now phone dos not boots and has got stuckd at sony ericsson logo...its not moving ahead... not even booting.. I ve tried to connect again in flashing tool flash mode still its not working .. phone automatically gets disconnected.. also wen I put the battery inside it turns on to sony ericsson logo automatically even if I dnt use power on button.. help me out... plz plz plz
Please give some info.
Have you unlocked bootloader?
What rom are you trying to flash?
When you start to flash, flashtool asks for disconnect the phone, power off and connect again with BACK button pressed. Then the process continues...
After flashing kernel you must enter to recovery and install zip file from sd-card.
Regards.
I was tryng to flash rom 3.0.1.G.0.75 on Gingerbread 2.3.3 and ya I was supposed to enter downloading mode but before I do dat phone has stuckd on... gets on wid sony ericsson logo evn if I dnt swtch on...help me..
Please, can you provide the followed procedure ?
Maybe this thread can help you http://forum.xda-developers.com/showthread.php?t=1226826&highlight=lock+bootloader+again
Which log do you use, PC Companion, SEUS, Flashtool...?
Do you have a CWM recovery ?
If you don't know how (or are afraid) to use flashtool...
You can do that :
1/ Launch SEUS (Sony Ericsson Update Service) HERE
or PC Compagnion HERE
2/ Turn off your phone, remove the battery over 5 seconds, replace it.
3/ Hold the right button (the one with the arrow) and plug your phone on your computer with usb (It calls flashmode)
4/ The green led must be light on and SEUS or PCC recognize your phone...
5/ Now you just have to follow the instructions to install a stock rom.
If it doesn't help, you can use flashtool... A great tuto HERE Thanx to Crowds
With it you can unlocked the bootloader and install a new kernel with CWM recovery inside...
Install a new rom, root your phone... ans so more stuffs...
I hope it helps...
I've been told to install x recovery on the computer,take out battery n unplug the phone .Then have flash base band on computer(it will then show that its trying to download)connect phone in flash mode.to do this hold down the bottom right hand button(the back arrow)on your phone then put battery back in(KEEP HOLDING back arrow button)and plug the cable back into your phone.I hope this helps.GOOD LUCK BUDDY!
I am having the same problem with my Xperia Neo, i tried to connect my phone to PC Companion and it says. "PC Companion was unable to connect to your phone, please disconnect and connect again"
My phone is just sitting there with the words "Sony Ericsson" flashing on and off, I fear that my phone is bricked but im not 100% sure, if there is anything that can be done please help!!!
Can you explain more what you're doing ?
Do you did that :
Launch Pc Compagnion
Plug the phone
Mount the sd card
EDIT : Sorry i read too fast your post... Your phone can't turn on you're stuck on the bootlogo of SONY ERICSSON...
Do you plug the phone in flashmode ?
nicks2587 said:
hey guys while I was falshing my rom of xperia x10 via flashing tool follwed the procedures given after it completed and asked me to unplug the device and switch it on... now phone dos not boots and has got stuckd at sony ericsson logo...its not moving ahead... not even booting.. I ve tried to connect again in flashing tool flash mode still its not working .. phone automatically gets disconnected.. also wen I put the battery inside it turns on to sony ericsson logo automatically even if I dnt use power on button.. help me out... plz plz plz
Click to expand...
Click to collapse
Some of the custom roms are flashed with xrecovery or cwm,
Now what kind of rom did you want to flash?
Maybe you went wrong that in procedures said "flash the rom".
Put out the battery then put in and turn your device on then restore your previous rom then try again and install(flash) new rom.
Good luck.
Sent from my X10 using XDA
Hi guys, i have looked everyway but still couldnt find solution to my X10 mini 's problem. Please help me!
I managed to root and install xrecovery on my x10 mini(elcair) with flashtool. Took the next step and tried to install CWM recovery, and use it to run miniCM6.
After the white sony ericsson logo disappeared, the blue android with the spinning light appeared, but now it seems get stuck here.
I tried using PC companion to restore my phone, but when my phone go into flashmode, there's a windows pop-up saying the USB driver failed to install and USB device cannot be recognized. Tried using flashtool but it doesnt work either. When i tried charging the phone with the charger, the green LED light did not light up too. I was wondering whether its hardware or software problem. Anyone faced similar problem before or knows what can i do next?
I dont have e x10 so im not sure if i can help you but does it have a button combination to get in to download or recovery mode?
You may want to install the drivers for your phone again ,and try to connect your phone again.
Take a SE Stock ROM and flash it using the newest Flash-Tool according to the description how to flash.
This works - I had this problem also on a X10.
Hope it helps.
Hi, I know there were many similar topics but this case looks different. I've tried to update my xperia Z using PcCompanion (to newest available kitkat) during flashing i got an error and all I saw after turning it on was grey triangle with warning. PC companion see my phone but cannot repair it (I got error 100), during flashing three different OFW in flashtool it always stucks on kernel or system flashing (excluding them in installation make possible for flashtool to finish the job) It gives constant blue light in fastbot mode but when i'm connecting it in flash mode it only blinks green and then red for a second each and remains black. I can make force shutdown only when it's in charger and being in charger it only blinks with red light and when I want to turn it on it only vibrate once and do and show nothing. It's not rooted, has locked bootloader and battery over 60 % full. Does anyone may help ?