[Q] Photon Bricked, RSD Lite not working! - Motorola Photon 4G

here's the issue I'm having when I try to flash back to stock:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I rooted phone successfully but didn't want to unlock bootloader because I wanted to keep my 4G... I was ignorant to the fact that you can't flash Cyanogenmod with locked bootloader and tried flashing with bookstrap apk. Phone stuck in
"Failed To Boot 2"
if someone can help me get this fixed I'd be willing to donate to your developing.
any questions just pm me.

---

Im assuming you've tried a different SBF and still wont flash? If not i'd start there.. Also do a factory data reset before flashing with sbf, if not you may get bootloops. Can you type out exactly what it says under "staus"? Your ss cuts off

---

If your battery is too low, the flash will fail in rsd lite. Also your battery can't charge in rsd mode. You need to charge the battery with another phone, wall charger or cut a charger and put the black and red wire on the correct + and - points where your battery is.

---

Anybody notice the phone is showing it's in fastboot mode?

---

Thanks everyone for trying to help, Sprint replaced my phone though

---

Stuck at Fastboot Support Protocol
Lokifish Marz said:
Anybody notice the phone is showing it's in fastboot mode?
Click to expand...
Click to collapse
this happened after my photon froze during a OTA it stayed in the same screen for a few hours so I did a battery pull and I keep getting "Failed to boot 1"
I have my phone it this exact same situation. My battery is dead at the moment but I made a factory cable not sure if that's a suitable replacement for fully charged battery. Anyways whenever I plug in the factory cable it says "Fast Support Protocol" but if I press the volume+ rocker it does not do anything, it just stays there. If I hold the volume it simply blinks and turns off.
Is there any known solution for this? I already ordered a wall charger but would love to get it working before that gets here.
thnx all