Hello, I'm new on this site, and already I need help.
Here is problem:
I rooted my Xperia S, and I regret for that (it's kind of slower, and I hate that) but beside that, I was trying to find solution to speed it up. U flashed the kernelV2, I mean that I think I was xD And then my wifi didn't work. So I googled up a lil bit, and find the kernel named "DooMKernel". I followed instructions and nothing, so I shut down my phone, actually reset it (holding POWER buton and VOLUME UP until it vibrates 3 times), and after that nothing, my phone wont turn on. As I remember my phone was at 35% of battery. And only hope that I have is, when I plug USB in my laptop, it makes a sound of connected device, and install SEMC Flash Device . I'm very afraid that my phone is broken, cause, I have it about 10 days, and I'm new android user. Don't take me too noob, I read lot of forums, tips, solutions, but in the end, I'm new in all this.
So, please does anyone have any solutions, what can I do? Please! (P.S. my phone is plugged in charger for about half of hour, without any response or light)
Thank you all, anyway.
Are you on ics rom? If yes doomkernel wont work
Connect phone to pc in fastboot mode by pressing power and vol up hold it till the first vibrate now release only the power button if the led turns blue flash the xsx kernel (example)
If you are on gb rom try to reinstall the system using pccompanion enter flasode by pressing power and vol up till the first vibrate now only push vol down and flash
Sent from my LT26i using xda premium
mericon said:
Are you on ics rom? If yes doomkernel wont work
Connect phone to pc in fastboot mode by pressing power and vol up hold it till the first vibrate now release only the power button if the led turns blue flash the xsx kernel (example)
If you are on gb rom try to reinstall the system using pccompanion enter flasode by pressing power and vol up till the first vibrate now only push vol down and flash
Sent from my LT26i using xda premium
Click to expand...
Click to collapse
Thank you for response.
I tried that, to put it in fastboot mode, nothing. My phone doesnt show any kind of led light in any situations (red when is in charger, blue in fastboot mode, green is flashmode). Only when I connect my phone on laptop it makes a sound of new device connected named SEMC Flash Device. I was thinking to fall apart my phone, to put out battery, maybe that would help.
It helped!!!! I didn't see your answer very well. Thank you!!! Is there anyway to put phone back unrootet, cause I don't like it, its kind of slowy
mericon said:
Are you on ics rom? If yes doomkernel wont work
Connect phone to pc in fastboot mode by pressing power and vol up hold it till the first vibrate now release only the power button if the led turns blue flash the xsx kernel (example)
If you are on gb rom try to reinstall the system using pccompanion enter flasode by pressing power and vol up till the first vibrate now only push vol down and flash
Sent from my LT26i using xda premium
Click to expand...
Click to collapse
Can you give me some advice, what kernel to use, how to flash it, ect?
I'd give you a big hug, you don't know how much you helped me (nothing gay)
Try this to install the drivers correctly
http://forum.xda-developers.com/showthread.php?t=1554632
Sent from my LT26i using Tapatalk 2
try this:
hold the power button + volume up then wait till it vibrates 3 times, your phone will power off,
1. install flashtool
2. download ftf
3. paste the ftf on c:\firmwares\
4. open flashtool then click the lighting icon, choose fastmode, choose ftf and wait until it says (power off phone then connect via fastmode), since your phone is power off all u need to do is to connect the phone and then hold the power button+ volume down.
5. then it will reinstall your firmware.
6.after installing unplug your phone then power it on.
voila its working now
Hi guys,
i was tring to get root on my xperia p with firm 6.1.1.B.1.54 but i flashed the wrong kernel(for xperia U) and now the phone doesn't start at all and i cannot enter in flashmode for reflash a new kernel..
if i press volume + and power button the phone starts to vibrate for a while..(atthe first time i could see a red light and violet light and the red again led)
if i press volume - and link to computer nothing happens.
flashtool can find the device but it says to plug the phone into flash mode...
what should i do???
help
Thanks
KOKOPELLIS said:
Hi guys,
i was tring to get root on my xperia p with firm 6.1.1.B.1.54 but i flashed the wrong kernel(for xperia U) and now the phone doesn't start at all and i cannot enter in flashmode for reflash a new kernel..
if i press volume + and power button the phone starts to vibrate for a while..(atthe first time i could see a red light and violet light and the red again led)
if i press volume - and link to computer nothing happens.
flashtool can find the device but it says to plug the phone into flash mode...
what should i do???
help
Thanks
Click to expand...
Click to collapse
after a lot of attemps ... i solved by using the volume + and power while it was linked to pc and after unlinking and linking in normal flash mode..
KOKOPELLIS said:
after a lot of attemps ... i solved by using the volume + and power while it was linked to pc and after unlinking and linking in normal flash mode..
Click to expand...
Click to collapse
i have the same problem with you. i tried it but nothing happen. i dont access to fashboot mode and flashmode .....
bloodtear225 said:
i have the same problem with you. i tried it but nothing happen. i dont access to fashboot mode and flashmode .....
Click to expand...
Click to collapse
First make sure you have installed the fastboot and flashmode drivers. Remove the datacable from PC. Press & Hold Volume Up Button and insert the datacable to PC to trigger Fastboot Mode. Press & Hold Volume Down Button and insert the datacable to PC to trigger flashmode.
bloodtear225 said:
i have the same problem with you. i tried it but nothing happen. i dont access to fashboot mode and flashmode .....
Click to expand...
Click to collapse
Probably the phone is not switched off cause you can't see anything... So be sure that is switched off and try again.that is essential.. Don't panic... U can solve it like I did
So basically when I try to go into Fastboot mode on my Sony Xperia Sola I hold the Volume up and then I connect the USB but the phone continues with a Orange/Red LED and then the Sony logo appears and bam it is in charging mode... My PC doesnt even detect a USB device(so it's not the driver).
But when I hold Volume Down and connect the USB I get a green LED...
ht::mostar said:
so basically when i try to go into fastboot mode on my sony xperia sola i hold the volume up and then i connect the usb but the phone continues with a orange/red led and then the sony logo appears and bam it is in charging mode... My pc doesnt even detect a usb device(so it's not the driver).
But when i hold volume down and connect the usb i get a green led...
Click to expand...
Click to collapse
i have this problem too! Tt someone help.
hAHa!!! said:
i have this problem too! Tt someone help.
Click to expand...
Click to collapse
Mybe you should hold volume up for fasboot mode.
Try use force poweroff . Press volume up + lock button until vibrate 3 time .
then try turn fastboot
You could try and do it from FlashTool:
Start FlashTool
Boot your phone up and connect it to your PC
Wait for your phone to appear on FlashTool
Click the lightning icon (Flash device)
Click Fastboot mode. A new box should appear.
Then click Reboot into Fastboot Mode (via ADB)
Hope this helps :
Trying to access flash mode to flash a working firmware. Phone will only blink red/green for a half second before shutting off. Cannot access the phone via flash mode to flash using flashtool. When I connect the USB cable holding the Vol up button the light turns blue and remains blue until I unplug. Am I missing something here?
Volume up gets you into fastboot mode, with the blue light. That's what you are getting. Volume down while plugging is how you get to flash mode. There will be no light, but you should hear or see a notification on your PC when it is recognized, if you have drivers installed.
Also be sure that you first choose the firmware and wait for flashtool to prepare it for flashing and then connect the phone with vol down, otherwise it will not work.
Regards
I had bricked my Sony z ultra by accidently
deleting OS through TWRP. When phone is
connected to wall power socket led glows red
and Sony logo appears. Logo will go off when
power+vol up is pressed for few seconds but
Will appear within few seconds. When connected
to Computer phones led will bink red and there
Will be continuous connect disconnect sound
From computer speaker. Computer sees the phone
Just an usb input device or unrecognised.
Flashmode (power+vol down) also fails in
Flash tool application in which message says
Usb debbug is disabled and I can't enable it in
Bricked phone. Is there any chance to revive my
Phone?
Ravi Chandra P said:
I had bricked my Sony z ultra by accidently
deleting OS through TWRP. When phone is
connected to wall power socket led glows red
and Sony logo appears. Logo will go off when
power+vol up is pressed for few seconds but
Will appear within few seconds. When connected
to Computer phones led will bink red and there
Will be continuous connect disconnect sound
From computer speaker. Computer sees the phone
Just an usb input device or unrecognised.
Flashmode (power+vol down) also fails in
Flash tool application in which message says
Usb debbug is disabled and I can't enable it in
Bricked phone. Is there any chance to revive my
Phone?
Click to expand...
Click to collapse
You can reflash it with flashtool by holding little white dot right next to sd card for about a minute or two then press volume down and after that release white dot and connect cable to the phone while still holding vol down and the phone will be resurected.
Believe me I did it after a few months of bricking my device but still was left in my draw.
Cheers