[Q] CM9 bootloops - Barnes & Noble Nook Tablet

I've search and I don't think I've seen an answer to this question yet and as my first question/post I'd like to say:
I'm running CM9.04 and I love it, but I'd like to assist in testing out the nightlies and AOKP etc..., but no matter what I do I always get a bootloop (Sometime shows the booting android for about half a second then reboot, sometime not even that). I see others say that these ROMs are working (as well as development ROMs do ) I clear all caches, factory reset and always the same thing (except on the .04 alpha release). Anyone else have this issue or a solution or suggestions?

Related

[Q] ICS-ROM 1.4.3 Huge glitch problem need help!!!

When i start my phone it gets really glitchy to point were i cant even see the screen any adviceeee?????
Install a GB ROM, and next time search read before you post (or even flash).
Such glitches in ICS ROMs are a known problem with no solution yet.

[Q] Device suddenly stops working and needs to be wiped

I have a serious issue with both my I9100 devices.
it suddenly freezes and requires reboot. when i do it, it stuck on boot screen (Where the yellow triangle would be if using unofficial firmware)
nothing helps, only wipe data. once I wipe, device loads fine and starts working again.
I tought at first its rom/kernel related, I switched everything and even tried stock rom.
it keeps happening...today, I tried to swap batteries as one got empty, I took the battery out of the stocked-rom device (after turning it off) and then later when i switched it on, it had to be wiped.
same as with my other device.
Anyone has any clue what this is about?
Its became a big issue for me, I cant flash/wipe every few days...
One device is on Neatrom 4.4 lite, the other stock-everything, both 4.1.2
eranyanay said:
I have a serious issue with both my I9100 devices.
it suddenly freezes and requires reboot. when i do it, it stuck on boot screen (Where the yellow triangle would be if using unofficial firmware)
nothing helps, only wipe data. once I wipe, device loads fine and starts working again.
I tought at first its rom/kernel related, I switched everything and even tried stock rom.
it keeps happening...today, I tried to swap batteries as one got empty, I took the battery out of the stocked-rom device (after turning it off) and then later when i switched it on, it had to be wiped.
same as with my other device.
Anyone has any clue what this is about?
Its became a big issue for me, I cant flash/wipe every few days...
One device is on Neatrom 4.4 lite, the other stock-everything, both 4.1.2
Click to expand...
Click to collapse
u can just rewert to stock ICS 4.0.3 firmware on both the phones and check for the issue (whether its firmware related or any hardware issue as such)
thanks for your help,
It did not happen on 403, tough it didnt happen on 4.1.2 for some while either.
what else would you suggest me to test?
eranyanay said:
thanks for your help,
It did not happen on 403, tough it didnt happen on 4.1.2 for some while either.
what else would you suggest me to test?
Click to expand...
Click to collapse
1) with 403 for some time once again to ensure no issues of freezing.
2)then a different 4.1.2 stock/custom rom altogether to check for the same(freezing) issue.
stay for some time on those firmwares and see (may be one or two charge cycles).
3) do not install any mods on top of the firmware, just stay stock and see
One of the devices is already back to 403, while the second one on stock 412
the hardest thing to tell if 403 solves it or not, as it happens occasionally, once in a week or two.
I tried two different stock roms, so that would rule out #2.
The weird thing is that wiping data is enough.
data is separated from the rom itself, yet it causes the entire device not to boot anymore.

[Q] How long did it take for CM 11 20140116-UNOFFICIAL (EOL) of jfbs to install?

Hi guys. It is my first time to run cyanogenmod on my phone. I have the Samsung Galaxy Exhibit 2 4G and I tried to install the CM 11 of jfbs. I did all the backups and I wiped the data and cache and installed the ROM and Gapps. But I rebooted my device and the Cyanogenmod logo appeared with the spinning arrow and it didn't want to stop spinning (or loading if you want). My phone was stuck on logo and the spinning arrow. I forced the phone to turn off and when I rebooted it I worked but after a little time it went back to the logo and the spinning arrow. I re-installed the ROM and Gapps but like before, the logo and the spinning arrow still there until now and it won't even stop and lead me to the lock screen. PLEASE can somebody tell me if it won't work or what is wrong whit it or if it is matter of time, how long should i wait? PLEASE I need to know what is going on and what to do. :crying:
theking1st said:
Hi guys. It is my first time to run cyanogenmod on my phone. I have the Samsung Galaxy Exhibit 2 4G and I tried to install the CM 11 of jfbs. I did all the backups and I wiped the data and cache and installed the ROM and Gapps. But I rebooted my device and the Cyanogenmod logo appeared with the spinning arrow and it didn't want to stop spinning (or loading if you want). My phone was stuck on logo and the spinning arrow. I forced the phone to turn off and when I rebooted it I worked but after a little time it went back to the logo and the spinning arrow. I re-installed the ROM and Gapps but like before, the logo and the spinning arrow still there until now and it won't even stop and lead me to the lock screen. PLEASE can somebody tell me if it won't work or what is wrong whit it or if it is matter of time, how long should i wait? PLEASE I need to know what is going on and what to do. :crying:
Click to expand...
Click to collapse
(as a dev for this phone)
If you could PM me with more details that would be helpful. When i hear that it continues after a reboot(not the first person to have said that) i think its that you are not waiting enough time. That may or may not be the case. I would give it a good 5 min. I have never timed mine but it does seem to me that prior android versions took about 2-3min maybe and for w.e. reason android 4.4(cm-11.0) takes a few more min. Anything over >=10min though id say is too much. In these cases the only things that can really help are logs. Logs are the only way you can show a dev what you are experiencing.
(as a xda member)
Also i would use the device thread not the general android thread, read through the rom thread of the rom you are tryng to install, and a last and final note, I would recommend that anyone that is new to install older more mature roms first. These roms will yield the best experience in most cases. Then once you are familiar you can experiment with other roms/mods etc etc.
cars1189 said:
(as a dev for this phone)
If you could PM me with more details that would be helpful. When i hear that it continues after a reboot(not the first person to have said that) i think its that you are not waiting enough time. That may or may not be the case. I would give it a good 5 min. I have never timed mine but it does seem to me that prior android versions took about 2-3min maybe and for w.e. reason android 4.4(cm-11.0) takes a few more min. Anything over >=10min though id say is too much. In these cases the only things that can really help are logs. Logs are the only way you can show a dev what you are experiencing.
(as a xda member)
Also i would use the device thread not the general android thread, read through the rom thread of the rom you are tryng to install, and a last and final note, I would recommend that anyone that is new to install older more mature roms first. These roms will yield the best experience in most cases. Then once you are familiar you can experiment with other roms/mods etc etc.
Click to expand...
Click to collapse
Thank you @cars1189 for your answer. I used the device thread to do it but the problem is, I let it spinning for more than 5 hours. I have flashed many roms in my phone since i had it (more than 10 times or more) and i know that it does not take more than 10 mins max to install. But don't worry after that i went back and restored my previous CM 9 rom and right now i'm on the CM 11 build of 1-29-14 of your CM mass thread. It works fine, not at 100% but it doesn't drain my battery like your CM 10.2 build of 1-11-14 and it is almost stable. I will try tonight to use your ADC kernel with the jfbs CM 11 rom that first didn't work for me because I saw in your thread that this kernel may help it to load and install without the spinning issue. So i will give it a shoot. But anyways thanks for your answer and it means a lot to me really. :good:
GOOD
@cars1189 , I'm actually running the 6-18-14 build of CM11 and as far as it goes, i'm not encountering any major issue at the moment. The theme engine is working fine for me and battery life is great for my usage. I use this build as a daily driver, and it does a great job. Calls, texts, data, wifi, Bluetooth and GPS are all working. I had issues before with the amount of RAM available, but now that it has 375MB of RAM, it is more snappy. Just :good: Thank you for your work on our to make our phone still valuable today!! THANKS MAN!!!!!!

[Q] XT910 touchscreen suddenly stops working! please read!

So, i have an used xt910 with Carbonrom KK 4.4.4, Safestrap v3.72 and Stock ROM. I have been having problems with the network since two weeks ago. Sometimes it just runs out of network out of the blue (Vodafone), even though my roommate still gets full signal. Sometimes by just restarting it the network would come back. Last saturday i rebooted it but then it would not turn on anymore, entering in a very annoying boot loop. And when i could boot into Recovery, a little surprise: The touchscreen would not work. First i thought it might be a hardware problem, tried dissasembling it and everything but nothing worked. But then out of the blue, around three hours later it started working properly again. Ok so i thought it could be some kind of bug with the rom so i installed CM 11 (the nightly version from the 22.11.). But it was running slowly, compared to Carbonrom. And i did not want to go back to carbon so i installed the Dirty Unicorns rom that i found here. And then today when i started it i saw that i was out of network signal again! So i tried rebooting it but it started with that stupid boot loop. Right now it is working okay, but it is really annoying to always go through this. So i do not think it was a problem with carbonrom (i am newbie with it). Has anyone ever encountered this problem bzw how did you manage to fix it?
Thanks a lot in advance!
(sorry for my english xD)
valderi.segundo said:
So, i have an used xt910 with Carbonrom KK 4.4.4, Safestrap v3.72 and Stock ROM. I have been having problems with the network since two weeks ago. Sometimes it just runs out of network out of the blue (Vodafone), even though my roommate still gets full signal. Sometimes by just restarting it the network would come back. Last saturday i rebooted it but then it would not turn on anymore, entering in a very annoying boot loop. And when i could boot into Recovery, a little surprise: The touchscreen would not work. First i thought it might be a hardware problem, tried dissasembling it and everything but nothing worked. But then out of the blue, around three hours later it started working properly again. Ok so i thought it could be some kind of bug with the rom so i installed CM 11 (the nightly version from the 22.11.). But it was running slowly, compared to Carbonrom. And i did not want to go back to carbon so i installed the Dirty Unicorns rom that i found here. And then today when i started it i saw that i was out of network signal again! So i tried rebooting it but it started with that stupid boot loop. Right now it is working okay, but it is really annoying to always go through this. So i do not think it was a problem with carbonrom (i am newbie with it). Has anyone ever encountered this problem bzw how did you manage to fix it?
Thanks a lot in advance!
(sorry for my english xD)
Click to expand...
Click to collapse
About the signal loss,just delete CellBroadcastReceiver.apk from system/app.
Sent from my Razr XT910
thanks!! I was looking into some other posts and i did it

850f alpha misbehaving after update? Help me figure out what's wrong

Greetings,
I have been tinkering with my GF's 850f with the hopes that she will forget about those damn expensive Iphones and embrace the Android way... but so far the Alpha has been acting up. I will explain the issue:
Sometimes, seemingly at random, the phone will get stuck and get really slow. I think I managed to isolate the issue because it seems to happen after using an app that uses the microphone (Duolingo, Whatsapp). After she uses the microphone, the phone will remain stuck. You can get out of the app and close it, but it won't open again and the phone gets slow. Everything goes back to normal after I reboot the phone, but it invariably happens at least once a day. It doesn't happen everytime she uses microphone.
Things I've tried:
Upgraded to official Lollipop using the France image (Clean flash)
Installed custom recovery (First 2.8.0 and then 2.8.6)
Flashed Ozcan ROM (Clean flash again)
It didn't happen on KitKat, it actually began after flashing the Lollipop upgrade, but I'm iffy about downgrading from Lollipop. Anyone knows a way to debug, single out or fix something like this?
Thanks in advance!

Categories

Resources