Any one have the issues launching the camera and the app goes straight back to the start screen. soft reset hard reset same issue.
Does this happen when you launch it only with the start screen, only the side button or either?
Related
It says only ipl 2.25.0001 and spl 2.25.0001
I try a hard reset, but when it asks me to confirm by pressing SEND, I press SEND and nothing happens.. press any key and nothing happens, just sits there saying press SEND to confirm...
I tried flashing Cingular/AT&T's rom on to it, it was successful on the screen, but after rebooting, just went back into the 3 color screen...
Does anyone have any suggestions?
Additional info
I just wanted to add, I have searched threads here on xda-dev and other sites, and have found similar issues - normally the other issues have been resolved in one way or another involving a hard reset, which my phone will not complete. When it asks me to press send, the phone freezes at that point and does not accept any key entries (except reset). I would really appreciate any input. I also have a theory-that I may attempt this evening-If you hold the camera button down and reset, it brings up the boot loader screen (if my information is correct)... could my problem be caused by a faulty camera button? Maybe internally the button is remaining closed, which could prevent it from doing anything on a reset outside of the boot screen? Any engineers around that may know this? I am going to attempt (hopefully with low heat) to remove the button this evening... possibly even repair or replace it if the phone works with the button removed...(these thoughts are based on my phone being dropped in the sand at the beach...maybe a grain of sand worked it's way into the camera's button housing and is holding the contact closed)
problem's almost fixed
well thanks for no advice... i desoldered and removed the camera button (button 3). powered it on and the phone works. I reprogrammed the camera to button 5. (i also loaded a new WM6 rom and some other stuff) The last time I opened up the phone, I broke the itsy bitsy super micro tiny lock on the keyboard ribbon cable socket... so now my slide out keyboard doesn't work. I installed a full screen keyboard and set it to the messaging button (button 1) - the messaging button still brings up messaging with just a touch, but a long hold brings up a full screen touch keyboard that works fantastically!!! I am going to dismantle the very tiny micro switch and repair it, then resolder it back on the mainboard to make my camera work like it should again...and find a way to get the keyboard ribbon cable to lock into the socket...then my phone will be as good as new!
umm... thanks???
well congratulations on getting it working again.
tiny switch
I have taken the tiny little switch apart without breaking anything... one tiny grain of sand stuck under the button pressing on the switch plate... now i have to find a way to put the little switch back together... then attempt to solder it back onto the board without over heating nearby components. I have been playing around with Byka's cube... took a bit of tweaking to get it to work well.... not sure if I want to keep it or not... I have been trying to find htc cube, but no luck outside of a rom... which I may consider...but I just spent the past week reinstalling all of the software I use... Would like to just design my own windows for my phone if I had the time... Been working on an ion motor for an electric car...
I would like to thank everyone here at xda-dev. for all the information. Could not have learned so much, so quickly, if it weren't for this site.
oh... and I am using an 8125 (G4) with Faria Crossbow
Have the same problem...
Hi!
I have the same problem (but I don't have much tech know how).
It all started when phone got wet (inc. in battery compartment).
My phone would not soft reset beyond the Bootloader, unless I leave the battery out for a few hours. Then once it loads up, after a short amount of usage 2 things happen: 1) every time I would turn it on (or get a call) it starts in Camera (you didn't report it but you must have had the same experience). 2) the buttons don't work properly.
It finally dawned on me the camera button might be stuck, I set the button to "none", and no more more automatic camera. I still need to free the button altogether as still causing button freezeup and also allow soft resets.
I don't know much about soldering.
Any ideas?
Thanks
have had my phone for a few months now, and just recently it started being really laggy, i pull the battery out for a bit and stick it back in, same thing, it goes to the main home screen and just gets stuck there sometimes, or wont respond at all. Sometimes the button lights show up, but not the screen. Anything I can do? Haven't done anything to it besides cookies and a theme
Clean your machine.
Most radical, but most effective way is a Hard Reset (factory reset)
Remember to backup your agenda, contacts and other stuff before you try this.
I used my phone this morning and it was fine. A few hours later I went to use it and it would not turn on. It is fully charged. I am running go launcher. I usually don't get asked which launcher I want to open it with when I wake my phone. But that screen flashed very quickly but I could not choose as the screen went blank very quickly. The screen was blank but the back button and the home button were lit up. I hit the power button so many times but nothing happens except the the 2 buttons lighting up. I went into recovery try to boot from there but nothing hapeens. It just goes to the HTC screen and hangs there. Its been on that screen for 10-15 and then I go back into recovery and still nothing. I tried to do a factory reset. It went to a screen with a picture of the phone and 2 green arrows going in a circle and a green down arrow inside the circle.
I have no idea what is going on. I have not done anything new to the phone. It is stock and I got Kit kat on it a few weeks back. Everything has been fine up until this morning. I understand the go launcher could cause a problem opening up the phone. But I don't understand why I cant do a factory reset from recovery. Any and all help is appreciated. Thanks
I also noticed that in the bootloader the very first line says 'LOCKED" is it supposed to say that?
Today I got my phone in. I was on the first set up page and it wouldn't respond to any of my touches. The buttons would glow like I was touching them but it wouldn't type or input. I soft reset it. It worked when I used assist touch. I hard reset it, wiped cache and factory reset. It fixed and I installed all my apps and when I plugged it into the charger it stopped working again. I can open the camera by double pressing the home button to unlock my phone but i can't open anything. It will glow like I'm pressing it but it won't open. I can pull down my notifications bar but none of my toggles or setting icon will work, again, they will glow just not open. I came back to my room and randomly it was working again, after 5 mins it stopped again.
Thank you for your attention.
ATT 64 GB
Galaxy S6 (not edge)
I don't know if this is the cause/solution to your problem, but I know S Voice can cause lag issues. By default, double pressing the home button (when device is unlocked) opens the S Voice. Frankly, it's redundant and pointless, as it's a mediocre attempt at Google Now. Open it, then go into the settings, and disable it. It causes lag because it's waiting to see if you're going to press it again or not.
But if that doesn't fix it, and it's doing that stuff before you've even set it up, I'd tend to think you've got a faulty unit. The capacitive buttons are part of the screen/digitizer, so maybe you've got a bum one.
I met the weirdest thing I ever have. I have a galaxy camera gc100, It works very well without any problems. Since I decide to lend it to my friend, I did a factory reset. After the factory reset, everything looks fine and the initial setup screen "Select language" appears. BUT, I can not touch anything on the screen. It seems that the touch is simply unresponsive at all until the screen turns off by timeout. And then I tried (1) hard reboot, (2) go to Maintenance boot mode by pressing power and zoom out and did delete cache and factory reset again. (3) flash stock rom. (4) take out of the battery and then holding pressing the power button for more than 1 minute and then insert the battery and boot. (did three times). But none of them works. This is just weird and I can not find anyone on the Internet having the same issue as me. Other people met unresponsive touch screen and then did hard reset to fix the issue. Mine is entirely opposite. I don't have any problems, but factory/hard reset causing the touch screen is unresponsive at initial setup screen. Do anyone have any clue how I can workaround this issue? Thanks a lot. (Btw the system is still functioning because I can adjust volume and take screenshots by using the physical buttons, and the screen can rotate too).
The touch screen might have been disconnected from the motherboard (if it was poorly treated)
Or water got inside and caused a short circuit.
The touch screen could have failed from age or other cause.
If what you said you did is true, then may have to get it replaced
Also android 4 supports mouse (as a last resort) using an OTG cable.