Any idea where to find a back pad for the Samsung Note 3 that integrates both the Wireless Recharging coil and NFC Antenna?
Something from an aftermarket source that doesn't cost $50?
Related
I know this has been brought up before to the extent that the LGOG does not officially support wireless charging but has anyone been "bold" enough to disassemble their LGOG to see if charging pads are present in order to fit the phone with a Qi charging receiver? I have not been able to find a tear-down for the phone yet. The teard-own for the LG Nexus shows a thin receiver with a 4 pin pad and I was curious if this may also be present in the LGOG. Any thoughts?
I just ordered the nokia DT900 will this charging plate support our G3 devices I got this for 10$ so I plalced the order, I need to Order the wireless charging chip so please suggest if this charger will support our G3 Device if i get the wireless charger sticker from amazon and replace it NFC on the back plate.
Hello guys,
I bought yesterday the Samsung Wireless Fast Charging Pad from Samsung official store in Amsterdam.
The problem with that pad that only on certain position the galaxy S7 starts to charge.
Is it common problem?
The charging coil is in the center of the phone so you have to place the center of it on the pad, in which positions is it not charging?
why did you get the one from samsung? There's others on amazon with 3 coils for charging so its not as stubborn when placing it to charge. I love mine. look for fast wireless charging 3 coil charging pad.
A French startup, called Energysquare, has created a new type of technology that can wireless charge almost any device. This includes devices that don't have wireless charging capabilities built-in, such as Apple's iPhone and iPad.
Energysquare consists of a charging pad and a sticker that is placed on the back of a device. The sticker sports two electrodes along with a Micro-USB, USB-C or Lightning connector that is plugged into the device's charging port.
Dont you already can buy these thing called QI charging pads? I know you have cases and stickers and kind work the same.
Has anybody found a good Qi wireless charging receiver for the Tab S3?
The S3 is a fairly large tablet with a USB-C connector which is (unfortunately) located slightly off center toward the right (top) edge where the power/volume buttons are placed. In order to use a Qi charging stand, it would be best if a Qi receiver pad could be placed on the back, slightly toward the left edge (near the pogo pin connector), so that the tablet could sit sideways on the charging stand with the power/volume buttons facing up.
This means we need a Qi receiver with a long USB-C connector. A typical Qi pad is about 8 cm long so we'd need one with about 7 cm of cable just to get the coil in the center of the Tab S3 and even then it might be too close to the top edge to align with a charging stand while the tablet is sideways. Most of the Qi receivers I've found only have about 2 cm of cable at most.
My Tab will sit vertically on my charging stands but it's not very stable and again, with the USB-C port off center, the coils might not align.
Alternatively, it might be possible to hack a standard Qi receiver to connect to the pogo pin connector on the side of the Tab S3.
[I've tried all sorts of tricks to resize this image down to something reasonable. None of them worked. Sorry.]
I have the same interest to setup QI wireless charging on my Galaxy Tab S4 tablet.
Have you made progress since that initial post ?
I have not found any useful relevant information to resolve this challenge!
Thanks.