I was testing the Sky Note 4.3 leak port from AT&T and everything was working fine. I had data, signal, mms, sms, wifi (after the fix) and all. But I got a bit greedy and tried to flash the Air Commands feature. What I didn't realize ( I was watching a show at the same time) is that I flashed the MJ5 baseband from the International Note 2, GT-N7100. Ever since then, nothing is working "properly." I can flash ROMs normally, but if I flash a ROM that is NOT 4.3, it says my internal storage is 0/0 bytes.
I've also lost my signal/data/imei/etc and it always shows baseband unknown (I have a efs backup folder, but it doesn't seem to read it properly). I can SOMETIMES get signal back when I reflash Jedi X19, but the occasions that it works, data still doesn't. If I reflash Sky Note 4.3, internal storage goes back to normal, but still don't have imei and what not and it says baseband unknown. I've already tried reflashing modems, but they never read.
Now I've tried restoring to stock using the pit file and stock rom, but it never works. the pit file doesn't repartition. If I flash the root66 stock firmware, it works, but goes into a boot loop. My startup logo also shows "Samsung Galaxy Note II GT-N7100." It thinks it's the international version??? I even decided to give it a go and tried flashing the Pit file for the international version and it WORKS. It repartitions it easily. However even with that, I try flashing roms and they work, but the internal storage problem and baseband problem still remain.
I'm thinking that if I wait until the official update comes out, I could get the official 4.3 baseband and firmware and maybe it'll work? I've tried the param_sboot_tz file and it gets stuck on sboot. If I just use the param_tz file, it gets stuck on tz.img. I don't know what else to try to get my phone back to normal. If anyone could help or somehow give a suggestion that I haven't tried, I would truly be grateful. Anyway, thanks for reading.
(Please no bashing, I know it was a mistake.)
you might like to read post at xda for this
thanks,
chat/email : [email protected]
hope the concern is solved
thanks,
chat/email : [email protected]
Related
I upgraded to att ics update 4.0.4. Installed CWM, rooted and tried to install ics blaze 4g, tmo_kid, tmo_vlk1, and back to the stock i717UCLF6 baseband. It showed up as unknown baseband even returning to stock. I did a factory recovery with Kies and it works now, but I can only get edge still. Any suggestions or something I missed? Thanks
Flash the blaze modem and reboot until you see the correct baseband. Sometimes the flash doesn't stick.
Don't forget to check packet data and enter your APN settings.
rangercaptain said:
Flash the blaze modem and reboot until you see the correct baseband. Sometimes the flash doesn't stick.
Don't forget to check packet data and enter your APN settings.
Click to expand...
Click to collapse
I tried what you mentioned about rebooting until you see it come up. I tried over 8 reboots and no luck. I tried flashing the i717UCLF6 baseband back, still would not come up. Under settings, about phone, baseband states unknown. Then goto to status and the imei is unknow and the serial number of the phone doesn't match. Any ideas?
Maybe reinstall the UCLF6 base from scratch at the samsung site using Kies.
rangercaptain said:
Maybe reinstall the UCLF6 base from scratch at the samsung site using Kies.
Click to expand...
Click to collapse
Are you saying to do a complete restore? If so, is there no fix at the moment for the modem running ICS stock from Att? I'm currently on Tmo
Somehow your system got borked. I'm suggesting return it to stock to get your SN and IEMI back, then try again with the Blaze modem.
RESOLVED Upgraded to Att ics, stuck on egde now
rangercaptain said:
Somehow your system got borked. I'm suggesting return it to stock to get your SN and IEMI back, then try again with the Blaze modem.
Click to expand...
Click to collapse
I have an update. I finally got the Blaze ICS modem to work. Its on a SGH-I717 already upgraded to ICS by Kies. First thing I did was restore the phone with ICS fresh using KIES. The only reason was that I needed to make sure the modem was working. Then powered down and booted into CWM. Created a backup so I could restore later. Restarted phone like normal. Copied the ICS Blaze modem firmware zip. onto my sd card. Powerded down. Restarted in CWM. Installed from SD card the Blaze ICS modem zip. Restared phone normally. The modem would not come up. Restared the phone and booted into CWM again. I did a restore from my backup earlier. Restarted the phone and now it works. So let me know if this helps any of you...
Hi,
In my ignorance I loaded on the i9100 rom from Samfirmware XXLSJ, and it loaded ok. However the modem doesn't work. The symptoms are: connects ok to 3g network, however will not txt/make phone calls, the phone reports "not registered on network"
So, I tried flashing the XXLSJ JB again, this time with another modem, one that is supposed to be for the T variant, I'm in New Zealand by the way and use Telecom. Same deal.
No problem i thought, ill simply go back to an earlier official Telecom version on ICS. However, this now hangs on boot up on the S logo.I went back to an earlier one, that one also hangs. I went back to Gingerbread, that hangs on start up also on the S logo too.
So some questions:
Can i run jellybean and use some new modem?
If not, can i put it back to original 4.0.3 official firmware without it hanging?
I'm using Odin 3.07 to do the flashing.
Thanks in advance, i'll just be happy with a working phone at this stage :silly:
laserfist3000 said:
Hi,
In my ignorance I loaded on the i9100 rom from Samfirmware XXLSJ, and it loaded ok. However the modem doesn't work. The symptoms are: connects ok to 3g network, however will not txt/make phone calls, the phone reports "not registered on network"
So, I tried flashing the XXLSJ JB again, this time with another modem, one that is supposed to be for the T variant, I'm in New Zealand by the way and use Telecom. Same deal.
No problem i thought, ill simply go back to an earlier official Telecom version on ICS. However, this now hangs on boot up on the S logo.I went back to an earlier one, that one also hangs. I went back to Gingerbread, that hangs on start up also on the S logo too.
So some questions:
Can i run jellybean and use some new modem?
If not, can i put it back to original 4.0.3 official firmware without it hanging?
I'm using Odin 3.07 to do the flashing.
Thanks in advance, i'll just be happy with a working phone at this stage :silly:
Click to expand...
Click to collapse
Sorted, ran the old firmware back on from Telecom, went into recovery mode and did a factory reset. all seems better.
My Galaxy S3 GT-I9305 LTE was running Liquid Smooth 2.37. Recently I lost notification and phone ring sounds and now I have lost baseband and I have no cell signal.
In the phone's 'about' section the baseband field is empty. Android version showing is 4.3.
I'm not quite sure what I did wrong, first to try and get back the sounds and then baseband, I have been playing around with various custom and stock ROMS and kernals to get full functionality back.
I've read tons of help posts but nothing works.
Here's a few of the things I've tried with results in brackets, used CWM recovery to restore working backup (failed 'unsupported file' message),
reflashed kernals (neither Boeffla nor yank555 have worked, wipe/data restore in CWM (it still takes me back to 4.3 with no baseband).
I thought I'd re-flash back to the phone's original stock ROM using Kies, but the weird thing is Kies doesn't restore, it upgrades to the latest 4.3 ROM which fails to restore baseband.
I wanted to send the phone back to the 4.1.2 it came with or was it an earlier ROM? I can't remember as I didn't note it down, I bought the phone second hand, it arrived loaded with a stock ROM for Australia's Optus network. I promptly rooted and flashed the phone to Liquid Smooth and the phone ran fine for months on the 2 Degrees Network in New Zealand.
Anyway, I must have tried reflashing a dozen stock roms I've found online using Odin. Some of them partially work, I get sound back, (it seems only the 4.3 ones work, with the german I9305XXUEMKC reliably loading - it even gives me a NZ english install option) but don't restore the baseband
. All the ones I've found for Optus are rejected, I get the 'unsupported device' or status 7 error in Odin.
So I decided to flash one that works, install cwm, root the phone and try installing different baseband kernals to fix the (probably corrupt) efs.
But I'm going round in circles trying to root the phone. Using CWM, supersu shows as successfully installed, but when I boot into the OS root checker shows my phone is not rooted. Knox seems to obstruct every attempt I make to disable it as well. I keep getting these 'knox stopped etc...from working messages'.
I'm sorry if my description is a bit confusing, I'm happy to clarify anything.
I'm at my wits end. I want to try everything before I have to ship the phone off to a repairer who may charge me hundreds of dollars to fix the phone.
This is I9300 not I9305 Q&A
Use the report button and ask a mod to move to the correct forum .
I can offer no help as i fail to understand the post .
As said before you are in wrong place and are not giving us a clear question to answer. If its a root problem there are fixes for it. Status 7 error is discussed in many threads. Flashing MG4 modem fixes efs problem. Downgrading causes problem. Learn to search before making a thread.
Ok, so I used to have cm11 installed, but it got sort of buggy in the long run.
I decided to try Foxhound rom, just for kicks... When it was finished installing, I got the default IMEI and the phone wouldnt connect to the network. I found a way to fix this (without backing up my efs folder), by installing an old rom. After that, I installed ef extreme rom (the one with the s5 ui).. It was supposed to be the most stable and smooth rom... But the camera and hotspot wouldnt work -_- ... I never understood why.
Anyhow, the problem is, now that Im trying to get off that crappy touchwiz rom, I NEVER get service anymore. My IMEI will always go blank.. Now the baseband goes "unkown" too (which hadnt happened before)... For ****s sake, I was trying to go back to my old cm11, and still, crazy IMEI... However, if i install the old rom all over again and the region modem: boom, mobile network works again... I dont understand why it fails to work after i have gotten it fixed over and over again...
I even made a backup of my efs folder when the mobile network is working (on the old rom.. Revolution HD)... When i restore it on newer roms, the IMEI and everything comes back.. however, it wont let me access the network (radio off?)
WTF can i do? Im desperate for help, please!!
@niko: standard is to get your actual firmware from sammobile.com & flash it with Odin … to get a stable base.
Your device serial number is probably corrupted. You can use service box to fully repair this issue. Or you can flash Ariza's patched modem. It will work but your efs folder will be permanently screwed and you will be forced to flash it every time you flash a new firmware.
____________________________________________
P3110 / I9300 / I9100 / NEXUS 5 / iPAD2
hello,
I have a problem with my s6edge. From the moment i got it, the phone was lagging, halting, restarting, loosing signal randomly. I thought an update would fix it so I updated OTA to mm6.0.1. but this didn't worked as expected. I remeber that when it was installing the new android, the progress bar stopped somewhere at 1/3 and the phone rebooted and then the status "erasing..." appeard. After it finished the update, I did a factory reset and then, after restart, i found that there was no network. I cheked the baseband: unknown imei: null. I think the EFS partition is corrupted. Since then I tried the following: flashing with odin [ap] different stock roms from 5.11 to 6.01 from different carriers in my region. No luck. I even tried to flash [cp] only modem.bin. Every time I flash a new rom, and I go to recovery, a broken android appears. If i restart and go again to recovery, it goes to recovery as it should go without the error.
I also mention that the phone was not rooted. I running now 5.1.1 G925FXXU3COI9_G925FOXX3COJ1.
What can I do to get back both imei and baseband? Any help will be greatly appreciated. 10x.
It's still in warranty and you've not messed it up. Get them to solve. Sounds like main board is dodgy with the signal issues
it would've been so easly.
unfortunatly, this is not an option. the legal owner is a friend witch is not in the country right now.
Now it runs latest 6.01 very smoothly (the lagging and halting are gone, with no errors at recovery) after I flashed the PIT file along with the rom with repartition enabled, but still, Imei is Null and Baseband is Unknown
Any sugggestions? 10x.
I can't belive I have to go to samservice with this problem witch i think it has a very easy solution....
Can you teach me how to flash along with pit file?? Please thanks in advance
any good news know? I would like to know that man
ferdeenandxda said:
any good news know? I would like to know that man
Click to expand...
Click to collapse
this worked for me
https://www.youtube.com/watch?v=TzGJDHmKx4o