I have been looking out for custom rom or atleast upgrade to Android 4.1 or 4.2 for the Karbonn Smart Tab 7 (ST7).
Has anyone been able to upgrade? Because lots of issues with stock ROM. I keep getting message that no SD Card found even though the SD card is present and detected by the device.
Hey guys
So this happened ,
Installed Mokee open source ROM ROM which is 4.4.4
Now i wanted to go back to Viper Rom which is on 4.2.x
So i went to boot flashed boot , flashed recovery , tried to install rom and well it did not install the rom kept saying fail
Anyways i had a OLD viper 1.1.x so i installed that so i can just get things started but now it doesnt show any files like SD card doesnt exist on the phone or on the laptop
I need some serious help , im freaking out.
Thank's alot
You need an older recovery
Sent from my Nexus 5 using Tapatalk
I am experience very bad hanging with moto e 1st gen . I guess this is encountered recently when my cell got updated to 5.1 from 5.0 lollipop version . with 5.0 it was working awesome!
Googled things and I cleared wipe cache partition , tried to degrade to KitKat but dono degradation dint happen though shown as successful !
Before going to any steps ,I just wanna check out in this forum for solution first !
Plz help me asap so that I can use this awesome phone as I was using it back
Thanks a lot
Try clean 5.1. falshing via twrp.
Flash a stable custom ROM or stock kitkat ROM
good moring ,
I ve samsung galaxy s3 neo i9300 android 4.4.4 , and when i try to flash any new custom rom of cm13 (marshmallow) i recieve an error message saying
"error executing updater binary in zip" , " error flashing zip "
however i could install a gapps file of version "open_gapps-arm-6.0-full-20160625" which i download from this website and it was installed successfully .
plzz help
thanks
Hey there,
That maybe the issue with your cm13's flashable zip file.
What is the version of cm13 that you have downloaded? (I mean the date of it, like this: cm-13.0-20160714-NIGHTLY-i9300.zip)
I got a gs3 too, and I flashed the cm13 nightly build that is released in 10/7, and it worked for me.
If you have any issue, reply this later!
Regards,
MrTumi689
Hey there ,
Thanks alot for your concern tumi
Ive used too many versions of cm 13 like 20160717 -NIGHTLY , 20160704 -NIGHTLY , 20160625 , 20160621 , all of those didnt work :/ , and i updated my OS b4 from 4.3 to
4.4.4 official .
I dont know what the cause of this prob .
Thanks
Actually, I don't think that the i9300 cm13 is compatible with your gs3 neo, which is i9300i
Don't think that you can install cm13 right now. What you can do:
-Maybe wait for cm14 to release as Android N is almost complete. Takes you some patience as it requires time.
-The latest CM for your phone that I found is CM12.1. Sorry.
Link to the CM12.1 for you: http://www.cyanogenmods.org/galaxy-s3-neo-cm12-1-lollipop-rom-gt-i9300i-i9301i-and-i9301q/
hey
Hey Tumi ,
Thanks alot for you effort , i think that gs3 neo is the same model as gs i9300GT because i see both model names on my phone .
Anyway ill try this rom , i think its very similar to cm 13 marshmallow .
Regards
Hi guys I'm new in this forum, actually i need a help,
So i was bored with stock android of my xolo era 1x pro so wanted to flash a custom rom in that, I didn't able to find any rom for my device but found some rom for xolo era 4g/X it has almost identical specs of my phone so i backed up my stock rom flashed miui 8 rom which was there for xolo era x it booted fine but i faced many issues
1.audio was not working
2.wifi was not working
3.bluetooth was not working (
4.camera was not working
5.volume buttons were not working
6.most importantly it was stuck into safe mode i tried all methods but i could not able to quit safe mode
Now my question is is there is anyway to fix those and port it properly on my device,i have seen many different tutorial for porting rom on spreadrum phones but im bit of confused i need some help
Specs of my device
Soc sc9832a 1.3ghz(8830 chipset)
Android version 6.0
Kernal version 3.10.65
That miui 8 rom link here