hey guys please help me
I have sd wi-fi card
now I want to connect to wireles internet connection and
I already connect to the wireles internet but I can't open any homepage when I try to open a website there is pop up it say
" page cannot be found "
please helppp me
I don't know why
is there anyone know what is my problem ???
thanks if you reply me
Is this your own wireless network?
If it is, can you connect other wireless devices to it?
Most common issue is the device is not getting an IP, I have seen Netgear, Belkin, and D-Link routers/access points fail to issue an IP to WindowsCE devices for some reason, usually if you soft reset the router/access point, it will work for you.
If it's not your network, perhaps there is a proxy server or other gateway on the network, and you need to enter these settings into your device.
or if it's set to get dns by dhcp and the gateway dont give any dns
or if it's hardcoded to always use the isp gprs dns on all connections
hi,
I've linksys wi-fi router model WRT54GH in my home & it has a good amount of signal strength to cover entire area.
My recently bought galaxy S2 is able to identify linksys wi-fi access point & connects too with the IP assigned to it, also at wi-fi settings connected being displayed.
Now when I try to access Internet (any url google/FB), it doesn't connect at all.
I tried almost everything about router configuration, restart etc. but with no success
can someone plz help on this ?
shantanu_d said:
hi,
I've linksys wi-fi router model WRT54GH in my home & it has a good amount of signal strength to cover entire area.
My recently bought galaxy S2 is able to identify linksys wi-fi access point & connects too with the IP assigned to it, also at wi-fi settings connected being displayed.
Now when I try to access Internet (any url google/FB), it doesn't connect at all.
I tried almost everything about router configuration, restart etc. but with no success
can someone plz help on this ?
Click to expand...
Click to collapse
In my case the problem was with frozen "WiFi sharing" in combination with juicy defenders "Location" fearure. It seems such combination is dangerous. Solutin (in my case):
1. defroze
2. remove all wifi networks
3. reboot (for "clean" frozing)
4. make WiFi sharing frozen
5. reboot again just for fun
Try to check your router's MAC address restrictions. In my router, as security, I have to add MAC addresses of each device to share internet. They take IP's, connects etc. but does not have accesses to internet
as above, check that there is no MAC filtering set up.
one other thing it may be is the security settings, if you have a WEP Key to access the router it may need the Hex conversion of your key depending on what level of security you have (64bit or 128bit for example)
shantanu_d said:
hi,
I've linksys wi-fi router model WRT54GH in my home & it has a good amount of signal strength to cover entire area.
My recently bought galaxy S2 is able to identify linksys wi-fi access point & connects too with the IP assigned to it, also at wi-fi settings connected being displayed.
Now when I try to access Internet (any url google/FB), it doesn't connect at all.
I tried almost everything about router configuration, restart etc. but with no success
can someone plz help on this ?
Click to expand...
Click to collapse
Try setting up a static IP address for your phone, I presume your network is a 192.168.1.0, go into router settings and LAN setup, give your phone the address in a static DHCP assignment of 192.168.1.5, or any other address in the same subnet your in. Some SGSII's have problems with dynamic DHCP for some reason, some NS had the same problem too,
Sent from my Sammy Galactic S2 Beastly Device
I have a similar problem and I fix mine temporarily by turning my wifi off, then in wifi settings > advanced, I change wifi sleep policy from 'never' to 'only when the screen is off'. However I have to do this every time I want to use wifi so it can become quite annoying sometimes.
So I can get through however only for a short period of time as it seems as long my Galaxy S2 keeps turning off my wifi even though it's on :/
I had exactly the same issue on Linksys E4200 with my laptop, could connect to network, even to router's attached storage, but not to internet. Restart helped
On SGS2, I couldn't connect to the router at all at first, but fixed this by switching from WPA2/WPA mixed mode access protocol to WPA2 private. But I guess this is not exactly your issue.
SiSL said:
Try to check your router's MAC address restrictions. In my router, as security, I have to add MAC addresses of each device to share internet. They take IP's, connects etc. but does not have accesses to internet
Click to expand...
Click to collapse
Thanks for the suggestion but MAC restriction is already disabled at router
Robsso said:
I had exactly the same issue on Linksys E4200 with my laptop, could connect to network, even to router's attached storage, but not to internet. Restart helped
On SGS2, I couldn't connect to the router at all at first, but fixed this by switching from WPA2/WPA mixed mode access protocol to WPA2 private. But I guess this is not exactly your issue.
Click to expand...
Click to collapse
Yes, you are right this is not an issue for me.
In fact my SG2 being assigned with an IP address from 192.168.1.xx subnet.
Also at a same time my laptop connected with an IP from same subnet able to ping SG2.
OccasionalDroid said:
Try setting up a static IP address for your phone, I presume your network is a 192.168.1.0, go into router settings and LAN setup, give your phone the address in a static DHCP assignment of 192.168.1.5, or any other address in the same subnet your in. Some SGSII's have problems with dynamic DHCP for some reason, some NS had the same problem too,
Sent from my Sammy Galactic S2 Beastly Device
Click to expand...
Click to collapse
My SG2 being assigned with an IP address from 192.168.1.xx subnet.
So I think IP addressing may not be an issue.
Also another thing I tried was, at a same time my laptop connected with an IP from same subnet able to ping SG2.
So wi-fi router may not be an issue here, whats say ???
Even I am facing the same issue at my office network. I am able to connect to the wireless network but if I try to access any app I cannot browse. This is really frustrating looks like some issue with the modem drivers.
I was able to browse on another wifi created virtually by mobile tethering. This looks like a major bug with the current firmware. Another interesting thing to note is that the Wifi network has a hidden SSID and uses WPA2 auth scheme.
I have seen a Galaxy S able to connect to the same n/w without any issues.
Has anyone figured out a solution to this one ?
Hi, thanks for your reply.
I am yet to figure out a solution for this
Even I am also agree on the probable issue with modem driver.
I've D-link modem.
Are you aware of anything about this modem that can be reconfigured to get this worked ... ?? pl let me know
The wifi router at my office is Cisco Aironet 1200 Series, anyone else facing this issue ?
I'm having the same problem at work connecting my SGS2 with v2.3.3 Official Firmware (customized for Orange service provider) to a Cisco Aironet 1130 AP. I can see that the Galaxy authenticates with the AP correctly and gets IP from the DHCP server, but it cannot send or receive any traffic, although the phone stays connected and authenticated. At home, I use an Atheros based Fonera with DD-WRT without any problem.
As I'm the company's network administrator, I will try to further investigate this problem, but it seems like some kind of incompatibility between the devices or misconfiguration ....
Basuk said:
The wifi router at my office is Cisco Aironet 1200 Series, anyone else facing this issue ?
Click to expand...
Click to collapse
try turn off the wifi, turn off the mobile data and turn on the wifi again
It seems the SGS2 sometimes has problems with DNS.
Try a static IP and use 8.8.8.8 as second DNS server, which is a free Google DNS server.
This fixed MY problems
I rooted my SGS2 and voila wifi worked at my office finally I have been able to find a solution.. love my SGS2 the Beast...
I'm having this same problem..
I think I've tried all the solutions above, but one (Sorry - noob question):
Rooted?
is there a firmware patch or something that I should know about?
Anyone got any other ideas?
ETA:
I can connect to hotspots (DHCP) and at home (Have to set it to static tho)
No internet
AP works - Laptop and i8910 (had to set static and advanced settigs etc). I've rebooted it a few times, set DHCP on and off. DHCP seems to be running on the router
viqles said:
I'm having this same problem..
I think I've tried all the solutions above, but one (Sorry - noob question):
Rooted?
is there a firmware patch or something that I should know about?
Anyone got any other ideas?
Click to expand...
Click to collapse
This is an issue with SGS2 with wifi server using authentication protocol TPIK, if you use AES as encryption then it will work without any issues.
That should be a setting in my AP? I can't see it...
If I get a new non-crappy AP is that likely to solve my problem?
ETA:
Ah - that's a WPA thing? Mine only seems to do WEP - is that right?
Hello everybody.
Since last saturday i'm testing a Galaxy S3.
I want to test if everything works properly before buying it.
I have some problems deling with the WIFI stuff.
I gave him a static IP (192.168.1.15), configured the gateway as the ip of my router (192.168.1.1),
the network class is 255.255.255.0 (network prefix = 24), the DNS points to the IP of the Router (192.168.1.1)
It connects without problems. form the S3 i can ping any device in my network and from other devices i can ping the S3.
I can connect to the configuration site of the router and from the page of connected devices i can see that the S3 is connected
with the correct ip and also the MAC adress is correct.
And for now everything is fine.
Problems raise up when i try to surf internet. The answer is always "Page not found"
If i open the browser and try to navigate to google] the answer is "Page not found". Same for any other site i try to connect with.
I cannot ping external adresses from the S3. Only the ones inside my LAN.
On the same LAN there are 3 laptops, 1 IPhone, 1 TV, NAS NETGEAR , home automation screen, all connected in WIFI.
All of them configured in the same way. (static ip, gateway=ip router, dns = ip router, network class 255.255.255.0),
And they all access internet without any problem.
The network is protected with WPA2/PSKey, encryption AES.
I tried to configure channel with WPA, WEP, without protection, but no changes.
The S3 connects to router but does not connect to internet,
I also tried to make it point to a public DNS 8.8.8.8. No WAY!
Works for other devices.
I tried to reset S3 to factory parameters, same thing i did for the router.
I reconfigured everything from scratch but no result.
I do not have any filtering based on IP or MAC adress on my Router.
I tried with DHCP, with reservation of IP adresses or without reservation. No change.
Other devices can access internet. S3 does not.
I have to say i'm quite desperate.
If you guys have some good ideas to solve or diagnostic the problem i would be grateful.
Cheers,
Fabio
I get that around my office as I walk around, I find that when I change AP in range my internet connection drops. I have to constantly disable/re-enable WiFi.
Even around my house, I have the handset to WiFi always on, yet when I wake up in the morning the internet connection is not working yet there is an IP. I couldn't be bothered to telnet to port 80 etc., but I hear that the Jellybean update will resolve this issue.
Same problem
nickzap said:
Hello everybody.
Since last saturday i'm testing a Galaxy S3.
I want to test if everything works properly before buying it.
I have some problems deling with the WIFI stuff.
I gave him a static IP (192.168.1.15), configured the gateway as the ip of my router (192.168.1.1),
the network class is 255.255.255.0 (network prefix = 24), the DNS points to the IP of the Router (192.168.1.1)
It connects without problems. form the S3 i can ping any device in my network and from other devices i can ping the S3.
I can connect to the configuration site of the router and from the page of connected devices i can see that the S3 is connected
with the correct ip and also the MAC adress is correct.
And for now everything is fine.
Problems raise up when i try to surf internet. The answer is always "Page not found"
If i open the browser and try to navigate to google] the answer is "Page not found". Same for any other site i try to connect with.
I cannot ping external adresses from the S3. Only the ones inside my LAN.
On the same LAN there are 3 laptops, 1 IPhone, 1 TV, NAS NETGEAR , home automation screen, all connected in WIFI.
All of them configured in the same way. (static ip, gateway=ip router, dns = ip router, network class 255.255.255.0),
And they all access internet without any problem.
The network is protected with WPA2/PSKey, encryption AES.
I tried to configure channel with WPA, WEP, without protection, but no changes.
The S3 connects to router but does not connect to internet,
I also tried to make it point to a public DNS 8.8.8.8. No WAY!
Works for other devices.
I tried to reset S3 to factory parameters, same thing i did for the router.
I reconfigured everything from scratch but no result.
I do not have any filtering based on IP or MAC adress on my Router.
I tried with DHCP, with reservation of IP adresses or without reservation. No change.
Other devices can access internet. S3 does not.
I have to say i'm quite desperate.
If you guys have some good ideas to solve or diagnostic the problem i would be grateful.
Cheers,
Fabio
Click to expand...
Click to collapse
I'm having the exact same problem, I'd really like to know if you were able to solve the problem.
Phoenix_Dean said:
I'm having the exact same problem, I'd really like to know if you were able to solve the problem.
Click to expand...
Click to collapse
Me too... Is anybody has solution for this issue?
Oh poor fellows ....try to add DNS manually according to your ISP...not add public DNS
Try forgetting the network and connecting again and make sure all the other devices are using different ip address
Sent from my GT-I9300 using xda app-developers app