My GT-I9300 was suddenly dead two days ago. The phone can go to the download mode, but cannot access the system or stock recovery. Except the download mode, all I got was just a white noisy screen... Here is what I have done:
1. First, I tried to use KIES to reset my phone to the factory setting/firmware, but eventually I got an error message that "the phone is not recognized".
2. Then I tried to use ODIN to flash stock ROM, but the following error came out:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
3. So I found out a PIT file for 16Gb GT-I9300 and used ODIN to flash it, but I still failed:
4. Finally, I found out a thread about flashing the PIT file, bootloader, and ROM:
http://forum.xda-developers.com/galaxy-s3/help/solved-pit-bricked-dead-problem-gt-t2535367
I followed the steps shown in the thread, but I still got an error message when I flashed the PIT file:
So......I don't know what to do now... Anybody help? Please...
you have to replace motherboard or emmc chip,emmc chips are on ebay
If you had warranty then contact Samsung. You have SDS which they will repair for you.
Sent from my GT-I9300 using Tapatalk
Related
Hi
I have an S3 that I installed CWM on and OmniRom kitkat on. I have had it going well for about 2 years now, but the other day my phone ran flat and when I tried to switch it on it went into a boot loop. I have tried reflashing the rom and tried other roms. Wiped data, cache etc as per all the tutorials. Eventually I tried the stock rom using odin. Odin ran well with no errors. But now my phone now loops between the samsung logo and the Android logo. I no longer have CWM because of the stock rom.
What else can I try.
thanks in advance.
Try the rescue firmware in general forum and the pit file, the emmc was corrupted/damaged when the battery went flat.
BoomBoomer
thanks so much this got me on the right track and after much trial an error i managed to get my phone back with stock firmware.
I have this problem though. This screen pops up on the home page, just cannot get rid of it, any ideas?:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
sorted it out. once I found out it was in factory mode i was able to search and there are a bunch of solutions
this one worked for me: http://zidroid.com/how-to-exit-factory-mode-for-samsung-galaxy-devices/
Hello,
Im using Samsung Galaxy J1ace(SM-J110G) running on stock rom kitkat 4.4.4
There are many cases that J1ace are stuck at 'weird odin mode' that showing device information at the upper left without 'green robot' and 'downloading, do not turn off ' warning... many phone get this problem, one by one..its just like a cancer for this phone
See pic:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
We tried alot of thing, but none of them are working, including:
1) Flash stock rom via odin (stuck at 'getting pit file' or 'no pit file found' on odin)
2) Flash stock rom+pitfile via odin (stuck at 'nandwrite start')
3) Flash FullRom+pitfile via odin (stuck at 'nandwrite start')
4) We also tried to flash FullRom+pitfile via Z3x Box (show 'pass' but still stuck)
Condition:
-Most of us has rooted our device, but there also non-root device that having same problem
-using custom recovery(twrp)
-running on Stock Kitkat4.4.4 (since there no custom rom for our device)
Is there any chance to revive our phone??? Please help us fixing this problem
My cell started with a loop to try to restore from the factory, so I tried using odin to put a new ROM, and I can not complete the procedure, it follows the image of the error
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
bution said:
My cell started with a loop to try to restore from the factory, so I tried using odin to put a new ROM, and I can not complete the procedure, it follows the image of the error
Click to expand...
Click to collapse
Greetings and welcome to assist. Have you tried kies/smart switch emergency firmware recovery to see if that works ?
Good luck
Sawdoctor
Yes, not support the model/Serial Number
SM-G530H/DS
I got same trouble, with my G530H XSE, just like you.
i dont know where i want to do. so many attempt i've been tryin.
any idea to help us? we need to help
emergency update from samsung kies, isn't working .
I was having a problem with 3 units.
G530h, 2 G530BT
by USB nda it worked .....
Pit error
without adding the pit error system
I solved all 3 of my clients by eMMC written using Medusa-pro
I did not find any other way
From yesterday night my SM-G965F started randoom rebbot. I tried to flash via odin, but it's stuck on odm.img, i tried with latest odin V3.13.1 and pacthed odin also, but same result. Please check the attached screenshot and give me solution.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
how did you solve this?
saimon36 said:
From yesterday night my SM-G965F started randoom rebbot. I tried to flash via odin, but it's stuck on odm.img, i tried with latest odin V3.13.1 and pacthed odin also, but same result. Please check the attached screenshot and give me solution.
Click to expand...
Click to collapse
a more detailed process will be really helpful ..
and the members will be more easier to help you ..
frome the very beginning to the end ..
thanks!
i have same issue
i forget to see csc code and flash the phone with combination file to remove FRP lock and know when i flash with stock frimware its stuck on odm.img
any help please
when i flash AP it goes a bit then stops and says FAIL! the other parts worked fine but i don't know what happened to the AP part
my phone is SM-N935L
pls help
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I actually have the same problem on my sm-a750fn, but im currently trying to fix it because my Problem at the beginning was the Binarymy device was 5 but the files were 4, so i downloaded the new software but the ap didnt get flashed, even tho BL CP and CSC were flashed successfully, for me it stops at boot.img and then _XmiData_Write and suddenly Complete Write Operation Fail. Ill try my best and if i figure smth out ill contact you
Edit: Im sorry but after all i cannot help you, because i tried using the ap from the not working firmware, didnt work so i went back to the working firmware and tried loading the ap again and this time it worked, you should probably try updating your samsung drivers
Edit2: Or try to find another Firmware, but a new one and just flash the AP (you should use firmware for the device tho, because i had issues of firmware changing the model of the phone? so just be careful)