I recently install kernel siyah and i overclocked it to 1800,after a while i went to download some benchmarking tools and then the screen colour became negative,so i restart my phone and then when i on it it just stuck at the second logo where the samsung blink any help? or probably i need a stock kernel?
Edit:Samsung Galaxy S3
Flash full stock firmware with Odin, if it will boot into recovery then factory reset afterward.
Related
I tried to upgrade my phone using odin, i first tried to root by installing a kernal.
after installing the kernal to enable rooting ...it is now stuck on boot screen with samsung galaxy sII logo.
i cant even get into recovery mode.
i can get into download mode.
I dont know the exact model of my phone as i did not write it down.
The phone is factory simfree, from carphone warehouse.
i tried downloading different stock roms but everytime i try to update using odin..it always fails.
NOT TO WORRY....I FIXED IT BY DOWNLOADING THIS FIRMWARE http://androidfirmwares.net/PhoneFirmware/Download/67
GT-I9100_CPW_I9100XWLP7_I9100XXLPS_I9100CPWLP5.7z
...cant delete post...dont know how to
help please!!
My Galaxy Tab SGH-I497 wont boot all the way on. It started when I flashed a rooted ROM. Now I can only get into download and recovery mode. Ive tried to factory reset and same nothing. I flashed a kernel and stock ROM with Odin, both successful but still shuts off at Samsung logo! Also I dont know how to get into CWM or how it works! Help!
Well iv flashed a lot of rom onto this phone, but i decided that i wanted to go back to stock. So i flashed the stock rom, recovery, ect. Now my ace2x only boots into download mode, or stays on a boot loop at the samsung screen forever.
Please Help!
use 3 part firmware.
Hello Dears,
I hace an issue that my phone does not boot up and stuck on the galaxy logo.
i'm pretty sure that this is an issue with the battery since even when it fully chared the red led is on and not the green.
also, the battery drain quickly to zero...
what should i do?
any methos to reset the battery? something else?
Thank you guys.
Download the latest Jellybean firmware and flash it via odin. It should work fine.
PS: Use odin 3.09 or 3.10
Use odin and download Samsung rom or cm
Hello,
I installed a new ROM of CM but no luck )=
same same.. the phone is still stuck on samsung logo
Hi I've flashed I9300XXELLA_I9300OXAELLA_BTU on Galaxy S3 I9300 device, The firmware the flash was I9300XXUGMK7, after the flashing (Odin v3.13) the device is struck in SAMSUNG logo loop.
What is the problem?
Thanks.
Beside a possible csc missmatch, what I cannot evaluate, you can try a factory reset in recovery mode. And be aware that a restart of the system, after a new flash of a samsung rom via odin, can last several minutes (maybe up 15 til 20).