I ordered a Nexus 9 from Amazon on Friday (11/28). It arrived today. It has the better buttons of the newer models however there are 2 columns of very low sensitivity on the touchscreen. About 3cm near the left edge, 1cm on the rightmost edge. A replacement has been ordered.
Has anyone else had a similar problem?
I used Touch Screen Test to produce these results
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Related
So I just got my dock in today from Best Buy and I placed my Prime into it and get a full whiteout. It looks like I have the contrast and brightness up to about 90-100%. I then pull it out and it goes back to normal. I was also able to replicate this when out of the dock by putting minor pressure on the bottom bezel near the charging port. Anyone having this problem?
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
From using a too small car holder without a rubber on the back I got these marks that are like stripes from sliding too much.
Now is there any way to fix this without getting a whole new battery plate?
(I also scratched my transparent bar slightly, all while I have the phone for only 2 weeks now)
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
This is as clear as I could get it to show on camera, I usually notice the screen bleed when using dark theme YouTube or when closing all tabs on Chrome..
I've heard people asked for a replacement only to get another defective unit, should I ask for a replacement or is my unit considered on the "low screen bleed" side of the market?
Does anyone else have the same problem? It's visible in the picture below, top of screen is whiter than display. Like I have eye comfort on, which I don't. I had previously mate 9 pro which can have extra white screen so this is a step back for me. if you had the same problem, is it fixable?
Thank you
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
there is low range of wifi after the screen replacment donnot knw what happened
Look at that arrow cable, that it is well connected up and down, there are two holes at the top, if you made a mistake. The bottom circle is the antenna module, it has some metal plates that make contact and if they do not do it well, you have to raise them a little.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}