I used Odin 3.10 to flash my G900A Samsung galaxy s5 to 4.4.2 stock g6900aucu1ance (AP, CP, and CSC)
When my phone turns on, it loads fine and it starts to "lag" on the "spinning" Samsung logo. It then freezes, waits a few seconds, and the screen turns black. The led is blue and the only way for me to restart my phone is to take out the battery and put it back in to reboot it.
Please help me
Also, i've already tried going to the recovery menu and factory resetting. It does the same thing.
I also have the same problem on my samsung galaxy alpha device.
EuphoriaFedoria said:
I used Odin 3.10 to flash my G900A Samsung galaxy s5 to 4.4.2 stock g6900aucu1ance (AP, CP, and CSC)
When my phone turns on, it loads fine and it starts to "lag" on the "spinning" Samsung logo. It then freezes, waits a few seconds, and the screen turns black. The led is blue and the only way for me to restart my phone is to take out the battery and put it back in to reboot it.
Please help me
Also, i've already tried going to the recovery menu and factory resetting. It does the same thing.
Click to expand...
Click to collapse
Same problem i'm facing on my smg850a
Related
Hey everyone,
As the title says, I get a black screen after my Galaxy S4 boots up. It boots up like normal, but after the Samsung logo appears, my screen goes black and the only thing that is seen on it are two icons on the top right of the screen. I used Odin to flash the stock Android 5.0.1 firmware. I tried using Kies to restore the firmware, but it gives me a message saying that the initialisating isn't supported by GT-I9505. I've visited at least 10 different forums and they all tell me to flash the stock firmware again, which doesn't work. I should also note that my phone doesn't boot into recovery mode for some reason. It says in the top left corner that it's booting into recovery mode, but then it shuts itself off and on again, and just boots like normal.
Hope someone's got a solution to this..
Hey everyone! Big problem..
I have installed CM12, Android 5.1 it's been all fine up until now, I was planning on selling the phone, so I factory reset it, that went well until it tried to turn itself back on afterwards.
My Samsung Galaxy S3 i9300t is stuck in a bootloop. I can not do absolutely anything.
I've tried taking the battery out, holding the three buttons, putting it back in, doing that with a USB, As soon as I turn it on, holding buttons or not it goes straight into a bootloop. I can't use odin to install the custom firmware again as I can't get into recovery or download mode or anything, once it's in the boot loop it stays there..
Any help is appreciated.
Bump?
Ok, so one night I was using my phone normally (Browsing. Watching YouTube, Playing Games) like everyone else does. Then all of a sudden it shuts off, but immediately turns on again without me pressing a button. (So basically it suddenly auto restarts on its own) This occured maybe 2-4 times (all in one night) until one time, it shuts off but doesn't turn on again (basically an automatic shutdown), so I tried turning it on again (Power button), then I got shocked because all of a sudden it enters a boot loop (Screen displaying this sequence : Samsung Galaxy S4 screen, my carrier logo screen, The encrypted screen (where you have to enter your encryption password) then again the Samsung logo but this time with the colors splashing from the background, then it shuts off again.) Sometimes after the boot loop sequence, it vibrates but never turns on again, sometimes it just turns off after the sequence. And as I try and try to get away from the boot loop, the sequence became shorter. So I'm guessing it's a battery problem, BUT my battery isn't bloated or deformed. I tried clearing the cache first, again the sequence got shorter (never going up to the carrier logo screen), then I tried formatting the data, still to no avail. Now, when I turn it on, It shows the Samsung logo screen for 2 seconds and shuts down.
I tried flashing it with ODIN thru Download mode BUT (HERE'S where another problem occured) :
My phone never get pass on the system.img.ext4 dialogue and my screen just goes blank. But ODIN still recognizes my phone. And when I remove the USB cable, ODIN says FAIL.
I'm sure the cable is working. I downloaded the firmware for my carrier (Tre 3).
What could be the real problem here?
Here is the description of my device :
Samsung Galaxy GT-I9505
Bought from Italy, Tre 3 carrier
Can I download a different region/carrier for my I9505 phone?
Advanced thanks for anyone who comments and I'm very sorry for my English. Thanks!
I would install TWRP recovery, boot to it, and use it to format data, which will remove the encryption. Then I would either push a rom to the phone via recovery or try to reinstall the stock firmware with Odin. Make sure that you run Odin as admin as well. The firmware must be the same version or newer. If you still have the stock recovery and can boot to it, then I think the build number of the currently installed firmware will be visible there. You should be able to use that to Google the correct version you need.
Hey it's me. Just posting a quick reply.
Thanks for replying to my post. Yesterday I successfully flash a rom to my GT-I9505 (Version 5.0.1 Italy HUI 3G). However it still didn't boot up. At first try it booted up to the first setup screen then just randomly shuts down. Then as I try to boot it up again, It just shuts down after the first Samsung logo (with the GT-I9505 logo), I can't boot into recovery cause it shuts down. I'm sure it's not a battery issue cause when I boot into download mode, it can stay in that screen for like 10 minutes. What could be the issue? I'm planning to disassemble my S4 sooner to see if something's wrong inside. Thanks again for the reply
My Samsung Galaxy S6 Edge will no longer turn on. The battery died and it was able to fully charge to 100% and then when I attempt to turn it on it sits at the flashing Samsung screen forever. The little notification light flashes 2 different blue colours when it attempts to boot.
I have flashed TWRP recovery via Odin (newest version) and it boots into it fine. But when I am in, along the top it is red. Everything I attempt to do (flash roms, factory reset, etc) it fails. Also when I try and restart phone via TWRP it freezes.
I have a SM-G925S, but do not know build number or no how to find it.
Please any help would be greatly appreciated!
hi there, is there anyone experiencing the problem on my s6 edge sm-925i ksa,
problem:
it hangs as soon as samsung galaxy edge logo appears, sometimes it can go to samsung dim dim logo but still frozen and even when i charged it turned off after a minute or two it hang and not responsive unless i do the power + volume down button to force restart it. i cant even go to recovery mode because of that hangs.
troubleshooting:
i can flash new firmware via odin w/pit files.
downloaded the factory firmware via frija
i do flashing other firmwares but stills hangs on samsung logo..
i also did the erase nand in odin but still no success booting up
installed twrp but frozen after a minute on twrp
model:sm-925i
csc:ksa
hope someone can help me fix my phone
jmvitan said:
hi there, is there anyone experiencing the problem on my s6 edge sm-925i ksa,
problem:
it hangs as soon as samsung galaxy edge logo appears, sometimes it can go to samsung dim dim logo but still frozen and even when i charged it turned off after a minute or two it hang and not responsive unless i do the power + volume down button to force restart it. i cant even go to recovery mode because of that hangs.
troubleshooting:
i can flash new firmware via odin w/pit files.
downloaded the factory firmware via frija
i do flashing other firmwares but stills hangs on samsung logo..
i also did the erase nand in odin but still no success booting up
installed twrp but frozen after a minute on twrp
model:sm-925i
csc:ksa
hope someone can help me fix my phone
Click to expand...
Click to collapse
After you flash stock firmware, the first boot can take 15-30 minutes so leave it a little while