hisense u971 Dead After Flash With Qpst ?
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
And With Mflash
I have the same problem.
First my phone came with viruses, and I wrote one firmware that is available to flash on the net using CMD and it flashed smoothly, but my phone had camera problem, only the front camera worked. Then I found another flashfile which is of different type and needed to be written using another method. When I wrote that Hisense-u971-13 firmware using QPST now phone half dead like some LG phones and detected only as Qualcomm HS-USB QDLoader 9008. When trying to write firmware I have always the same problem, but the address of flash writing failure is not the same always when trying to write.
Any advice how can I revive this damn phone?
Thanks
I see everywhere enter the mode download but do not see images or how to do it at the most is that I can get in diagnostic holding (vol +) + power, hence connect the USB, but it is still not the download mode. the fastboot only have the Chinese rom, hence got the European but is at QPST, need to restore the operation of the camera
images
https://1drv.ms/i/s!AvOFwCdFFtWO2n2zXow22G1EoSps
https://1drv.ms/i/s!AvOFwCdFFtWO2nwAHGODwfwO8-W9
Related
Dear tema member XDA,
my Lenevo s850 not recognize in laptop.
history:
i have root my mobile.
remove some factory installed unused apps then phone malfunctioning,calling not working.
so i made emmc clear in hard reset.then phone update and ok.working ok.
after that i have flash custom vibe 2 ROM by flash tool , phone working ok.
when phone switch and again on.
i try to again flash original flash ROM it completed but preloader error msg was coming and flash tool completed.
. but when disconnect phone and again not ON. i try to factory or meta mode but not working screen,when connect to PC it shows usb not recognize.
i read other thread regarding this.
if i have to jumper the usb charging.give me picture of point.
help me to On the phone.
Make sure USB debugging is set to on. Like so :
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
To turn it on go to about device and click build number 5-7 times to enable developer settings
Sent from my SM-T350 using XDA-Developers mobile app
Hi guys!
I have a Lenovo s960t phone (I think fake Lenovo). I tried change rom and I load a wrong preloader. Now the phone not turn on, not charge, I can't get any sing of life. It hard bricked.
But I tried go to meta mode with short the colo or kcolo with ground. But havent any sing on motherboard which golden point the colo. I found 2 point (can see on picture) what work and the pc is see SOMETHING on USB port. Unkown device. I tried tons of MTK 65xx driver to install. Change my operation system to 32 bit Windows 7 but same. Unknows device. Tried both golden point and same results.
http :// tinypic . com / r / ftpv91 / 9 -without spaces (because not allow my picture to share
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I hope somebody can help on me to make it.
Hello,
I need help to recover my phone.
I've flashed my Ulefone U007 several times to update to a newer version.
The last time, I've installed without errors, but with time, the applications started to show errors, others disappeared (Marketplace, calculator, calendar, ... for example). I flashed the phone again with SP Flashing Tool, but something went wrong and my phone is dead since. The SP Flashing Tool doesn't detect my phone any more and gives me an error
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
The phone doesn't show battery animation when I charge it, No light or vibration when I power on, I've tried "power"+"volume up" or "power"+"volume down", and nothing happen. Can't get to the recovery menu.
I'm using Windows 10. I think something inside the mobile is still alive, because when I connect the mobile in the USB of my computer shows a MediaTek USB Port (COM4) on the devices.
I'm guessing that the bootloader or disk partition is corrupt.
Any help will be appreciated.
Thanks in advance.
Regards.
Hello!
I have a Allview X3 Soul (clone of Gionee S6)
GsmArena link : https://www.gsmarena.com/allview_x3_soul-7913.php
So, i managed to get it in fastboot mode through adb. The phone screen shows this:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
So it says that fastboot AUTOMATICALLY turns off to keep the phone safe.
PC doesn't detect it in fastboot, only adb
I have rooted it and then unrooted with KingRoot (NOT KingoRoot) 1 year ago, and after that wireless connections stopped (wifi, cellular data, calls and bluetooth), I couldn't install some apps.
3 months later I tried rooting with Magisk Manager (bad idea, i didn't have twrp or unlocked the bootloader). Same thing happened as last time, adding that the wallpaper became blank black
Anybody knows how to unlock bootloader through adb or to enable fastboot mode through adb?
EDIT 1
Performed a Hard Reset, same results
You do not have to use fastboot to flash TWRP recovery ..or any new rom .. use sp flash tool to flash the orginal firmware
Hi, i need some help.
Been using mipad 1 with Lineage os for a while, last week i decided to flash the stock rom... dont ask me why :|
Flashed it with fastboot, I am not sure what I did wrong at that time but I am not able to boot the system anymore. The device always gets stuck on the mi logo or just freezes after a few seconds on mi-recovery and twrp (see the videos below please)
I am still able to access fastboot, already flashed different versions of stock roms, but no results so far...
Any help is appreciated.
Hi Did you get a solution? i tried shorting the memory slot and i have a stable connection to the laptop, shows up as Nvidia usb boot recovery driver for mobile devices. I am unable to flash the tab. Mi old version detects it but says operation complete in 0 seconds when i try to flash fastboot rom. The miflash new version does not detect the device.
miflash old version detects this:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Eagerly awaiting ideas.
PS: I have no access to fastboot