Asus Fonepad ( K004 ) stuck at boot loop - Android Q&A, Help & Troubleshooting

Hi, i have Asus Fonepad ( K004 ) which stucked at boot loop, it boots and then after few seconds black screen and it starts boot again... . This all started after i have turned it off, because there was error message "google.apps.process" stopped working and after pressing ok this message won't go aways, so the tablet was turned off and after power on it stuck. I have tried to do factory reset, but got this message "still unable to mount /cache give up | result: fail (problem with write cache command!)". And have loaded new firmware twice but it's not working. I have seen topics with such problem, but people solve it through adb and .img file. For this device there is only one firmware file .raw. Help if you know what should i do/

Related

[Q] Stuck in bootloop, can't connect to adb

I tried installing CM12 and when I restarted I got stuck in a bootloop. It just stays on the LG logo screen for a while until the kernal crashes. I can enter Dload mode and fastboot and I see my computer installing the drivers but adb devices says nothing is connected. I tried entering recovery but the phone just vibrates, restarts, and goes back to the LG logo. Is it fixable or do I have to send it in for repairs?
*Edit* - After about ten minutes of trying to enter recovery and rebooting it finally entered recovery and now all is good.

[Q] Asus Zenfone 4 A400CG bricked, bootloop in droidboot and Intel logo

Hi all,
I have a Zenfone 4 A400Cg and a few weeks ago, I tried to change the SKU from WW to CHT so that I can update to CHT Lollipop.
Changing SKU was successful but I couldn't update to Lollipop. So, I went back to WW SKU but I have a problem with Asus Demo Mode and I tried to fix it. I don't remember what I flashed after that (I flashed many ROMs) and it turned out that it boots up and show Intel Inside logo then it automatically boots into Droidboot itself.
After that I found that, reflashing any stock ROMs via fastboot command (fastboot flash system system.img.gz) and via SD download can't help me to get back. Such issue still persists. Factory reset doesn't work as well, when do such option, it reboots and shows Intel Inside logo and boots back into Droidboot itself. Normally, when flashing a new update or do a factory reset, the phone will reboot and shows an Android with progress bar and a spinning cogwheel, but in this case I don't see it but Intel logo.
But I notice that before the Intel Inside logo will appear, the original Asus Zenfone with Android logo at below will appear for a split second.
If anyone knows how to fix this please advise me. Thank you

[ Alcatel Pop C1 - 4015X ] Stuck on operator Logo [ Bootloop ][Need Help]

Hello XDA ,
I own an Alcatel Pop C1 that is stuck on the Operator Logo.
The phone starts normal , it passed the android logo animation but after that it stucks on the Operator Logo.
The phone is not rooted or has a custom recovery.
I hard reset'd the phone for over 4 times and no result.Also I tryed to spam the volume buttons method to see if the phone can get in the safe mode but had no result on this situation either.
I tryed almous all methods. I readed about adb push , to put a cutom rom , but I dont quite understand how to make it.
Methods tryed till now :
- Button spam for Safemode ( Didnt Work )
- Factory Reset ( Didnt work )
- Alcatel Mobile Upgrade S 4.1.1 ( Latest Version )
- SP Flash Tool v3.1344.0.212 ( Phone cannot be seen by the tool in bootloop state or recovery mode )
Need some advice on what to do .
Thanks in advance !
Did you ever find the solution to this?
I have the same problem.
It will only boot to Alcatel boot screen but no further. My customer said it lost power in the middle of the update.
I have downloaded also the Alcatel Mobile Upgrade S 4.1.1. and it starts the process gets to the third step where it is about to load the image on to the phone then it says there is a problem with the image. I went though the process of removing the batter as the directions say then reconnecting and it goes though the same process with the same error saying there is a problem with the image.
I have tried the same things as you as well and they have not worked.
-Factory reset and safe mode.
Safe mode only shows a black screen but the computer recognizes the phone.
I am going to try to see if I can find a custom rom and flash it and then possibly restore it back to factory. I will let you know if I find anything that works.
Jeremysjunk

Acer iconia a1-810 stuck in recovery mode !

Hi i have problem with my tablet Acer Iconia a1-810 im stucked in recovery mode... every time restart to anroid recovery mode...
hard reset wont help i tried update firmware from acer site all WW_GEN1 and nothing always error like assesrt failed getprop(ro.product.name == a1-810_ww_gen1 installation aborted.... i tried like 6-7 firmwares always error... I tried delete first line in update script always installantion aborted...
What can i do? when i click reboot system now it will be erasing like 15 sec and reboot back do recovery every time... i tried disconnect battery but nothing help..
sorry for my enlgish
IrvinDgl said:
Hi i have problem with my tablet Acer Iconia a1-810 im stucked in recovery mode... every time restart to anroid recovery mode...
hard reset wont help i tried update firmware from acer site all WW_GEN1 and nothing always error like assesrt failed getprop(ro.product.name == a1-810_ww_gen1 installation aborted.... i tried like 6-7 firmwares always error... I tried delete first line in update script always installantion aborted...
What can i do? when i click reboot system now it will be erasing like 15 sec and reboot back do recovery every time... i tried disconnect battery but nothing help..
sorry for my enlgish
Click to expand...
Click to collapse
up
I have the same problem...

RECOVERY MODE "failed to mount/data"(invalid argument) failed to resizing-data"

HI GUYS!
I have a problem with my Samsung S9+ , while it stopped at a sudden and started to have a loop restart and then i got to the recovery mode i did wipe cache on the beginning and restarted but it went for loop restart, then i did factory reset and again loop start .. so then i went to the bootloader to install a firmware via Odin3 i did it and then when it finises and the phone reboot it come back to the recovery mode and show on the screen down that "failed to mount/data"(invalid argument) failed to resizing-data ..
knowing that i cannot go on the phone to do ADB the phone is only loop restarting ..
please guys anyone can help me in that ??

Categories

Resources