My fire hdx 8.9 is unlocked and was installed with cm 13 rom. I wanted to flash the same cm 13 again, so I wiped data. After that, ALL roms I tried to install was ERROR 7.
I heard that this is due to an error recovery, so I tried to install a new one by ADB. However, I installed a wrong thor one, and now I can't use the touch screen even if I install an Apollo one.
To make matter worse, it is also ERROR 7 whatever I try to install. So what should I do? THX a million!
Neko_nyan said:
My fire hdx 8.9 is unlocked and was installed with cm 13 rom. I wanted to flash the same cm 13 again, so I wiped data. After that, ALL roms I tried to install was ERROR 7.
I heard that this is due to an error recovery, so I tried to install a new one by ADB. However, I installed a wrong thor one, and now I can't use the touch screen even if I install an Apollo one.
To make matter worse, it is also ERROR 7 whatever I try to install. So what should I do? THX a million!
Click to expand...
Click to collapse
- place device in fastboot mode via <power>+<vol-down>
- connect cable; look for ready prompt on device (if not check drivers)
- grab TWRP build 3.0.0-1 from this thread (that build - NOT the latest)
- use fastboot command in OP of above thread to install TWRP
Related
Hello good people of XDA.
I have managed to get my HDX stuck in a bootloop by trying to install CM11 for safestrap 4 whilst running safestrap 3.75 and am hoping someone can help me unbrick it
- Was running update-kindle-13.3.2.4_user_324002120.bin rooted with Safestrap-Thor-3.75-os3.2.4-B02 installed
- Attempted to install [ROM] [STABLE] CM-11 for Safestrap v4 2015/07/26 on stock ROM slot from within safestrap. All appeared to install OK
- Upon reboot NO SAFESTRAP and does not go past grey kindle fire logo (no animation)
- Device reboots after 40 seconds
- After much faffing around with drivers I DO have adb access (for 40 seconds until device reboots) and can send adb reboot bootloader to the device to get fastboot. Fastboot commands work and device does not reboot when in fastboot
- Can get to stock recovery if i issue adb reboot recovery or power+vol up
- I (foolishly I now realise) did do a "reset to factory defaults" at the stock recovery
- Unsure if I still have root - dont think so though due to doing factory reset
- Cannot flash a system update because the file is 849mb and the device reboots before the transfer is complete and I get a "protocol error". Also possible lack of root may cause this not to work even if i could copy it across
- Tried to flash signed-thor-twrp-2870.img but got FAILED (remote: flashing not allowed for locked hw) when trying to copy to the SDCard
Looks like I have managed to overwrite the safestrap recovery and for whatever reason the CM11 ROM is not loading.
As I understand it, the general process for unbricking a device is:
- get fastboot access [OK]
- flash a recovery [HELP stuck on this]
- Install a ROM from recovery [will be ok with this once I get a recovery working]
I THINK I need to unlock the bootloader so that I can flash a recovery image but I need root to do that which I think I have lost. Is there a way to check? Is there a way to get root back from adb/fastboot? I have tried KFHDX Toolkit to root the device but get "Kindle Fire HDX 7 (cm_thor-userdebug 4.4.4 KTU84Q 8680464d7c test-keys) is not supported" so it is seems to be recognising it as CM11?
I would really appreciate any guidance anyone could give me
Why didn't you read first and ask first before you did all that?
It says CM11 for Safestrap v4! You did NOT have v4! You can NOT install TWRP on 3.2.4, you Need 3.10 - 3.2.3.2 for this. And I don't think you can unlock the 3.2.4 bootloader either.
This looks very bad for you.
So you should have downgraded to 3.2.3.2, install TWRP, unlock bootloader, and flash CM11. Now it seems you don't have a working system anymore.
Cl4ncy said:
Why didn't you read first and ask first before you did all that?
It says CM11 for Safestrap v4! You did NOT have v4! You can NOT install TWRP on 3.2.4, you Need 3.10 - 3.2.3.2 for this. And I don't think you can unlock the 3.2.4 bootloader either.
This looks very bad for you.
So you should have downgraded to 3.2.3.2, install TWRP, unlock bootloader, and flash CM11. Now it seems you don't have a working system anymore.
Click to expand...
Click to collapse
Yeah I realise all of this now. Thought safestrap would protect me if there was a problem.
So, anyone know if there is anything I can do to salvage my device? Was hoping I would be OK since I have fastboot.....
stragen001 said:
Yeah I realise all of this now. Thought safestrap would protect me if there was a problem.
So, anyone know if there is anything I can do to salvage my device? Was hoping I would be OK since I have fastboot.....
Click to expand...
Click to collapse
Amazon's neutered fastboot environment is useless with a locked bootloader (and next to useless when unlocked). "Factory cables" are totally ineffective on an HDX. You can not unlock your bootloader without downgrading which is impossible without a working system AND functioning recovery. There is an outside chance you might be able to root using HDX toolkit (look for it in the Android Development forum) but not sure what that will accomplish given your device is fully borked. You can not flash a new rom with locked bootloader. You can not flash a 'real' recovery with a locked bootloader or bootloader version vunerable to the signature exploit (3.2.4 is not). Ditto for the bootloader itself. I could go on but the point should be obvious.
How can I install CWM for the Fire HD 7 (4th gen.)? (KFASWI - Fire HD 6 / 7 - Fire OS 5.1.2)
My Fire has no recovery at all (if I try to boot into recovery it boots normally) and I can't boot into fastboot either (it boots normally).
How can I install CWM? If I try to install TWRP I get no TWRP on reboot.
Please help, I want to install Xposed on it!
CreeperBombCraft said:
How can I install CWM for the Fire HD 7 (4th gen.)? (KFASWI - Fire HD 6 / 7 - Fire OS 5.1.2)
My Fire has no recovery at all (if I try to boot into recovery it boots normally) and I can't boot into fastboot either (it boots normally).
How can I install CWM? If I try to install TWRP I get no TWRP on reboot.
Please help, I want to install Xposed on it!
Click to expand...
Click to collapse
Just follow this :
http://forum.xda-developers.com/fire-hd/general/how-to-upgrade-to-lollipop-root-gapps-t3163950
Post #2 will get you into TWRP, so you can flash Xposed. Then you'll lose TWRP as you go back into FireOS 5, but can repeat this any time in the future !
bibikalka said:
Just follow this :
http://forum.xda-developers.com/fire-hd/general/how-to-upgrade-to-lollipop-root-gapps-t3163950
Post #2 will get you into TWRP, so you can flash Xposed. Then you'll lose TWRP as you go back into FireOS 5, but can repeat this any time in the future !
Click to expand...
Click to collapse
That **** called xposed bricked my fire into a bootloop, only after 1 year I could unbrick it using the tutorial from bibi
:fingers-crossed:
As a long-time user, no-time developer on XDA, I appreciate "ClockWorldMod"... sounds like something I would have said in 2010, which really takes me back
FYI ClockWORKMod is the recovery you are referring to, I assume. And TWRP dominates since about 2012 or 2013 (correct me if I'm wrong, I'm no dev), so I certainly back the recommendation to use that tutorial.
Hi everyone, I just purchased a used thor from ebay and am excited about flashing custom roms for it. It came with TWRP 2.8.6 and HDX nexus (4.0.5) already installed, so a great plus and I was able to flash the newest refresh, Fire Nexus rom, BUT with a slight hiccup as it gave me an error, "E:Error executing updater binary in zip". I followed the advice from a google search result that said to reboot back into recovery after the failed attempt and try again, but without wiping. This time it worked.
My question is, if I have a custom recovery TWRP 2.8.6 and now a custom rom, fire nexus with root, does this mean the bootloader is unlocked? I guess a bit confused. Also, would the TWRP error message be an indication of an outdated TWRP or something else?
At some point I would like to move to to CM 14.1, but realize I would need to update TWRP and have an unlocked bootloader to achieve this. Thanks everyone. I am a complete noob to flashing!
- Current Recovery: TWRP 2.8.6
- Current Rom: kk-fire-nexus-rom-thor-20161017
- Rooted
- Made a backup of HDX Fire Nexus
- SuperSU required a binary update, done automatically by TWRP.
Verify the hash value of the ROM , just to confirm it's not corrupted. If it is fine boot into in twrp under "mount" options de-select system and try reflashing. You may need to reboot after deselecting it.
Mr McBoatface said:
Verify the hash value of the ROM , just to confirm it's not corrupted. If it is fine boot into in twrp under "mount" options de-select system and try reflashing. You may need to reboot after deselecting it.
Click to expand...
Click to collapse
Thanks for the reply. Rom was ok I think..I checked the zip in es file explorer before flashing and all the directories and files were intact. I checked the mount as you said and the system had previously been deselected. I did read that selecting and then deselecting might work. The next time I flash a rom I will def try this method again.
So do I need to downgrade or what? How do I root kindle fire os 5.3.3.0? My kindle fire is hd 6 4th gen
Yep. There's a thread around here somewhere outlining the process. The basics are: Set up ADB on Kindle and PC. Sideload Fire OS 4.5.3 to your Kindle via ADB. Block OTA updates. Root via your preferred method. Install TWRP. Use TWRP to flash 5.3.3.0 bootloader and ROM back to your Kindle. Done.
I know it's a pain in the arse to go through all that, and in the end you don't even get to keep TWRP, but as far as I know it's the only possible way to get root on the HD 6 and 7 4th gen right now. At least until Kingroot is updated.
You can't flash twrp right after flashing 5.3.3.0? Or will the kindle not boot?
Sent from my VS990 using Tapatalk
No. Your Kindle would still boot, you just wouldn't have a recovery anymore. For whatever reason TWRP doesn't play well with bootloaders above 4.5.x. So if you were to flash TWRP in 5.x, you overwrite the stock recovery. Upon reboot, TWRP won't work since you have 5.x bootloaders, and your stock recovery is gone since it was overwritten by TWRP. So you're in the nasty situation of having no recovery and no way to get one back.
Somewhere in the rooting thread there is mention of an automated script that will flash 4.5 bootloaders for you and then boot into TWRP. Once you're done just flash your 5.x bootloaders back and reboot. Not a permanent fix, but at least it's all done on the Kindle itself (no need for a PC once it's set up) and there's no chance of ending up without a recovery since TWRP is ran in memory and not flashed so your stock recovery stays intact.
There's a detailed tutorial that I've updated and simplified for 5.3.3.0 here: https://forum.xda-developers.com/showpost.php?p=72466867&postcount=540
Hi all, sorry to jump in here, but does Fire HD 6 have OTG support for flash drive?
Hello, I have a rooted Kindle with Safestrap 4.01 (TWRP v2.7.1.0) and Android 4.4.4 (KitKat). I did that some time ago.
Now I want to update Android 4.4.4 to Android 6 or higher to run some apps on it.
I tried it with Lineage 14.1 Thor.
I wiped the device in Safestrap, installed the new firmware lineage-14.1-20200705-UNOFFICIAL-thor.zip, wiped Dalvik after it was done flashing and rebooted.
I also tried it with other Lineage versions but after rebooting it's only showing a black screen for 20+ minutes (the only one that seemed to work was Lineage 11 but it didn't update my Android version).
Am I doing something wrong? Maybe I go about it totally wrong but all tutorials tell me that's the way to go.
EDIT:
I almost bricked my system twice and I think I found the culprit. It might be Safestraps fault.
Now I'm trying to get a twrp recovery mode update but the fastboot mode doesn't let me use .img files
(doesn't recognize any devices and I already manually updated my Android ADB Interface driver a few dozen times but it still won't work - still a question mark above the device).
Is there a twrp zip file which I can use to install from Safestrap?