I decided to try out the Mokee ROM which is based on CM 12.1. Everyone on this thread(https://forum.xda-developers.com/re...m-cm-12-1-mokee-bule-mokee-blue-t3328382/amp/) praised this ROM for being stable enough. I installed TWRP and flashed the ROM. Everything was working fine, only problem was I couldn't change notification light color. I installed some CM themes and flashed a font. However after I flash something through TWRP the ROM acts strange. Sometimes it says "Android System stopped working." Widgets are blanked and I have a soft brick. I wiped dalvik even tried I dirty flash twice. Same problem persists(e.g. flashing something hangs up the system) and I couldn't tell if the ROM was stable or not. I was missing my calls so I reverted back to MIUI 9.
Any solution for this? I cannot provide screenshots now.
Related
Hi All,
Last week, I flashed my LG Nexus 4 (16GB) phone with stock Android 4.4 (Official Image), before that I was on CyanogenMod 10.1.3 Stable.
Now, for some reason I didn't like the stock 4.4 and tried to Flash back my CyanogenMod 10.1.3 from CWM "Install ZIP" but the problem I'm facing is that it CyanogenMod doesn't boot, hangs on "Spiral Splash Screen". Then I tried Flashing CM 10.0 stable, still loops into boot forever and at times boots (after 15-20 minutes of booting on spiral splash screen) and doesn't recognise SIM card, Camera, Storage, WIFI or anything.
Then after getting fed up with this I tried flashing MIUI V5. This also takes a 15-20 to boot and fails to recognise - SIM, WiFi, Camera etc.
So lastly like a loser I flashed back my Android 4.4 it works fine.
I've my boot-loader in unlocked state.
and Yes before flashing CM or MIUI, I did - wipe data/factory, wipe cache, wipe dalvik cache from CWM Recovery.
So I want to get back into CyanogenMod 10.1 stable. Help me out with this.
Restoring Nexus 4
prakharprasad said:
Hi All,
Last week, I flashed my LG Nexus 4 (16GB) phone with stock Android 4.4 (Official Image), before that I was on CyanogenMod 10.1.3 Stable.
Now, for some reason I didn't like the stock 4.4 and tried to Flash back my CyanogenMod 10.1.3 from CWM "Install ZIP" but the problem I'm facing is that it CyanogenMod doesn't boot, hangs on "Spiral Splash Screen". Then I tried Flashing CM 10.0 stable, still loops into boot forever and at times boots (after 15-20 minutes of booting on spiral splash screen) and doesn't recognise SIM card, Camera, Storage, WIFI or anything.
Then after getting fed up with this I tried flashing MIUI V5. This also takes a 15-20 to boot and fails to recognise - SIM, WiFi, Camera etc.
So lastly like a loser I flashed back my Android 4.4 it works fine.
I've my boot-loader in unlocked state.
and Yes before flashing CM or MIUI, I did - wipe data/factory, wipe cache, wipe dalvik cache from CWM Recovery.
So I want to get back into CyanogenMod 10.1 stable. Help me out with this.
Click to expand...
Click to collapse
Hello Prakhar,
I would suggest you to first download the official image of Nexus 4 for android 4.3 and flash it from https://developers.google.com/android/nexus/images and then you can try to flash CM 10.1.3 from the CWM Recover Console. Hope this helps!
I would also like to point you out to https://developers.google.com/android/nexus/drivers which contains drivers for your phone's camera, etc. you can download those binary and flash it one by one through your recovery console, which might fix your issues.
It worked !
Downgraded to stock 4.2.2 then Flashed CM 10.2 RC1 from CWM Recovery !
Thanks a lot U3ViaGFsbyA6UA==
Hi to everyone!
I have a Samsung I9300T (Australian version). A few months ago I flashed my phone through CM Installer from stock Rom (Vodafone's Android 4.1.2) to CM 11 M2. And there were no problems.
A month ago I flashed CM 11 M6. And after upgrading from M2 to M6 my phone started rebooting at random times. In these moments, the display goes black, then the logo "Samsung S3" is displayed for a few seconds, then reboot again and it lasts permanently. I flashed cm m2 back, but this problem not solved.
I've made full wipe, installed M7, installed GApps, made full wipe. And it's still reboots.
I've reinstalled CWM recovery through ROM manager. And it's still reboots.
I've made full wipe. installed another ROM (not CM), made full wipe. And it's still reboots.
I've flashed default stock and recovery from vodafone (4.3) through Odin, and it's still reboots.
Please, help me with this trouble.
Thank you.
If it is still the same on a fresh install of stock firmware then it is a hardware issue.
boomboomer said:
If it is still the same on a fresh install of stock firmware then it is a hardware issue.
Click to expand...
Click to collapse
When I flashed a stock ROM, I found some files from CM ROM in phone memory. How can I make full format of all data in phone? I think some parts of old ROM make bugs. And maybe kernel was modified, may it cause these problems?
Hi!
I flashed CM 13 on my RedMi 3, after some weeks I wanted to go back to XiaoMi.EU MiUi so I wiped dalvik, cache, data and system partitions then I restored the backup but it didn't boot up (it showed Mi logo then it reboots); I tried to make a clean flash but it still didn't boot up.
I flashed latest china developers firmware but it didn't boot up too; I tried with global developers and I found that the bootloader has been blocked (I don't know why), I unlocked it and tried again but it still didn't boot up.
I tried to flash vietnamese unbrick firmware but it stil didn't boot up.
I reflashed CM 13 but it doesn't boot up.
What's happened? I ran out of ideas. :silly:
Sorry for my bad english.
try this:
http://en.miui.com/forum.php?mod=redirect&goto=findpost&ptid=342268&pid=6219442
retakal said:
try this:
http://en.miui.com/forum.php?mod=redirect&goto=findpost&ptid=342268&pid=6219442
Click to expand...
Click to collapse
It didn't work. Thanks anyway.
After a lot of experiments I got CM 12.1 working; unfortunately it's the only one ROM that boots. :|
@Anik_khan: Have you ever tried to go back to MiUi from CM 13?
EDIT: Sometimes when I try to turn it off it reboots and sometimes it reboots 5/6 times before boot up.
I tried to flash English unbrick ROM and XiaoMi.EU fastboot ROM too but they don't boot.
On CM 12.1 audio doesn't work. I start thinking that's an hardware fault because I tried all possible solutions.
I tried latest @Anik_khan's CM 13, latest XiaoMi.EU weekly and FlyMe too but they don't boot (on CM 13 I don't even see bootanimation). If I flash a custom Kernel (for example MYKernel) on CM 12.1 it doesn't boot anymore.
I suggest you to go to Mi service center.
Hi,
I've got a RN3, snapdragon version, 3GB of RAM. Unlocked bootloader. TWRP 3.0.2-2
I've been using CM for a while, android 6.0.1 and I've been trying now for a few days to move to Nougat.
I've tried different roms: NitrogenOS, lineage OS, resurrectionRemix.
I've also tried flashing different versions os miui firmware: 7.3.16, 7.3.23, 7.3.30
So, after all that, the result is always the same. The flashing seems successful, the phone boots but then I cannot go through the initial setup screen.
I choose the wifi network but when I try to enter the password, the screen resets every 5 seconds or so. I know it's resetting/reloading because the password I've typed so far goes away and I have to start again. It happens every few seconds and I cannot setup wifi properly.
I tried changing the password to aaaaaaaaaa to make it easy and quick to setup. Once I go through that, it stays for ever in the next screen "checking information" (or something like that). Again, it seems to be reloading this screen every few seconds.
is there something am I missing? Maybe I'm flashing firmware/rom in the wrong order?
I'm back with android 6.0.1 now and the phone works fine.
thanks in advance for your help.
Flash Kenzo Firmware , Rom & Nougat Gapps not MM , next reboot system
Sent from my Redmi Note 3 using Tapatalk
VaibhavKumar07 said:
Flash Kenzo Firmware , Rom & Nougat Gapps not MM , next reboot system
Sent from my Redmi Note 3 using Tapatalk
Click to expand...
Click to collapse
thanks @VaibhavKumar07
so, this is exactly what I've tried a few times.
what about wipes and all that stuff?
I don't mind doing a clean install and reinstalling/reconfiguring everything.
I've tried different things, but for example what is mentioned in the thread "CM13/14/14.1/AOSP N firmware for KENZO/KATE [VoLTE][12.1.2017]"
-Reboot to TWRP recovery
-Flash firmware
-Factory reset (data, cache and dalvik-cache)
-Flash your favorite Marshmallow or Nougat ROM
-Reboot your phone
is that still valid for the nightly builds from April 2017?
On Cm firmwares I was unable to get VoLTE working so recommend you to flash Miui beta firmware search in SD Rom or guide section you'll find em if not message me again .
Regarding procedure :
- First flash Twrp 3.1.1.0 from official site cuz that's latest
- Next go & wipe check everything except SD card & OTG
- Flash Firmware
- Flash Rom
- Flash Gapps Arm *64 Android N from Open apps
- Flash Any Add-ons if required like kernel or Sound enhancement mods ( optional )
- Clean cache/dalvik cache
- Reboot
Mention the Rom you're flashing!
Sent from my Redmi Note 3 using Tapatalk
So, I did all that several times, except for flashing the latest twrp version. I'm on 3.0.2-2 because it flashes ok but when rebooting it's back to 3.0.2-2. I'm doing this from fastboot. I'm not only loading, but flushing. It seems to be ok but then it's gone after reboot.
Anyway, I've tried this procedure with 3 different roms:
ResurrectionRemix
LineageOS
Nitrogen OS
flashing latest versions for each rom.
Could the twrp not updating properly have something to do with this issue? does the latest version fix some flashing issues with Nougat?
the thing is that if flashed and boots, but it doesn't run properly as mentioned.
I will try to get latest twrp version working and report back if that makes any difference.
VaibhavKumar07 said:
On Cm firmwares I was unable to get VoLTE working so recommend you to flash Miui beta firmware search in SD Rom or guide section you'll find em if not message me again .
Regarding procedure :
- First flash Twrp 3.1.1.0 from official site cuz that's latest
- Next go & wipe check everything except SD card & OTG
- Flash Firmware
- Flash Rom
- Flash Gapps Arm *64 Android N from Open apps
- Flash Any Add-ons if required like kernel or Sound enhancement mods ( optional )
- Clean cache/dalvik cache
- Reboot
Mention the Rom you're flashing!
Sent from my Redmi Note 3 using Tapatalk
Click to expand...
Click to collapse
so, still fighting with this.
i managed to upgrade to twrp 3.1.0-1, all good.
however, i still have the same problem with the initial screen, it keeps reloading every few seconds and can't finish the setup or even skip it.
i've tried different versions of firmware. I've also tried flashing the latest miui rom (dev and global) and then a custom rom.
i've tried different builds (different dates) of the following roms:
nitrogenOS
lineageOS
aospextended
mokee
resurrectionremix
exact same behaviour with all these roms.
what am I doing wrong? i'm on marshmallow and everything works fine, but stuck moving to nougat. do I have to flash something not mentioned already to move from custom MM to custom Nougat?
txutxe said:
so, still fighting with this.
i managed to upgrade to twrp 3.1.0-1, all good.
however, i still have the same problem with the initial screen, it keeps reloading every few seconds and can't finish the setup or even skip it.
i've tried different versions of firmware. I've also tried flashing the latest miui rom (dev and global) and then a custom rom.
i've tried different builds (different dates) of the following roms:
nitrogenOS
lineageOS
aospextended
mokee
resurrectionremix
exact same behaviour with all these roms.
what am I doing wrong? i'm on marshmallow and everything works fine, but stuck moving to nougat. do I have to flash something not mentioned already to move from custom MM to custom Nougat?
Click to expand...
Click to collapse
Try this once (Clean) :
Flash Nitrogen
Reboot
Flash gapps and firmware.
Hope it may work for you.
Hey guys,
Googe play services keeps stopping
android.process.media keeps stopping
bluetooth keeps stopping
at the first start (google register)
I tried: 2 different roms: mcaosp + pixel, newest gapps (nano), flashed data, cache, dalvik + system
Do you have any solutions/ tipps? I want to try pie
Greetings
I had this problem too, tried all variants of gapps, bitgapps. All variants of twrp, all pie ROMs and same error. You can try and see that if you create a second user in the phone, suddenly all works perfectly.
tl;dr:Just try crdroid ROM, the one worked for me on the owner user
Flash the ROM first without gapps then boot normally.Turn off phone,go to TWRP and then flash GAPPS.
Had this issue many times and its quite annoying.
Thanks for the answers. I tried this 2 times ;(
It just dont work with your tipps. I will go back to oreo until I get news about this
no fix yet ;/
Flashed all except usb otg + sd card, installed firmware 9.6.2 and tried syberia + arrow rom. (Followed the install tutorials)
Android PIE dont like me ;(
EDIT: Got AOSP Extended to work but now it searches for updates since 10 minutes. (I have good wlan <.<)