hello there,
i have a sony z2 .. i unlcked it then while i'm flashing it i've done something wrong that i don't really know what it is !
i followed the instructions then i downloaded a file on my phone so it can go to recovery mood
so eventually the phone keep rebooting !( it start .. then SONY logo .. then crashed then reboot again )
and i can't reach any data on the phone !
considering that it can not be charged while it's not booted ! ( when you plug it in it start immediately)
so i tried to flash it again but i couldn't because some steps has to be done while the phone is on !
i tried xperia companion pc ! but it didn't help me it said that my device is unlocked !
so i'm stuck in here !
is there any solution ? ??
my phone is rooted *
Related
Hi, I have problem whit my phone i unlocked bootloader, and after it i tried to root it , but when i tried to turn it on it get stuck at sony logo and nothing happend i waited for like 30 minutes and nothing, I can't enter flash mode or boot mode because my phone doesn't recognize holding button and PC doesn't recognize my phone too. Is there any solution to fix it ? pls help :crying: . Sorry for my bad english
you should've asked that question here But anyways, flash a generic firmware with flashtool and see if it works
Hello friends
This is my first post on xda so please correct me if Im wrong anywhere..
Im newbie to flashing and rooting android and three days back I decided to port a custom rom on my Xperia P.
I was succeeded in porting a custom cm based ics rom along with custom cwm recovery...
But then I found another rom MoonBreaker 3.5 for Xperia P and tried to install it,
I have flashed system data cache as instructed and flashed a stock JB kernel but then due to my fault I mistakenly disconnected my phone �� and now my phone reboots but stuck on Sony logo ( as there is no os i think so) so i tried many times to hold power+vol up for force restart and tried to put it on fastboot mode by connecting it to pc holding vol down but now my phone even don't show up in device manager and after 5-10 sec that blue led goes to red and again Sony logo comes up.......!!!!!
I even tried to force restart when attached to pc and tried to put phone in fastboot mode but my pc wont detect it anyway.... ��
I have already installed all the drivers for fastboot and flashboot before successfully but now pc wont detect it.......
Please please help me what to do so that i can boot into fastboot and flash old rom or even official stock rom........ I just want my phone back..... ��
And if i have to take it to service center then how much they charge me to install software........
Thank you all guys please help me.........
i have the same problem on the same phone and i used the same custom rom please help us
hi everyone i got xperia p not used from long time nw want to use it again but when i tried to switch it on it stucked on logo screen and by the way it was custom rom now whatever i do cant connect it to flashtool and aslo not reading with adb (was reading but it stopped and now dont ) help plz ..... aslo i can enter cwm if it helps and thx
Help needed !! Xperia U "DEAD"
Is there anyone who can help me with my xperia u ? My device got dead when i flashed CM11. After flashing i won't turn on. At first it wasn't starting up (not even the sony logo but only vibrated) but i was able to get into fastboot mode & flashmode. As it was not starting up, i left it for charging for few hours. But after that it became hard brick. Now i can't even get into flashmode or fastboot mode, it wont even vibrate !!
PS: Charging led seems to be working F9 !!
Anyone ?? Please help !!
HI
i have a amicom nyx from a friend ( mt6572 )
At first the phone seems to boot loop . the android logo show sometimes. but never fully boot .
In a windows machine it usb detect then disconnect then connect then disconnect in a loop. most of the time the logo doesn't appear.
its very hard nearly impossible to to access the recovery menu to do a hard reset , ive been there once or twice but the phone reboot on me
i manage to flash it whit the firmware . whit an old version of sp flash
but after a 100 % successful flash i am exactly and the same status.
is it a defect button ? or a virus ? or else. i am a little lost now.
Thanks ....
anonyone ,,, i m out of idea