I'm having a bit of trouble with this. I've already been through NMaverick's guide, to very limited success. I was able to flash an older version of my firmware with SP Flash Tool, and get TWRP flashed and booted into recovery, disabled encryption, and installed Magisk. My screen is flickering, so I don't want to leave it like this.
Does anyone have any advice on how best to move to the newest firmware without losing TWRP/root?
Just to add: With my most recent firmware available, the screen doesn't flicker, all the stock functionality appears to work fine, but I can't boot into recovery. When I hold down Volume Up, the phone acts like it's stuck in a boot loop. I get a green line across the top of the screen after the boot logo, and then it tries to boot again. Letting go of Volume Up results in a normal boot to the OS.
Hello everyone, where I can find this version for the 3T or if someone has it in Backup, it is very important for me to find it:
CQ3060MF2_AGS32_Armor_3T_20181107_V01
Thank you
Related
Hi.
I bought a Lenovo tab 3 7 Essential (TB3-710F, MediaTek MT8127 chipset) to use as a car computer.
First, I unlocked the bootloader using fastboot, which worked like a charm. I then downloaded the stock rom for the tablet and modified the "logo.bin" using logobuilder to get a desired splash screen. Before flashing the modified stock ROM, I tried to install a compatible version of twrp using fastboot. The installation succeeded, but the tablet only booted into stock recovery instead of twrp. Stupid as I was, I deleted the original "recovery.img" in the downloaded stock rom folder and replaced it with the twrp.img file renaming it to "recovery.img", convinced that this would fool the tablet to boot into twrp instead of stock. I then flashed the modified rom using sp flash tool. The process went through and as a result, the tablet didn't show any sign of life at all. Only a black screen. I assumed the tablet was hardbricked, so I tried to flash the unmodified, original stock rom again. This time the Lenovo splash screen showed up, but before proceeding to the boot animation, the tablet only ran into a bootloop, not going any further than the splash screen. I tried to boot into recovery to reset to factory settings, but all kinds of key combinations; Taking out the battery, re-inserting it, pressing power + Vol down + Vol Up, And also only vol up and down with power, neither seemed to work. For now, I have tried all the stock firmware I have found, but they all run into the same bootloop. I am really stuck for now, and I can't find a way to get past the bootloop or into recovery. Any help would be really appreciated.
Thanks in advance.
Hai, i also facing the same problem. Keep restarting at Lenovo loading
cikgutan said:
Hai, i also facing the same problem. Keep restarting at Lenovo loading
Click to expand...
Click to collapse
I eventually ended up buying a new tablet as I couldn't find any solution. I assume these "cheaper" mediatek devices aren't the most popular for such rooting purposes. Anyhow my problem was not with the rooting process, but rather trying to replace the splash screen boot logo. For rooting I used kingroot directly on the tablet. Had to run it a couple of times but it worked eventually. If you want to use a custom boot logo I recommend that you don't try to replace the splash screen logo, but rather the animation after, as this can be done directly on the tablet using a file manager. I just had to live with the first Lenovo logo and to be honest it didn't really bother me at all.
Hi All
I have a ulefone power 3 which isnt modified at all , my problem is its stuck in a boot loop and not sure what to do
when i hold up and power and go into recovery it just keeps rebooting so cannot do anything, kinda new to any kind of flashing but does anyone have any ideas on what i need to do please
thanks
I think you need to flash your phone like this : http://ulefone.com/download/power3.html
same with power 3s
UPDATE: It was possible to flash the phone, but now i have some "shifted" lines on my display
UPDATE2: After performing an wireless update, everything works fine again (without twrp)
Hi, I have the same problem,
Ulefon Power 3s, after i tried to install twrp (everything worked like in the deskription at https://forum.xda-developers.com/android/development/ulefone-power-3-twrp-3-2-1-0-root-t3741853)
The phone is stuck in a bootloop (Orange State like https://img.xda-cdn.com/2fPFK8gGwJxzn2rNTC6VzDxvLI8=/https://i.imgur.com/tLOV7sz.jpg?1)
When i press the power and volume up button the screen stays black and the phone still stays inthe bootloop.
Right now I am not able to stop this bootloop.
My tools are also to big to disconnect the batery.
I am not able to connect with my computer at this time.
I asked the smae at the twrp thread.
Any suggestions?
Thanks!
Hello i have the same problem i think this version of twrp do not work with the lastet firmwares from ulefone. I think the twrp have an issue with the rom version v40...
I also stuck in the bootloop and the only thing that i could do was a new flash...
I installed stock Android 10 Q (from 9 P) via Odin on my galaxy tab s6 LTE, then i unlocked the bootloader and rooted with magisk (manager 7.5.1, zip 20.4) following the magisk git site installation instructions (which are a bit more complicated than from some third party sites.)
Everything ok, but then when i power off it reboots. It's not in a bootloop: it boots up normally, but if i can't power off then that's not good when I'm not using it. I tried patching again and checked i got the the same md5.
Eventually i found that if i booted to recovery mode and there i choose reboot, it reboots to unrooted, but it does power off.
To get root access again i start with the recovery key combination but let go at the splash screen before it enters stock recovery mode. This means that i have to reboot each time i want to either switch it off or have root (but not both.) It's good enough for now, so I'm posting this in case anything else has the same problem.
HI,
I inherited this phone. ( D6503 )
Fixed a few hardware problems, now looking at software improvements.
I have unlocked the bootloader , but for the life of me I cannot get a recovery on this phone??
I have previoiusly done flashing on nokia, motorola and Nexus, but I am having no luck with this sony
I am able to connect using ADB, and can get to fastboot, but it stops there.
Issuing '' fastboot boot twrp.img'' ( to try and boot temporarily to twrp ) gives me a blank screen.
issuing ''fastboot flash recovery twrp.img'' does the same.
I cannot get a bootloader screen at all, even using the key combinations.
I cannot boot any recovery at all.
Is there someone here who can put me out of my misery
I am not looking to perform anything fancy, I just want to flash the latest lineage to see how it performs
Many Thanks in advance.
pootler.
Anybody???
I have rooted the z2 by dropping down to 5.11, installed the twrp app, then flashed recommended version of twrpl
Then when I power off the phone, and press the power and volume down buttons, instead of booting into twrp after 7 or so seconds, it just reboots after abour 2-3 seconds???
Can anybody help?-------please
I have even tried rooting , then installing twrp by either 1) fastboot or 2) twrp app.
I then installed NDR utils, to reboot to recovery - it still reboots to main system??
HEEELLPP !
I also tried flashing TWRP with 1) fastboot and 2)the twrp app,
I then installed NDR utils ( i have root ) , and it still wont boot into recovery, just straight into system???
HEELLPP!!
Thread closed on request of OP @pootler
Hi Community,
I read some posts how to fix my Problem, but i cant go to a service Point.
So I was using the Evolution X for a long Time (Installed with TWRP 3.1.0).
And now i wanted to change to the Nusantara Project (Vanilla), I did a clean Flash, everything worked i could access the System.
Than i had problems installing Play Store, so i rebooted into Recovery via the System. But now im Stuck in the Loop.
Can i Somehow connect my Phone to the PC and Reset?
Can someone tell me if i Hard/soft bricked my phone ?
Just a little advice, would be really appreciated.
Thanks a lot
Go to TWRP, wipe system, cache, data and dalvik. Now flash nusantra and whichever GApps are recommended for it (if there are no recommendations then use OpenGApps, make sure the architecture is correct). Now wipe dalvik and restart. Sometimes, certain roms begin to bootloop if you boot into the rom first, then try to install gapps later.
If you still have issues, just reflash the stock rom.
I cant access the TWRP anymore, im just stuck on the Bootloader, no matter how i turn on The Phone (Volume Up + Power ON ), (Volume Down + Power), (All 3 Buttons)
Nothing works anymore i dont understand ....
Im searching the net but i cant go to fastboot or something else, its just keeps on rebooting ...
So it's bootlooping, but you cant access recovery?
When the screen turns off, press the key combo and it should go to recovery.
Your best bet is to take it to a service centre, but if that really isn't possible for you, then wait for its battery to drain completely, then when you plug in the charger, instead of turning the phone on, press the key combo to enter the recovery. From there, wipe and flash some other OS.
I've also heard that certain versions of TWRP don't support some roms, leading to a bootloop. In that case, you'll have to use orangefox recovery to flash the rom (orangefox is flashable via twrp)
Yes its Bootlooping.
When i turn it on, on the Left Corner "Recovery Mode" blinks for one second. Than the usual Text appears:
"Orange State
Your Device has been unlocked and cant be trusted
Your Device will boot in 5 Seconds".
So after a couple of seconds (around 10-20 sec)
It turns off and immediately on again. I Just can turn it OFF when i hold all 3 Buttons.
Than i try starting it with Volume up + Power / Volume down + Power, But i cant access Recovery or TWRP.
So i should wait til the battery gets low and try it again ?
Like i said, my custom Rom (Evolutionx) and TWRP just worked fine. I dont know man ...
Well since your bootloader is unlocked, try flashing the stock rom again. Look for a tutorial and follow it.
Hi I managed to unbrick my device with this guide, and im back on a stock rom
Unbrick
i ran following commands to get to my custom rom:
I run adb reboot bootloader,
add executed following commands.
(Pitch Black recovery 3.1)
- adb reboot bootloader
- fastboot flash recovery recovery.img
-fasboot reboot recovery
It just hang up and booted after a while into the normal system.
But im not able to get to the recovery menu ?
When I restart and hold Volume up + Power, i go in a loop and the phone keeps restarting over and over again.
what have i Fu**ed up ?
Do i need another recovery tool ?
sorry guys, i appreciate your help a lot tho !
EDIT: Is my bootloader unlocked ?
I can access via "adb reboot bootloader" the phone
and on the blackscreen on the phone it is written:
oppo verfiy pass
fastboot_unlock_verify ok
Update:
So i tried some Stuff and i got Red State. No Problem i Unbricked it once again and now im on Stock Android 10.
Now im Trying to enable the bootloader again.
I downloaded the In Depth Test_Realme_6.apk but i keep getting the Error that i should update the system.
So should i update the system ?
I cant find a CURRENT Tutorial to make this work, please help...
If you cant find a tutorial for your version, why not downgrade back to a previous one if possible.