Hi All,
I have an XDA (not ii) and trying to connect it to the rikaline gps 6010-x5.
For some reason the XDA does not recognize the GPS.
I instaled al drivers and did as instructed by the manufactorer.
Can someone help me with this issue?
Doron
i would start with making a search for
rikaline 6010-x5
and read some of those many posts about peoples exp with that gps reciever
Related
Hi, Can one of you lot help me out 'Again' :lol: Ive got a FUjitsu Siemens S6120 Lifebook with plugfree bluetooth software installed, when I try and connect to my XDA 2 (WM2003 2nd) I can only get the following services available : Dial up networking , Service Discovery and voice gateway.
I cannot seem to get a 'bond' with the XDA, I know that bluetooth is working as I tired my HP PDA and that connected via a serial service.
Very fustrating, anyone got any ideas ?
Many thanks in advance ! James
Can anyone tell me if TOMTOM 5 is compatible with the XDA?
When i say compatible, i dont mean will it install etc cos ive actually managed that no problem. What i mean is, has ANYONE found a GPS reciever that works with the XDA and TOMTOM 5 ? If so what settings did you use?
I have a RIKALINE GPS reciever, and TOMTOM 5. Ive tried what seems for ever to get the god damn thing working but no matter what settings i use, the TOM TOM 5 software refuses to acknowledge that i have a GPS reciever attached or even a signal.
I know the RIKALINE GPS reciever has a signal since ive watched the procedure it goes through in order to obtain it. I know what BAUD rate the GPS reciever needs, but i dont actually know how its connected to the PDA. Ie COM 9:, Serial Cable on COM1:, Serial on USB or Serial Cable on COM2 ?? I have tried them all but to now success. SO does anyone have a TOM TOM 5 installation guide or some information on what i should try next. Anything anyone can give me will be much appriciated. I really dont want to go back to TOM TOM 3 (which i have had working with all the above equipment)
Thanks in Advance
Hi there
Yes the XDA is fully compatible - but there are also conflicts you need to be aware of.
Go to START/SETTINGS/CONNECTIONS - select "BEAM" option - make sure that the box is UNCHECKED - as the infra red beam conflicts with the receiver!
On the TOMTOM program set the GPS receiver to TOMTOM CABLE GPS & away you go!
Let me know if you still can't get it working.
You'll need "Serial Cable on Com 1" Use Other Cable GPS receiver and set the baud rate and it should work once you've disabled the beam
Hello,
Is anyone know how to turn the Titan into a GPS gateway?
I found that the screen on the Titan is very small. I happens to have an iPAQ with bigger screen. I want to use the iPAQ as a GPS.
The problem is, I have loaded the GPS program on the iPAQ but was unable to obtain a Com port connection using the BT from the Titan.
Thanks
I believe gpsGate will do the trick for you.
http://gpsgate.com/index.php?id=14
Thanks for the quick reply.
I have downloaded and trying to configure.
I have no luck of getting the Titan to share the GPS over the BT connection.
Anyone know if there is any way?
Thanks
Hi,
First of all, i am new to this site and this is first post of mine, my problem is that I have HTC HD2 and i am unable to connect with External GPS Receiver which is Qstarz BT-818 and Destinator 9 Software. i need help from you experts in step by step manners so as to integrate destinator and Qstarz with HD2.
In fact, i tried several time to configure ports unfortunately i fail to connect it, the same procedure i did it with my omnia i900 it is working fine, but HD2 may have different procedure.
I need it badly thus anaxiously awaiting experts advice on this post.
Thanks and regards
hrd
No One Understand How to Fix it???
It is uttersurprise that no one has solution for this issue, strange. OK i will try on some other sites.. Bye Experts
I am not up on GPS, but if you are using external GPS instead of HD2 GPS, most modern GPS units use bluetooth, and you could try to pair both up via bluetooth.
i have a program that relies on constant gps location but it wont connect to the gps on my i9000 is the gps routed to programs via "com" ports? if so is there a way of finding out what port its on and if i can find out what port the program uses?
its not that the gps isnt working cause it works for all other apps that use it, also i know the app uses gps exclusivly not the getbestprovider() function im just wondering if getting the gps info is different od different devices or does the os talk to the hardware then pass on the data to the app?
melli.
can anybody shed any light on this issue please?
Questions or Problems Should Not Be Posted in the Development Forum
Please Post in the Correct Forums
Moving to Q&A