Hello everyone.
I have a problem with my G4 from Vodafon Germany.
I woke up this morning and it was stuckd up. I did a soft reset...denn came the Bootloader and it stopped there.
The Bootloader shows:
IPL 2.21.0001
TPL 2.21.0001
I tried to flash the ROM from Vodafone Germany ROM-Version 2.21.3.1from here: http://www.vodafone.de/hilfe-support/technischer-support/97016_93771.html
It says 100% success, then Congratulations, the Phone starts up again and it is again stucked up in the Bootloader. It still shows only:
IPL 2.21.0001
TPL 2.21.0001
What should i do to get it working again?
Please HELP
Stefan
Problem solved.
I just took the Battery out for 5-10 Minutes.
It works now with the WIZ LOVE Rom.
I'll install TNT later.
bye
Hi
i have the same problem
but that battery trick wont work with my cell phone
i really dont know
but i dont have it flashed right.
because with the exe files of ruu's and more of them
he wont go furhter than 0%
it says device not detected no response, because when i launch the exe files
active sync will just lose connection.
after this i get this same bootloader problem
regards
R.G
Related
Hi all,
I've tried to flash my phone with RRU (underground edition crossbow.exe), update said everything ok, it started to upload new rom into phone, but at 96% it stopped with error 302. After passing the recovery process it boots just into bootloader. Tried to run again, the same.
Screen shows:
IPL 2.17.0001
SPL 2.17.0001
ActiveSync v. 4.2
Phone was unlocked (was showing Vodafone boot logo, but I've used o2 simcard without problem)
Obviously don't know if phone have CID locked or not.
Thanks for any advices
--------------------------------------------------------------------------------
mine is a G4 device IPL 2.09 SPL 2.09.0000
i flashed several times my prophet with diferent wm6 roms but i allways downgrade to wm5, cause some issues i didn't like,
this morning i tried to upgrade to wm6 again, made the procedure
1 Hard reset
2 connect to pc and wait to activesync to come up
3 run upgrade utility and wm5 flash started
after a while the upgrading process stucked at 5% and gave an error, i don't remeber whitch it was,
but since then my prophet always turns on in bootloader mode, you can do nothing, even turn it off, the only way to turn it off is removing the battery,
when you put the battery again and press power on it starts in bootloader mode
the diference that i notice it's that now the bootloader shows
IPL 2.09 and SPL 2.09 not anymore SPL 2.09.0000
so i tried again to flash the prophet but it always give me this errors
300 when i used the wm5 spanish rom
and 274 conection problem when i use the temp pdaviet rom or the fantastic mobiz rom
when i plug the prophet to the pc the bootloader displayes USB but activesync never starts
what could be my problem i used the correct G4 roms
please somebody help me
First u dont have a G4 device....
See
http://wiki.xda-developers.com/index.php?pagename=prophet_g3g4_how
Second i think u flashed ure phone death cause of the wrong rom version (G4 instead of G3)
hi,
i think he does!
G4 is *.000X
G3 is *.000
I had SPL 2.09.0000 too, and used the G4 upgrade utility to wm6 and worked good.
regards
RP
tropheuz said:
hi,
i think he does!
G4 is *.000X
G3 is *.000
I had SPL 2.09.0000 too, and used the G4 upgrade utility to wm6 and worked good.
regards
RP
Click to expand...
Click to collapse
well since his device is not working i think he didnt
i have .0000, been flashing G3 all my life...
During th eflash of my rom radio with 1.54.00.10 the program stopped and my mobile restart in bootloader.
The problem is that the flash program doesn't want to restart flashing and my mobile stay on bootloader menu.
HELPPPPP Please..
What do you mean by "the flash program doesn't want to restart flashing"
Did you try to flash your original shipped ROM entirely to the device?
What is IPL/SPL on your device?
Sorry for my english...
I flashed with RUUWrapper.exe on my PC with usb connection but during the verification the soft said me error 260 the device not connect.
Is there a possibility to flash the rom radio without PC, directly on my mobile ?
Thanks
on the bootloader screen :
HERM200
IPL-1.04
HERM200
SPL-2.03
Looks like the FLASHING TOOL is not compatible to your device! What OPERATING SYSTEM are you using?
I am not sure if your device is already CID unlocked?
If you run on XP and your device is CID unlocked use the CustomRUU (search the forum), if not: read the WIKI!
My device is unlocked and I use wwindows XP
How can I flash with serial?
this is what you get for not flashing Hard-SPL. idiot
I'm ok but how can I do?
please...
HELLLP (ive been upgrading since the xda II) and i recently got a tmobile hermes with wm5! then got wm6 upgraded it and got to about 78% and my pc died and then i tryed recovery did not work had to go to work so i left it! got back and ive tryed so many more upgrades of the image with no luck its stuck on splash screen! ive placed it into bootloader mode then ran ruu wrapper and it gets to the bit of updrading (25mins and a progress bar) and the phone goes white with upgrading image 0% then on the pc i get error 262!! and thats as far as i got please can some1 help thankyou so much
here is all my information that ive got!
bootloader mode = herm300 IPL -1.01 (in white text)
Herm300 SPL - 1.04 (yellow text)
when i restart the phone and its stuck on bootloader mode this is the info
m 05 - r 1.05.05.00
s 04 g 32.36.7010.04h
b 06 d 3.62
please can u ask as many people as you can ive known about this since the xda II days but never needed help and i know some1 can help this is a great website and forum thanks
hey, im new but have read many of the pages here. i have burnt roms to my first wiz (G3) unlocked it and everything went well. i came about a wiz (G4) last week wm5 bland rom locked and want to get wm6 on it so after my research i went to the IMEI unlock site and purchased the unlock for the g4
the unlock seemed to go well the first time but, it won't come out of boot loader mode
i ran hornet o.10 for g4 it runs and completed to 100 % and then on reboot it comes up with the boot screen again
IPL 2.21.0001
SPL 2.21
i ran the tnt 1933 rom this morning and it completed 100% but still i have a boot screen
i know im missing something the battery power is fine .
i downloaded the stock rom for cingular but it won't load it has error "(294) INVALID VENDOR"
any suggestions ...
thanks in advance for your input
Airborne_Pathogen said:
hey, im new but have read many of the pages here. i have burnt roms to my first wiz (G3) unlocked it and everything went well. i came about a wiz (G4) last week wm5 bland rom locked and want to get wm6 on it so after my research i went to the IMEI unlock site and purchased the unlock for the g4
the unlock seemed to go well the first time but, it won't come out of boot loader mode
i ran hornet o.10 for g4 it runs and completed to 100 % and then on reboot it comes up with the boot screen again
IPL 2.21.0001
SPL 2.21
i ran the tnt 1933 rom this morning and it completed 100% but still i have a boot screen
i know im missing something the battery power is fine .
i downloaded the stock rom for cingular but it won't load it has error "wrong update utility"
any suggestions ...
thanks in advance for your input
Click to expand...
Click to collapse
Are you sure SPL is 2.21 and not 2.21.0001 as IPL 2.21.0001 ?
Well,if its 2.21 only,the phone's got mixed Bootloaders (IPL/SPL),IPL 2.21.0001 are G4 and SPL 2.21 is G3,I don't know how you got it,but your phone is 'Bricked'
mmm it figures
so it appears there could be a problem with the imei program,
as i said it never came out of boot mode after the unlock
and no errors were shown ...
i could get another and replaced the main board, this one is in new condition
except for the custom bricked rom . in the future i will not play with a g4
thanks for the diagnosis, no way to flash a new spl / ipl ... i did read that if
it booted you could get it back in some chance cases .. i am curious as to how this happened (others not doing this for a hobby could brick there only phone)
step 1 - ran imei unlock
never came out of boot mode after
2- flashing the to above roms said to be G4 safe
i never look to see what the ipl / spl were before
i looked with the wizard tool but didn't save it
well you live and learn, it's good for parts now off to ebay for another crack at it ...
thanks everyone ... the best thing about this phone is everything you can do to it
with help from those who know ...
I recommend trying to flash back to original service provider ROM, then unlock again and try another. As long as you can get to bootloader (tri-color screen), there's still hope for your phone. When it's in this mode, and you plug in the USB, does it say USB at the bottom of the phone screen? If so, you are not dead yet.
Custom build wm6 roms like TNT etc... never Brick a G4 phone as no IPL/SPL is included in them,they are completely safe for G4 devices.What I can gather,it must be the wrong imei unlock code perhaps.
Well,like Myrddin Wyllt said,there's no harm in trying,so if it gets into Bootloaders,try to flash the official rom and if there's an error "wrong update utility" ,replace the RUU in the rom with this RUU and run this RUU,hope it might work.
Myrddin Wyllt said:
I recommend trying to flash back to original service provider ROM, then unlock again and try another. As long as you can get to bootloader (tri-color screen), there's still hope for your phone. When it's in this mode, and you plug in the USB, does it say USB at the bottom of the phone screen? If so, you are not dead yet.
Click to expand...
Click to collapse
yes sir i can talk to the phone from xp pro ..
USB does come up
so i can swap the RRU with the nbf file i need ...
no file name change required on the xxx.nbf file
thanks alot for the(schooling) advise ... i was going to need to brick another to make some book ends... this could save me that
stuck
Airborne_Pathogen said:
yes sir i can talk to the phone from xp pro ..
USB does come up
so i can swap the RRU with the nbf file i need ...
no file name change required on the xxx.nbf file
thanks alot for the(schooling) advise ... i was going to need to brick another to make some book ends... this could save me that
Click to expand...
Click to collapse
ok, i swapped out every RUU i could find i get errors from
read file
invalid vendor id
wrong update utility
im too new to figure this out ..can you extract a ipl / spl from an
official rom and then flash that to get the boot loader's back in sync
i found the att 8125 ipl /spl nbf when i flash, it runs to 100% reboots but no changes
anyone have a link to flashing just the ipl / spl on the g4
i am most thankful for any advise ..
try running the hardspl on phone, it might just work to revert it back to a G4 spl.
Link to HardSPL : http://forum.xda-developers.com/showthread.php?t=332320
and G4 ipl and spl here : http://forum.xda-developers.com/showthread.php?t=342744
Also I paid to the IMEI Check and I had to change the plate because the PDA died as yours. E had not returned to the money of the IMEI Check only reply to me was that it had to change of plate ..... It had the unblocked CID?
bastards
yes they won't return my money ... somehow they bricked my phone
i would use the hard /spl and not the imei those guys are assholes
Crazy as it sounds i can't find any info about flashing this device
It's stock, but I'd like to flash HardSpl and unlock it if possible..?
Bootloader says:
Niki200
Spl 1.16
Can anyone help please!!
Edit
Alright, i see some users with HardSpl 1.22 flashed to there devices. How do I go by doing that, I've downloaded the file but when I try to update it via the data cable it just freezes at 0% for 2 minutes and nothing happens...?
Any advice..?
Now this is what I was looking for, great work!!
http://forum.xda-developers.com/showpost.php?p=4653286&postcount=605