Here's the extracted radio 1.21 from Imate JasJam's 1.31.305.2 ROM.
HERM_1.21.31.10_type2_radio.rar
Remember:
- You need bootloader 1.04 to upgrade to a extracted radio ROM
- screen will show "Upgrade Radio Stack Please wait........."
- after finishing flashing radio (about 15 min) you will see an "Upgrade Error", but the radio ROM will be flashed anyway.
- no need to hard reset after upgrading the radio, only soft reset with stylus when upgrade ends.
- upgrade at your own risk, i take no responsibility for anything that happens to you, your Hermes, your marriage, etc.
For more information see the extracted radio wiki page.
Enjoy!
thanks machine for all
OK, I flashed this Radio ROM into my Hermes
Well, guys, I 've already flashed this Radio ROM into my Hermes.
The procedure itself worked as usual. Radio version before update was 1.20.31.10.
Device booted up after flashing successfully
At this moment I don't see any difference between 1.20 and 1.21 versions.
[HELP]
What is the better radio ROM for Tytn ???
I have the one with the 1.35 ROM
Radio rom : 1.18.0.10 !!! But I think we can find better !!!!!!!
tell me what do you think about this
bobstarina said:
Well, guys, I 've already flashed this Radio ROM into my Hermes.
The procedure itself worked as usual. Radio version before update was 1.20.31.10.
Device booted up after flashing successfully
At this moment I don't see any difference between 1.20 and 1.21 versions.
Click to expand...
Click to collapse
bobstarina: now you need to update your signature
Thx...upgraded succefull...after downgrade the Bootloader from 1.06 to 1.04..then able to upgrade.....
Didn't see anything special...hehe...
I have flashed Bootloader 1.01 MFG on my vodafone 1605, with this bootloader, i successed flash voda french rom, htc 1.35 rom and Dopod CHT rom, i flashed bootscreen too.
but i didn't find any method to flash a Radio rom, there isn't explication in Wiki neither in thread.
can you tell us pof, how to flash a radio rom with a Bootloader 1.01 MFG, please!
thanks at first
@googoo no way to do this directly with 1.01 MFG yet. Essentially, the process is this:
First flash a 1.04 bootloader using 1.01 MFG. Next, flash desired radio. Then flash back to 1.01 MFG.
detail on these steps are in the Wiki
@qooqoo: sorry I forgot to add it in wiki, i thought it was obvious, but you're the second person asking this, so I added it to the wiki now. Thanks sleuth.
thanks Sleuth255 and pof.
I think I made a mistake... I'm using SPL 1.09 and I didn't even realise... It says its upgrading radio stack!!! Whats gonna happen???
I've upgrade to this ROM to test it...
BTW: I ve updated the wiki with the Protocol Version installed with this radio: 32.53.7020.01H
Test?
Can anyone post his experiences with the new Radio ROM?
Well I am using 1.20 and sometimes the device freezes while receiving a call. I am not sure if this is Radio ROM related and I am not sure if I should now upgrade to 1.21 or downgrade to 1.16
TyTN is a German T-Mobile MDA Vario II, it came with a 1.03/1.06? Radio ROM.
Edit: Will try with 1.16 now - but a 1.21 stability report would be appreciated..
@Applestar:
My Jasjam which is a HT647... came factory installed with this new ROM which is now available at the imate website (www.imate.com):
ROM Version: 1.31.305.2
ROM Date: 8th September 2006
Radio Version: 1.21.31.10
Protocol Version: 32.53.7020.01H
Ext ROM Version: 1.31.305.104
Bootloader Version:1.06
The problems I faced with this original ROM was that the Radio would freeze abruptly without any apparent indication. The GSM signal showed full bars but I could not make a phone call. Similarly when someone tried to phone me he would get an indication that my mobile is switched off. Other than this the PDA would continue to function normally and therefore no warning that the Radio has stopped functioning till I needed to make a phone call. I could not establish a pattern when this occurred but it would definitely occur once or twice a day. The only way to restore my radio to working condition was to switch to flight mode and back or a soft reset.
I then downloaded the ROM which was available at the i-mate site (www.imate.com) at that time i.e. on 9th January 2007. The ROM that I downloaded was definitely older than the one which came preinstalled on my jasjam and is detailed below:
ROM Version: 1.20.305.3
ROM Date: 21st July 2006
Radio Version: 1.07.03.10
Protocol Version: 32.41.1010.02H
Ext ROM Version: 1.20.305.104
Bootloader Version:1.04
Ever since I have installed this ROM the problem of the Radio freezing is gone for ever and now I am absolutely satisfied with my investment.
Furthermore I have not experienced any adverse effect of the older ROM. The free RAM is the same for both ROMs, I do not see any difference in signal strength or battery life either.
I would be interested to know from members who have recently downloaded the the ROM if anyone has noticed the Radio freezing problem
Kind Regards
ok, thanks the operation is correct.
I've finished the testing of this 1.21.31.10 Radio ROM.
I used to use the 1.20.31.10 ROM and this is the comparation of this ROM with the new 1.21.31.10 ROM:
- Under GSM and UMTS the time to register in the network as the coverage is the same in both ROMs. I haven't noticed any difference while talking and receive voice calls.
- But THE PROBLEM is that the data calls are broken in this ROM. I used direct Modem connection with my work (we got two 56k Modem waiting for incoming calls). It connects without apparently problems with the modem (maybe it takes more time than the older ROM) but the data interchange is very sloooooooow and suddenly it stops! The data call isn't dropped but it doesn't interchange data after two or three minutes of slooooooow interchange. Finally, if you close the call and tries to reconnect it can't!!!! WM5 says that an unknown error happens and can't be connected!!!!
After a soft reset you can connect again but it remains very sloooooow...
Fortunately I've switched back to the old and stable 1.20.31.10 ROM and everything works normal now (thank God!).
So, my final advice:
DON'T USE THIS ROM!!! IT LACKS DATA CALLS BUT WHO KNOWS WHAT ELSE IS BROKEN!!!
My recommendation: 1.20.31.10 ROM.
Best regards.
I recommend: Radio 1.07.03.10
With this Radio I had very good signal strength. Better than Radio 1.18.00.10.
I think newer Radios aren't better to lower the SAR-Level.
I am having a very positive experience with this ROM. While I doubt there is any way to explain this, but after I installed it, I was able to use the Microsoft Voice Command through the BT headset and the hack that is provided in a different discussion group. Using 1.20, that hack did not work with my device. Otherwise, I see no difference.
One new feature provided by this radio ROM as compared to the one in the previous JASJAM WWE version:
Automatic date/time and time zone synchronization with your GSM operator.
There is a new properties tab in Phone properties where you can enable/disable this feature.
PAPPL said:
I recommend: Radio 1.07.03.10
With this Radio I had very good signal strength. Better than Radio 1.18.00.10.
I think newer Radios aren't better to lower the SAR-Level.
Click to expand...
Click to collapse
Do you know which radio ROM has the lowest SAR level?
Only one short question! -Only one short answer! ;-)
I´ve flashed my hermes to the 1.35 radio rom. Now iam getting these ****ty
radio waves signals out of the hermes´s earspeaker . And it is possible that i have to send in my device, because i have several problems with sending sms. Because of these things it would be very nice if it is possible to flash back to the shipped version of the Radio Rom(1.27.00.00)
I tried to flash back with
RUU_Hermes_TMD-TMA_Radiopatch_1.27.00.00_107_GER.exe
and it completed succesfully but on the hermes is still the 1.35 Version of the radio rom.
THX
You will need the sspl version of the installer. It can be downloaded here.
hmm, so i took the wrong radio ROm version?
on this site:
http://forum.xda-developers.com/showthread.php?t=291827
i took the first one because i have a herm300 from t-mobile.
So i only have to flash with the version you gave me, and thats all?
Update radio without Activesync connetion
Can I update this rom version without any activesycn connection. My HTC TYTN is hang out after rom dwwongrading and now it start unitl windows loading screen. I think that only alternative is download new rom with help of three colour screen usb connetion or with help of mtty program. My bootloader version is 1.09
Please let me know your opinions,
Juha
@Miliano: you are correct. The sspl download for v1.27 was created by wpbear.
Unbelievably, I found the link for you by looking in the Hermes WiKi....
@frontpage: sspl based flashing won't work unless windows mobile can load
Hey people, Ive noticed a few problems with people upgrading to HardSPL and new radio etc... then not being able to flash a newer WM5 rom, since the RUU doesnt like the new SPL version.
So ive written a "Safe WM5 Flashing Guide" to help people on the way.
You will find it HERE. A bit of feedback would be great.
you should add a warning to this:
There are some old WM5 roms with old radios on them which have radio bootloader 0106, people who have flashed radios > 1.27 on their hermes got radio bootloader 0108. Those will get a "No GSM" error when flashing a 0106 radio, so if they want to downgrade to original rom they can't put the original radio on the device.
Hello,
Just unlocked both sim and cid, and installed tnt 1933 touch flo rom, no problems on the install, expect for that my cell phone does not work.
I know I might have to update the radio rom, and anyone please explain the procedure and the file needed, read, but confused.
current:
G4
ipl 2.21.001
spl 2.21.olip
gsm 02.25.11
os 11.0.0.1
s.thakur
I just upgrade and notice the bug too. My phone works sometime, but I cant end the call! and some sms are not being rec'd.
TNT.1933 is known to have problems for some Radio ROMs.
Either choose other ROM or try other Radio ROMs until the problem goes away (There is no recommended radio version because it depends on your carrier)
For what I know, this is link to the newest Radio ROM available (2.71.11).
In the thread it's written it is g4 safe.
So I think you can flash it to your device plain and simple.
But I am not pretty sure if you need to use the RUU provided or the Mun's RUU from the Hard SPL thread...
EDIT:
I have flawlessy performed Radio upgrade to 2.71.11
I can now confirm it's g4 safe... just start the romupdateutility and follow the instructions...
No need to change RUU from the one included in rar archive for my G4 HardSPL.
Hi guys,
I´ve read a lot of posts here at xda.
But i have few questions before i try to upgrade.
First of all, my RADIO version is not listed anywhere here. It is 1.58.21.26. So if i SuperCid it, is there a problem to put another radio version?
2 - If i install another ROM(original or cooked), is there a way to go back to the default rom that it´s in my phone? even after i installed other radio version?
3- supercid, hardspl, sspl or uspl? wich one is better or keeps my original rom and radio??
Thanks!!!!
1. If you CID, and use HardSPL (1.22 latest i believe) you should have no problems flashing new Radios or ROM's.
2. When you flash a new ROM your current one is over written (after you have flashed it you have to set up the OS again - all data stored in phone memory will be lost).
3. They are all different Things. HardSPL permanently updates the SPL on your phone allowing you to flash a new ROM when ever with bricking your phone. SSPL (SoftSPL) allows you to flash a new ROM (or radio, or hspl) 1 time then returns to the normal SPL. uspl, I'm not sure about I have never used it before. and CID unlocks the device to all networks and allows you to flash any ROM (rather than just ones from your carrier or official HTC ones. NONE of these will preserve your ROM if you flash a new one. however if you just flash these bits they should not effect windows or your radio.
DO NOT put a new ROM on your phone until you have unlocked it and put HardSPL or SoftSPL on it. If your brick your phone its near impossible to get it working again!
Questions before proceeding.
My HTC NIKI100 was unlocked for any carrier through the IMEI code, it also has the original radio 1.58.21.26. Perform the installation process of HARDSPL 1:22 as the tutorial here: http://forum.xda-developers.com/showthread.php?t=355730 and got success! now I can put a new radio or need to do the procedures as SuperCID here: http://forum.xda-developers.com/showthread.php?t=395945 ???