Hello there
I have a Touch Pro device, and since yesterday evening, after the phone goes in sleep mode (or after i press the power button), it doesn't turn back on. I can't reset, can't Hard reset even. If i call the phone, it rings, but the screen doesn't turn on, neither the illumination of the keys, or the keyboard. If I take out the battery and put it back, it boots OK, screen works, until it goes to sleep mode, after that... the same.
I had Romeos ROMeOS² v1.90.2] when the problem started, now i was able to flash it to ShEp's Rom Ver 2.3a][WinMo 6.5][Build 21198 Ver 2][TF3D Ver 2] and the problem still persists.
Thanks for your help.
Update: I haven't done anything and now it's does not even boot, it vibrates when its turned on, and i can hear the start up melody, bot no screen and no keyboard illumination.
might help
I'm no expert, but have you tried Bootloader mode? If you can get into bootloader mode after taking out the battery and restarting, try flashing Hard SPL again then a stock ROM with a radio. With the phone plugged into the USB port it shouldn't go to sleep. If that doesn't work it may be bricked.
Untill now the phone started after i took the battery out, and i flashed it to another rom. Even after this it started up after i took the battery out, after that i haven't done anything and now it doesn't screen wont start even after i took the battery out.
The only thing i didn't try was hardspl again......
OOh man, i was trying to do a hard reset without the screen. and now if i turn the phone on, every time i press vol down/up after i certain time, the phone vibrates as when you turn it on. It's stuck at the hard reset phase ?
How is the hard reset ? Vol up to hard reset and after that vol up to boot ?
Suggest you read the wiki
Have a look at the wiki for beginners. Hard reset is normally hold VOLUME DOWN AND CENTER BUTTON then reset with stylus.
Thank you for beeng so friendly and helpfull, since the display was off, i asked what too push AFTER entering the hard reset screen. It was VolUp to hard reset, and afther that VolUp again to reboot. Or VolDown... It doesen't matter, i took the phone back to Orange warranty
I don't know what will they say... HardSPL+ Custom Rom... But phone won't start so mabey they wont notice
Cheers
Related
Hi,
I'm a hp rw6828 user and is very much enthusiast to try out those wm6 roms made by those experts. However, i did a mistake while trying to flash.
I tried flashing with a rom from wantat but i forgotten to delete the EBOOT.nb0 before i clicked "upgrade". Then the program stopped at 6% for a long time and didnt move. I disconnect the cables and tried to turn the device on.
THe device can go into the wm6 and the start button can be use but the screen is "moved" to the right side and other function is not working.
After that, i did a hard reset and the the os seem to work like normal. However, when i tried to go into bootloader mode by pressing both "_" and soft reset. That didnt work. I tried another way by taking out the batt, leave it for a 10mins, press both "_" and soft reset, put in batt, release soft reset then "_" keys. That didn't work either.
But, just lately, i've tried taking out batt, holding the camera key and softreset, place back batt, release soft reset n camera button. This method works and i get what it seems to be an atom bootloader?
i get a black background with "MN1 Bootloader Mar 29 2006 13;52;14 copyright..... 1) debug module through UART 2) jump to DM Enter your selection.
Can someone help me? I'm not sure what i'm facing and what to do? All you help is much appreciated. THank you.
Hello.
I recently got a galaxy s2 that had been water damaged and wouldn't start.
I disassembled the phone and cleaned it thoroughly with isopropyl.
After putting the phone back together, everything works perfectly, except for the front camera and... whenever the phone goes into standby/ sleep mode for more than 5 seconds, the phone will not come back on and I have to replace the battery in order to turn the phone back on. This happens every time the phone goes to sleep mode for more than 5 seconds. If I turn the screen back on before 5 seconds have passed, the screen comes right back on.
However, if I have the charger attached to the phone, nothing wrong happens and the phone works perfectly (except for the front camera).
I would
A factory reset the phone .
B flash firmware to rule in a hardware problem .
jje
Thanks for the reply.
I have tried resetting the phone but that didn't solve it.
I also tried to update the firmware, but I'm not able to, because when the phone restarts during the flashing proccess, the phone just stays off and won't power back on. I then have to re-insert the battery to power up the phone again, but then the flashing proccess is interrupted.
By the way. I don't have any experience with rooting android phones and don't know of another way to flash the phone, other than throught the "KIES" software or through the update function on the phone itself.
I'm not sure if the phone is rooted or has a custom firmware, but when I press vol up + home button when powering on the phone, I am presented with a menu that says ODIN, so not sure if that means the phone is rooted or not.
I'm not sure if the phone is rooted or has a custom firmware, but when I press vol up + home button when powering on the phone, I am presented with a menu that says ODIN, so not sure if that means the phone is rooted or not.
Odd that and i would guess it is custom firmware .
Recovery factory reset is
Vol Up + Power + Home Button held down and released at splash screen
Download mode is Vol Down + Power + Home Button
Can you get to either of the above .
jje
Oleq83 said:
Thanks for the reply.
I have tried resetting the phone but that didn't solve it.
I also tried to update the firmware, but I'm not able to, because when the phone restarts during the flashing proccess, the phone just stays off and won't power back on. I then have to re-insert the battery to power up the phone again, but then the flashing proccess is interrupted.
By the way. I don't have any experience with rooting android phones and don't know of another way to flash the phone, other than throught the "KIES" software or through the update function on the phone itself.
I'm not sure if the phone is rooted or has a custom firmware, but when I press vol up + home button when powering on the phone, I am presented with a menu that says ODIN, so not sure if that means the phone is rooted or not.
Click to expand...
Click to collapse
You have a lot of information you need.
Odin is the utility used to flash firmwares/kernels/modems/etc to your phone. If that screen that says "Odin" says custom binary: no (or something similar) then it is LIKELY that it is not rooted, but you can root and reset this display with a few different techniques.
I've found Kies unreliable at best when attempting to update firmware, and have only used Odin. (since Kies never fully updated my firmware even once)
Read FAQs and stickies here.
Ok. Thanks for the help to both of you.
Tried to flash a stock firmware with the odin software, but after the phone powers off during the flashing proccess, it wont power back on.
So I have to re-insert the battery again, which interupts the flashing proccess.
So the water has propably done too much damage to the phone then and it's propably not a software fault.
I've ordered a new battery in case that is the cultprit, but if it's not, then I'll propably just sell the phone for spares.
At least the screen is in pretty good condition
Oleq83 said:
Ok. Thanks for the help to both of you.
Tried to flash a stock firmware with the odin software, but after the phone powers off during the flashing proccess, it wont power back on.
So I have to re-insert the battery again, which interupts the flashing proccess.
So the water has propably done too much damage to the phone then and it's propably not a software fault.
I've ordered a new battery in case that is the cultprit, but if it's not, then I'll propably just sell the phone for spares.
At least the screen is in pretty good condition
Click to expand...
Click to collapse
Don't forget to press thanks the guys who helped you
My x10 is bricked and won't boot past the Sony Ericsson screen. I have trouble getting it to turn on at all, it takes a weird combination of removing the battery and holding whatever keys. All I know is that it won't turn on unless I take out the battery, put it back in, hold the volume buttons, and press power. If i'm lucky, the phone will vibrate, and seconds later I'll have the SE screen. If there is no usb plugged in, it will go to recovery. I cannot, to save my life, get this phone into flash mode. I had it like an hour ago, but for some reason flashtool got stuck on reading device information, and I couldn't get it back into flash mode since then. Can someone help?
FireFreek said:
My x10 is bricked and won't boot past the Sony Ericsson screen. I have trouble getting it to turn on at all, it takes a weird combination of removing the battery and holding whatever keys. All I know is that it won't turn on unless I take out the battery, put it back in, hold the volume buttons, and press power. If i'm lucky, the phone will vibrate, and seconds later I'll have the SE screen. If there is no usb plugged in, it will go to recovery. I cannot, to save my life, get this phone into flash mode. I had it like an hour ago, but for some reason flashtool got stuck on reading device information, and I couldn't get it back into flash mode since then. Can someone help?
Click to expand...
Click to collapse
try out the REPAIR option in SEUS or PC companion.
(also to get into flash mode follow the following steps in the same order as mentioned below :
1. remove battery and plug it in.
2. connect the usb to the x10 first.
3. finally connect the other end of the usb cable to the pc holding the back button. )
OR
you can also try out this method too
Okay, I finally got it working. But the problem is that sometimes it just randomly turns off, and doesn't turn back on again. And when it does I'm not sure why. It might be a battery but I've got three of them, and two of them are new. So it shouldn't be that. (BTW, I managed to root it, unlock the bootloader, and install FXP125 7.2 cyanogen mod. It works fine when it's turned on.) It's like it has moments where the phone works perfectly, turning on, being able to get to recovery and flash mode, and moments where it does absolutely nothing.
strange behaviour !
try to wipe cache partition and dalvik cache
or may be you could reinstall clockwork mod nd CM7 once again right from the beginning
also you should let the ROM settle before its regular use.
***EDIT***
i am also on FXP125 CM7 and so far no such behaviour.
well my phone is now stuck on the htc screen... help please
I was running meanrom 3.0 then dirty flashed 3.9. My phone would turn off randomly so i restored it to 3.0. Then my text messages wouldnt work couldnt send or receive. So then i full wiped, restored and still no text. Then I full wiped and hit reboot system. And now it is stuck. I guess it is stuck because i didnt restore or install a rom? I cant even get to the bootloader. So is this phone a paperweight now?
Hold power down, this will cause a simulated battery pull, the phone will turn off, wait a second or two then press and hold power button and volume down and you will boot to the boot loader. Be very careful next time
Edit so long as your phone responds there is almost always a way to fix it, you only worry when phone stops responding (screen off won't charge won't turn on)
I wish more people would read my guide I included problems (even this exact one) to help people avoid them
ok got to bootloader. THANKS
No problem I'm glad I helped.
Note: This exact problem and many others are in the troubleshooting section of my guide. (Sorry if I don't advertise no one will use it lol)
Yep.... you wiped the ROM and then tried to boot nothing.
yeah....this is clearly covered in my guide...lol
Ok, i've searched all over the internet for the same problem and i couldn´t find anyone who've experienced this.
Where's what happened, my power button started to mal-function after my phone restarted. Now i cant lock or unlock the screen with it. The funny thing is that if I press it long enough it shows that [Shutdown/restart] menu. And if i keep pressing it it will soft reset the phone as usual.
I've already tried an app to se wich keys are being pressed to rule out the stuck key problem. The phone no longer recognizes the quick press of the key to lock/unlock, it only recognizes the long press of the power button.
Also today it refused to identify the charger and didn't charge at all, dunno if it as something to do with it.
My phone is the Wiko Wax, rooted, custom rom( Tesla 0.4.9a) android 4.4.4, with custom kernel as well.
I have already re-flashed everything, formated my phone and everything, but it doesn't seem to get fixed.
This started to happen after the phone restarted it self, without me doing anything to it