Does anyone know how to enable diagnostic mode in the x10?
That is when android os creates a layer to the GSM modem chipset's USB from it's own USB.
Related
Hi all,
I would like to use QPST to change parameters of the radio on TMobile Springboard with CM 10.
It turns out that the kernel supports DIAG interface, as I can turn it on with
Code:
echo diag > /sys/class/android_usb/android0/f_diag/clients
and also there is something on the tablet called
Code:
/dev/diag
which I assume is the exposed diag serial port. What I want to do is to set up usb interface like was done
here: http://forum.xda-developers.com/showthread.php?t=2049701
and a Windows driver, so I can connect with QPST to this port. However, no combination of usb VID/PID/Windows driver worked for me so far.
Did anyone try it?
Hi guys,
i have been searching the whole internet but i found no workable solution.
I have hard bricked my Vodafone Tablet Smart 4.
Current status:
- i put the charge cable into the tab, but nothing happens
- i can push any button, but nothing happens
I connected it with the computer and the computer recognized the tab as unknown device (yes, now i could install any driver, e.g. Qualcomm HS-USB QDLoader 9008) for 35 seconds (Debug Mode).
I have tested many possible software solutions (e.g. QcomDloader, Qualcomm Snapdragon Flash Tool, SP-Flash-Tool Version 3.*, 4.*, 5.*).
Now my question:
Is there any way to rewrite a new bootloader/ preloader partition on this tab? Or can i flash a new firmware directly to the Qualcomm CPU?
best regards
Olaf
I see lte version use mdm9625 chip. Does anyone know how how to enter engineering mode to add a diagnosis com port so that to use qpts/qxdm rewrite lte band?
Does anyone know if there is a solution to unbrick the LG e455f?
When I connect the driver appears as: MediaTek USB Port (COM11). The screen goes completely dark, I have no access to any command.
Guidance an step please if anyone know.
I had to do a search about the Diag port. I didn't know what is was.
I glanced at a few links which suggested a generic method for qualcomm phones.
Example:s
Qualcomm Diag Mode, Enable DIAG Port For Qualcomm Phones - GSM-Forum
How to Enable Qualcomm Diagnostic Mode 1. Dial Number For Some Of Non ROOTED Generic Qualcomm ''CPU'' Type *#*#717717#*#* Or *#*#13491#*#* on dial pad.
forum.gsmhosting.com
Enable DIAG Mode or COM Port on any Android Smartphone / Tablet
Want to activate Diag Mode or Enable Qualcomm Diagnostic Mode on your Android Phone or Tablet? Follow the 3 methods listed here and enable Diag COM port.
www.gizmoadvices.com