i have a bell atrix that has been running on the att 2.34 rom with faux custom kernel with no problems since the fixes have been put out however tonight while texting i received a message saying that the sim card was not provisioned mm#2 does anyone have any idea as to why this happened? do i need to get a new sim card or is it a soft/hardware issue? any help would be appreciated
thanks in advance
Ended up being my sim card was fried and needed a new one. mods can close this if they choose
Related
Specifics of my phone are Rogers unlocked/rooted.
Was functioning perfectly fine with stock rogers rom, i tried to flash saurom, that's when it went to ****.
My phone hasn't recognized the sim card since, giving me a no sim error. I've tried flashing odin stock rogers and stock kernel, CWM the rogers modem, etc.
Nothing has fixed it thus far... ready to throw this thing against a wall
I'm able to put my sim card in another phone and it functions just fine. I've even taken a sim card from that other phone, and put it into my Note, and it worked... But my native sim card doesn't like my Note anymore?..
Anyone have any suggestions?..
can you try changing another Rogers sim card or unlock first. it's only 15$ to network/factory unlock at cellunlocket.net
it's already unlocked. i've stated that i put another card in the phone and it functions fine. and put the same card into another phone and it functions fine.. but this card gives me this blasted error.
If you go to settings >> about phone do you have a baseband or does it say unknown?
If you go to status (under about phone), do you have an unknown IMEI and unkown IMEI SV?
That's the first place to start.
Synthetickiller said:
If you go to settings >> about phone do you have a baseband or does it say unknown?
If you go to status (under about phone), do you have an unknown IMEI and unkown IMEI SV?
That's the first place to start.
Click to expand...
Click to collapse
Have proper IMEI numbers and i717ruxla2 baseband.
I found i could switch it to HSPDA+ only and I'll be able to use 4g data/voice for a few minutes.. then it lose signal :S
funkdoobi said:
Have proper IMEI numbers and i717ruxla2 baseband.
I found i could switch it to HSPDA+ only and I'll be able to use 4g data/voice for a few minutes.. then it lose signal :S
Click to expand...
Click to collapse
Sounds like a finicky modem.
Do you have the stock modem EFS or another version you could try?
Synthetickiller said:
Sounds like a finicky modem.
Do you have the stock modem EFS or another version you could try?
Click to expand...
Click to collapse
I've flashed and reflashed the rogers modem over and over again.. Not sure how it can still be a modem issue?
I went out and got a brand new ROGERS LTE cim card today to replace the one that i thought was faulty... same issue. I've tried two non-lte cards from other providers and they work perfectly fine.. yet my rogers card doesn't? :S
funkdoobi said:
I've flashed and reflashed the rogers modem over and over again.. Not sure how it can still be a modem issue?
I went out and got a brand new ROGERS LTE cim card today to replace the one that i thought was faulty... same issue. I've tried two non-lte cards from other providers and they work perfectly fine.. yet my rogers card doesn't? :S
Click to expand...
Click to collapse
I have absolutely zero experience flashing to rogers. I will tell you my experience though. Hopefully, it might give you some insight.
My i717 was flashed from AT&T to a T-mobile radio. On the stock AT&T rom, no radio would work. This included the original radio firmware I had downloaded from XDA and other places as well.
I flashing to a GB rom, Sauron in my case fixed the issue. If I flashed to ICS, I had to get an ICS compatible radio. If I flashed back to the AT&T rom, nothing works. It seems to be irreversible, despite what everyone on here says. I know I'll get flack for it, but I've tried it a few times. Maybe I have a special phone? LOL
I would say back up your EFS w/ EFS Pro (it worked for me), then try flashing to something else, even AT&T or T-mobile. I think you'd get 2G speeds at least. I'm not familiar with Rogers bands, so I don't know what radios you can flash to or what basebands are compatible. Maybe someone could chime in on that topic?
As long as you back up your EFS, if you're careful and find a working radio, you should be ok and you should be able to revert and flash away.
Does anyone out there have a working rogers radio? Help this guy out!
Thanks for the reply. As per what you've said, I've already tried a bunch of that.
I've tried flashing to both Bell and AT&T stocks. No dice. I've tried swapping the modems out as well to their. No dice.
As stated, I've even gotten a brand new sim card today. That card works perfectly fine in my backup phone (which isn't an LTE device, don't know if that matters?).
Im having this same problem..
I had a data plan on my sim card.
AT&T plan
and ever since I tried to root it...and i accediently wiped sd card
it says NO SIM CARD FOUND ever time it starts..
no sim card
Suddenly today, no sim card msg appears.
My samsung galaxy note i717 (Rogers) phone is std and never been altered.
I checked this thread and no answers appear.
Will contact rogers.
i have same problem AT&T I717
i tried different firmware like Rogers Telus and AT&T As well but problem is still there
and also i checked Hardware nothing wrong with hardware side i have same phone i replace SIM Socket but dos't work either
any Ida about this problem
Thanks
My first note I got did this also. Lucky it was 10 minutes after walking out of the store. They swapped out out for me and haven't had it happen again. Most likely, its the phone. Revert back to stock and send it in for warranty if possible.
Sent from my Samsung-SGH-I717 using xda app-developers app
I have the same problem display on screen " the mobile network will be unavailable until you restart a valib sim card inserted" repeat it every time
Sent from my Micromax A90s using xda premium
I have tried every radio in this forum, must be at least 7 or 8, and none of them can get my SGNote i717 to work When i go Settings > wireless and networks > mobile networks i get a popup saying "insert SIM card to access network services" eventhough i already have a SIM from wind in there.
I am running OnlyOne rom 4.0.4, rooted.
kernel version:
3.0.8-perf-i717ucle2-cl526350
[email protected] #1
SMP preempt tue may 8 21:16:00 KST 2012
build number:
IMM76D.UCLE2
If anyone can point me to or post a working, or prefered, faster radio to use for Wind Mobile, I would really appreciate it. I've spent countless hours on XDA.
I have copied the radios to the SD card and tried flashing each one with CWM, then trying them out, but none work. If I am doing it wrong, please show me how to do it right.
Cheers :good:
Wind uses T-Mobile bands. Go get the blaze modem in the T-Mobile thread discussion.
But if you get a sim card not recognized or a no sim card inserted error, its not the modem. Check your sim in any GSM phone to see it it is damaged or not provisioned.
rangercaptain said:
Wind uses T-Mobile bands. Go get the blaze modem in the T-Mobile thread discussion.
But if you get a sim card not recognized or a no sim card inserted error, its not the modem. Check your sim in any GSM phone to see it it is damaged or not provisioned.
Click to expand...
Click to collapse
or even dirty. possible that your sim slot is damaged too.
madman604 said:
or even dirty. possible that your sim slot is damaged too.
Click to expand...
Click to collapse
Well, its a brand new phone, perfectly clean and i had it working before. at first when updated to onlyone rom, i tried many that didnt work until i found one that did. but i found the speeds were too slow, so today i decided to shop around for some others, but now that i flashed these ones, i cant get the original one working again.
are you sure its hardware and not software?
found this:
http://forum.xda-developers.com/showpost.php?p=26657065&postcount=336
quite a unique circumstance but explains a lot. i will try it now and confirm it worked on my phone
yes, the above link proved to be the correct answer. onlyone rom users for the galaxy note can only use the ripped sgs2 ICS radios
i hope this will be able to help someone else
:good:
Whew. Good job on the investigation.
same as me
hello
this happened to me and drove me crazy in the end from recovery i did all the wipe and installed the saurom rom then every thing worked agen i am new at this but i think my mastic was that i flashed ics modem over a gingerbread rom or vers versa
but after a wipe and a new rom the phone start to see the sim i wish that help because this drove me crazy good luck
Can someone post the steps to do this? I am with Mobilicity and lost network connection. Probably because of flashing roms that do not work with Mobilicity.
sazfar13 said:
Can someone post the steps to do this? I am with Mobilicity and lost network connection. Probably because of flashing roms that do not work with Mobilicity.
Click to expand...
Click to collapse
The solution to this problem is all those on the Tmobile/Wind/Mobilicity network need to flash one of these radios after they have flashed a rom of their choosing. I believe the radios that come with these roms are for the AT&T/Bell/Rogers/Telus networks
http://forum.xda-developers.com/showthread.php?t=1573568
rangercaptain said:
Wind uses T-Mobile bands. Go get the blaze modem in the T-Mobile thread discussion.
But if you get a sim card not recognized or a no sim card inserted error, its not the modem. Check your sim in any GSM phone to see it it is damaged or not provisioned.
Click to expand...
Click to collapse
No, it actually "does" have to do with the modem sometimes. I flashed several roms and, when i got the error, it was only with a certain rom and, after going back to the other rom, the problem was gone. The SIM wasn't touched hence...it was not the SIM.
immortalsoule said:
No, it actually "does" have to do with the modem sometimes. I flashed several roms and, when i got the error, it was only with a certain rom and, after going back to the other rom, the problem was gone. The SIM wasn't touched hence...it was not the SIM.
Click to expand...
Click to collapse
Flashing a rom does not flash a modem. So with all the rom changes you did, you never touched the modem.
Only a few update packages contain both a rom and a modem.
rangercaptain said:
Flashing a rom does not flash a modem. So with all the rom changes you did, you never touched the modem.
Only a few update packages contain both a rom and a modem.
Click to expand...
Click to collapse
Yes and my packages "may" have been some of those packages. Stop assuming....believe it or not you don't see everything that goes on at the other end. I also flashed other modems as well, the three made for T-Mobile, along with those roms and just didn't add it into the conversation. The Padawan ROM actually "does" carry multiple modems.
What ever, dude. Stop getting so excited. Its just information.
And its not your thread -- its a community thread.
Hello, i have a problem, i did unlock my sim locked phone with voodoo, and it worked great.
Today I've tried cm10 and when it booted it said that my sim is locked ?
Then I've tried unlock it again with voodoo but it say's SIM lock-reader error
What to do??
Have you tried another sim after you ran voodoo? I got the same error on cm10 but the phone was unlocked
I don't have another sim, but when I've first got the phone, I've installed cm10 on it and unlock it on cm10 with the voodoo.
And now after about the week with the (unlocked) phone I wanted to get some vanila feeling and installed it again, before every rom i flashed there was no problem, so i doubt it's sim card problem.
Bucika said:
I don't have another sim, but when I've first got the phone, I've installed cm10 on it and unlock it on cm10 with the voodoo.
And now after about the week with the (unlocked) phone I wanted to get some vanila feeling and installed it again, before every rom i flashed there was no problem, so i doubt it's sim card problem.
Click to expand...
Click to collapse
I have the same issue.
I have 2 sims.
The first given with the phone when not sim unlocked is still working but not the new one.
After restoring CM9 both SIM works fine.
so i just got a i717 didint like ics on andriod 4.0.4 upgraded to andraded 4.1.2 jb perfectly fine. from there i flashed cyanogen mod with twrp. it was cyanogen mod 10.1,whick upgraded me to gb 4.2.2 at this point i got extremly spotty service. so i did a factory reset wiped cached and reflashed the rom now i am getting a no sim card error. like the sim card is not showing up anymore. i went back to jb 4.1.2 and same thing no sim. i did an advanced factory reset then reflashed twrp then flashed jb 4.1.2 STILL no sim card. i installed the newest version of cyanogen mod 10.1.3 and still no service. its unlocked to t mobile.i dont know what to do to get this sim to work. i have also tryed using a friends tmobile sim and didint read it and i have also tryed to use another friends att sim card and still no luck. Im going to order a new sim tray tomorrow untill then does anybody know whars going on or any fixes?????
Thanks in advance!
I am not a professional and don't know much about how a modem is supposed to work or what a modem even is.
I have a SM-J500F (j5lte) and recently I installed various custom ROMs on it. They seemed to work fine. But my SIM card was unusable on every single one of them. For your information, my SIM card is a JIO 4G SIM card (Indian). Jio is a SIM card that ONLY supports calling via VoLTE. Now, out of the ROMs I flashed, some explicitly stated- "VoLTE works" or something like that. Yet I had no luck. Therefore, I am back to stock now. I can easily call/message using the same SIM card.
Now my question is- If I flash the stock modem in a custom ROM, will the SIM be usable?
Thanks in advance.