Hi there, Just need a bit of clarification.
I rooted my G2 touch using the Goldcard method about a week ago and it's now running Modaco 3.2. I was preparing my phone for post i had just sold it via ebay. i decided to do a format SD Card without thinking. I got a message saying the SD card was damaged after this in notification window. After panicking a bit i formatted the card using my pc. everything is now working.
My only problem is that is this going to affect installing custom Roms for the new owner as i remember having to change something in HEX editor with regards to the SD card?
Any help would be much appreciated.
Ps Can i do a factory reset with a modaco custom ROM?
If you are running MCR 3.2 already then the new owner will be able to install other custom ROMS no problem as the patched recovery thingy is already on your phone. Dont sweat it,.... But you might want to let them know about the SD showing as damaged,... You dont want -'ve feedback.
I have recently upgrade to android 2.3.3 and am using EWJET as a rom.
I cannot access the SD once Android OS has booted. All apps and the system/settings says SD Card isn't mounted. Tried multiple installs, nothing works.
All 2.1/2.2 Roms are fine.
If i tap back during start-up and access xrecovery I have normal access to the SDcard and can flash packages etc. So the phone is able to access the card ok.
My SD card is the 8gb that came with the phone and isnt partitioned in anyway.
However in the past I did have it partitioned, but not now. Incase I am installing 2.3.3 and the rom wrong, ill tell you my steps.
Factory Firmware 2.1 flashed
rooted, busybox and recovery installed
Flashed X10i_3.0.1.G.0.75_only_kernel_baseband
then install the EWJET rom as per his instructions..
I pray I am only doing the above steps wrong as I desperately want the SD working on 2.3.3.
Any help would be appreciated.
Brent
having something similar:
http://forum.xda-developers.com/showthread.php?t=1201915
brent0r said:
I have recently upgrade to android 2.3.3 and am using EWJET as a rom.
I cannot access the SD once Android OS has booted. All apps and the system/settings says SD Card isn't mounted. Tried multiple installs, nothing works.
All 2.1/2.2 Roms are fine.
If i tap back during start-up and access xrecovery I have normal access to the SDcard and can flash packages etc. So the phone is able to access the card ok.
My SD card is the 8gb that came with the phone and isnt partitioned in anyway.
However in the past I did have it partitioned, but not now. Incase I am installing 2.3.3 and the rom wrong, ill tell you my steps.
Factory Firmware 2.1 flashed
rooted, busybox and recovery installed
Flashed X10i_3.0.1.G.0.75_only_kernel_baseband
then install the EWJET rom as per his instructions..
I pray I am only doing the above steps wrong as I desperately want the SD working on 2.3.3.
Any help would be appreciated.
Brent
Click to expand...
Click to collapse
you try pulling it out and blowing on it like an old nes game...
jk smiles but have you tried perhaps throwing the sd into a computer and just formatting with different cluster sizes or in general formatting the card. Might need to use an adapter.
Happen the same thing to me but with wolfbreaks rom... some people told me to re-flash the rom but it didnt work. The funny thing is the the sd card will work on any other device, and any other sd card will work on the phone... havent try re-formatting the card cauze i dont have the adapter but it should work
Sent from my X10i using XDA App
J!K said:
Happen the same thing to me but with wolfbreaks rom... some people told me to re-flash the rom but it didnt work. The funny thing is the the sd card will work on any other device, and any other sd card will work on the phone... havent try re-formatting the card cauze i dont have the adapter but it should work
Sent from my X10i using XDA App
Click to expand...
Click to collapse
you might want to get an adapter. A while back i tried setting up a sd-ext partition on a 4gig card and long story short the only way i was able to run a format that gave me back the 4gigs was throwing it into an adapter
Had the same thing when I updated with stock-2.3.3.... At the time I had it partitioned in 2 partitions...
I connected the phone then with my pc, and there it was, alive and well.... So I backed up the entire card, that is, the first partition, where all my data were; I powered off the phone, took it out, found a adapter, deleted the 2nd partition with Partition Wizard Home Edition Minitool, made the sd-card 1 partition only, formatted that partition, and then I copied all my backed-up data back to the card
Then I put the card back in the phone, booted and voila: the card was recognized again by 2.3.3....! and now it functions ok!
Hope this helps, greetz, good luck,
kwarkje
J!K said:
Happen the same thing to me but with wolfbreaks rom... some people told me to re-flash the rom but it didnt work. The funny thing is the the sd card will work on any other device, and any other sd card will work on the phone... havent try re-formatting the card cauze i dont have the adapter but it should work
Sent from my X10i using XDA App
Click to expand...
Click to collapse
formatting did not help
Anything new on this?
for me it is a little different. The card that came with the phone works fine with the GB update, the thing is that I got another phone, this one came with a 4 Gb card so I took the one in the x10 with all my pics and put it in my new phone and put the other new card in the x10 but it doesn't recognize it...
I've tried with 2 different cards, in xRec i can read it, back up, etc, but once in android its like there's nothing there. Tried formatting it with no results....
What could it be that it reads the original x10 card and no other?
Ive got no idea, but its annoying. Im gonna have to go back to 2.1 which sucks.
We need to some how figure out whats causing this. Ive tried everything.
2.3 seems to be the problem.
brent0r said:
Ive got no idea, but its annoying. Im gonna have to go back to 2.1 which sucks.
We need to some how figure out whats causing this. Ive tried everything.
2.3 seems to be the problem.
Click to expand...
Click to collapse
I have 2.3 and the card that originally came with the phone (16Gb SDHT) works fine, the thing is that it doesn't read any other card.
brent0r said:
Ive got no idea, but its annoying. Im gonna have to go back to 2.1 which sucks.
We need to some how figure out whats causing this. Ive tried everything.
2.3 seems to be the problem.
Click to expand...
Click to collapse
Same issue no clue what to do
Today i found a workarround using DISKPART (6 years later hehe)
Note that this will wipe your storage card so BACKUP !!
Hold [Win + R] and type in : diskpart (or launch cmd as admin and types: diskpart )
Every lines should be followed by enter key.
list disk
select disk *
(" * " is the number of your drive. be carefull do not choice your hard drive number which is commonly 0)
clean
create partition primary
assign
format fs fat quick
exit
Tested and work fine on windows 8 (but should work on 7, 8.1, 10)
Thanks Hope i help even 6 years later !! cheers
hi everyone well last week ive tried many times over to install ics rom over my gingerbread and everytime this is what i get after i have completed followed the steps of how to upgrade to ics rom....when its trying to install the sd card can not be mounted...and repeats it many times over...so then i put phone into recovery so i can reboot...and it rebooted into the ics rom which i dont know how, but now my sd card is damaged and cant mount so i lose all my info no biggy....after reformatting the sd card, its ok...so i figure i would start it again...same thing.....i even did the steps but left the sd card out where you are suppose to and put back in when needed...still the same thing cant read sd card on install and after reboot sd card damaged need formatted...so i dont know what else to think except that i just cant simply get it flashed to the ics roms of any kind properly...if anyone can help thanks
vk4559 said:
hi everyone well last week ive tried many times over to install ics rom over my gingerbread and everytime this is what i get after i have completed followed the steps of how to upgrade to ics rom....when its trying to install the sd card can not be mounted...and repeats it many times over...so then i put phone into recovery so i can reboot...and it rebooted into the ics rom which i dont know how, but now my sd card is damaged and cant mount so i lose all my info no biggy....after reformatting the sd card, its ok...so i figure i would start it again...same thing.....i even did the steps but left the sd card out where you are suppose to and put back in when needed...still the same thing cant read sd card on install and after reboot sd card damaged need formatted...so i dont know what else to think except that i just cant simply get it flashed to the ics roms of any kind properly...if anyone can help thanks
Click to expand...
Click to collapse
buy a class6 or higher sd card and your issue will be solved.
As I said in my other post:
Sounds like you need a new SD card. Some of the stock cards don't play well with MTD based ROMs. I think it's a speed issue, and MTD based roms assume cards are at least a certain speed. I would probably get a Class 10 microSD card (be careful if you get 32gb, there are known problems with some of them)
I bought http://www.amazon.com/AmazonBasics-microSDHC-Class-Memory-Adapter/dp/B0058GH4U0/ref=sr_1_12?ie=UTF8&qid=1335980268&sr=8-12 and have had no problems at all after!
thanks everyone for replying...i might have to just upgrade to a different card and see if that will solve the problem.
vk4559 said:
thanks everyone for replying...i might have to just upgrade to a different card and see if that will solve the problem.
Click to expand...
Click to collapse
every since switching to a class 10 card, i have had no mounting issues or sd card damage errors since. my device also seems to be more tolerant of dirty flashing, before i had to always wipe data...also the phone seems faster loading apps, pictures etc.
droidstyle said:
every since switching to a class 10 card, i have had no mounting issues or sd card damage errors since. my device also seems to be more tolerant of dirty flashing, before i had to always wipe data...also the phone seems faster loading apps, pictures etc.
Click to expand...
Click to collapse
+1
droidstyle said:
every since switching to a class 10 card, i have had no mounting issues or sd card damage errors since. my device also seems to be more tolerant of dirty flashing, before i had to always wipe data...also the phone seems faster loading apps, pictures etc.
Click to expand...
Click to collapse
+2
Hello guys,
I have a problem that is very rare and I have not got into any other other threads to fix this one in particular.
the problem i have is that I was on Jelly Bean and then out of no where the phone went to recovery and was just there
trying to read the SD Card and it attempt 10 times and it just keep booting on and off to the same error at the CWM Recovery
So I got the phone into Download mode flashed the Boot loader for Frojo and then Odin again but with Eugene_2E_JK2_Froyo.tar.md5
I got myself back to stock but it still have the same problem on not detecting any of the SD Cards Internal and EXT.
This make go and Odin back again a new rom EUGENE373_SamsungS_Froyo_PDA and the I went to STOCK Eclair and i still have
the same issue.
Is there anything I can do to restore my SD CARD?
With this problem there will be pretty much anything to do to the phone any more as it wont read the SD CARD for files, apps or anything
in there. Im getting an error at the notifications
Code:
Can not mount External SD card
Mountpoint absent or incorrect
I really need your help as I need apps for my job as i work on the road 24/7
Please advise on how to fix the i believe is the ICS BUG
Thanks
Soft bump
Anyone?
Thanks guys, :silly::cyclops:
I found my solution to the famous ICS EU Bug from here http://forum.xda-developers.com/showthread.php?t=1580902
so im currently using a samsung i5510m on android 2.2.2. recently i rooted my phone so i could switch my external SD card as internal since the phone only carries around 150mb of data. so, after rooting the device i edited my vold.fstab file the way i saw on one of the posts on xda. all was well until i rebooted my device, after which it refused to recognize SD card. just to be sure that the card didn't get corrupted i used a card reader and plugged it into my PC, it loaded up with the files. i thought it could be fixed if i formatted the card and so i did.however it didn't fix the problem and neither did factory reseting the device. Ive tried adb commands but its all been useless since the it cannot access the card and neither the phone itself. Ive tried using my other SD cards too but the result is the same.
any help guys? how can i restore the vold.fstab to the way it was since i think thats the problem here?
thanks in advance