So my evo 3d decided to pull a random reboot on me tonight (what's new?) and I let it all play out, (I'm running infected eternity 3.0 r39 btw) and right at what seemed to be the end of the boot animation, it froze. It did it before and a simple battery pull seemed to have fixed the problem last time. Only this time, after a battery pull, when it went to boot, all it would do is show the white htc splash screen, go completely black, and go back to the splash screen again. It will boot into recovery fine, I tried flashing a different kernel with no luck, and I decided to run a logcat in adb to see if I can figure out what exactly it's doing... here's what I get.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
does anyone have any ideas? I'm no rom expert, but I'd have to say that "Disk image malformed" and "Disk I/O error" sound not too good.
*update* I just flashed the latest stock kernel through fastboot and it managed to get past the htc screen, but is still freezing at the boot animation. the other two attempts (ziggy's OC and stock) were flashed through twrp that was booted into from fastboot via adb. gonna try a reboot and a reflash of the kernel before reflashing the entire rom...
Also note, that when the boot animation does run, and it freezes on the boot animation, adb devices pulls up the device, but it's listed as offline
Related
Hello!
A month or two ago I bought the the non-US Atrix and I wanted to have CM7 on it.
As I thought the information on the steps over at this page would work even for the international Atrix I tried to flash clockwork recovery, and little did I know that it didn't work when selecting Atrix 4G as model.
When trying to get into android recovery returned the error "Failed to boot 2" I didn't think too much of it for the time being as I could boot Android as usual.
Now when there is a new system update available for my Atrix I obviously want to install that since I still haven't gotten CM7 to work. But when the phone restarts to install the update it gets stuck at "Failed to boot 2 Starting RSD mode". Restarting doesn't work since when Android starts up it wants to reboot into the installation of the update.
Is there anyone who knows or have tips on how to solve this problem. I would really like to be able to use my phone again.
Use the Motorola update tool.
Cwm didn't work provably cuz your bootloader isn't unlocked (?)
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
I still have the problem where my phone wants to restart every time I start it, and for Motorola Software Update to be able to update I have to have the phone connected during the whole process.
Or is there another way of doing it that I don't know about?
Hello. After tons of tries, I finally achieved S-OFF so I was going to try to turn my phone into a GPe by using RUU. Everything was going fine, the install failed once like it should, but then, my phone just couldn't get found by my computer, I unplugged it, plugged it back, and when on fastboot, the pc won't recognize the device. Also, now I'm getting this when I boot into fastboot
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
, BTW, I've been reinstalling drivers like crazy for like an hour now, nothing seems to work, when I boot the phone normally, it does find it though, any help? Thanks.
haZethew0rld said:
Hello. After tons of tries, I finally achieved S-OFF so I was going to try to turn my phone into a GPe by using RUU. Everything was going fine, the install failed once like it should, but then, my phone just couldn't get found by my computer, I unplugged it, plugged it back, and when on fastboot, the pc won't recognize the device. Also, now I'm getting this when I boot into fastboot. BTW, I've been reinstalling drivers like crazy for like an hour now, nothing seems to work, when I boot the phone normally, it does find it though, any help? Thanks.
Click to expand...
Click to collapse
I'm having the same issue. Bought it w/ TWRP, s-off, and gpe rom. hboot is 1.54. The computer doesn't detect it in fastboot. Also, I'm not getting the tampered flag, just unlocked.
Hey,
I have a HTC One s9u here that wont boot anymore after I factory reset the phone through the recovery menu.
The phone was running slow and would freeze now and then which is why I decided to preform the factory reset.
Now it just gets stuck on the white HTC screen. I have tried running factory reset again several times as well clearing the cache partition.
I have also tried every button combination there is with no success. I left the phone on this screen over night and it must have ran out of battery at some point as it was off in the morning.
After plugging it in and turning it on it once again was stuck on the same screen. I tried this as I read somewhere that removing the battery or letting it drain completely may fix this issue.
I thought about flashing a stock ROM but am not sure if I have the correct ROM. The s9 is not listed with the other stock ROMS on the official HTC site. I did find a thread on here where someone provided a ROM for the s9u which I have downloaded. However in download mode on my phone Radio is shown as UNKNOWN so I can't match the ROM exactly. Which is an issue because I'm located in Australia and I don't want to flash a ROM that wont work with the Australian mobile network. This phone was bought overseas as I don't think it was ever available in the Australian market.
This phone has not been rooted and has the stock recovery which is why I don't understand why a factory reset would cause it to get stuck during boot.
I will attach photos of the bootloader, download and recovery screens in case any of the info on these screens is useful.
Bootloader image:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Download mode image:
Recovery image:
(Sorry about the huge images and the fact they're sideways. Not sure why they have been rotated).
If anyone has any suggestions on how to fix this issue I would be very grateful.
Regards,
Ruben Ah
Hello!
I got my mom's phone because it got stuck on the boot screen (honor Powered by android). She was out in the cold for a while, and when she tried to use her smartphone, it had shut down. As she tried to restart it, it got stuck on the boot screen. So she gave it to me hoping to at least get some important data back. I fixed some bricked phones in the past, but this one seems impossible to fix.
I got fastboot working, but the recovery doesn't seem to start no matter how I press PWR and Vol+. Also fastboot reboot recovery gets me no further than a reboot to the boot screen. Since the FRP is locked, I can't flash a recovery image.
The fastboot screen suggest to open HiSuite. But on my Mac it does require HDB to be active. However the windows version aknowledges that a device can do something via fastboot.
But my win10 machine is unable to properly recognize the usb device. Installing USB drivers seems not to help, even manual install in the device manager fails with driver signature disabled. Also a registry fix from this website seems not to help. In the end, I can't get fastboot to work in the commandline nor HiSuite.
At this point I'm out of Ideas. As it stands now, the only way to recover the data is by unsoldering the eMMC .
There are ways to unlock the bootloader, but as far as I know, it requires wiping the storage.
I'm not sure what happened to the phone outside, but it's really strange that there is no recovery available.
Does anyone have ideas on how to proceed?
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Hi there.
I just want to make some premises:
-The device is NOT rooted
-The device was NOT flashed or been modified in any way
Anyways,
I just picked up this phone after some years of being in some boxes, and wanted to see if it still works.
Here's what he does in booting:
-Logo
-Logo with screen less brighter
-Vodafone animation (yeah, my phone is branded)
-Stuck (like the image)
-Home button light still flashing tho
I tried to hard reset it, it kinda works, by booting, going into the setup, and 1-2 seconds later it boots itself straight into the animation (yup, no logo) and remains stuck.
I seriously don't know what to do.
Can you guys please help me out?
Thanks in advance
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Have you tried reinstalling the stock rom?
RodrigoAyuso said:
Have you tried reinstalling the stock rom?
Click to expand...
Click to collapse
yes and no
let me explain:
yes because I have everything set up for the process
and no because the LG softwares don't recognize the phone
Rust Metal said:
yes and no
let me explain:
yes because I have everything set up for the process
and no because the LG softwares don't recognize the phone
Click to expand...
Click to collapse
in short, no
[FIXED]
so I recently fixed, here's what I did:
-Downloaded and installed KDZ;
-Picked my software file (un-branded, while I were at it)
-Opened KDZ with Administrator Privileges (very crucial step, or else KDZ will crash for some unknown reasons)
-Flashed
-Waited
-Done