I have so many times flashed my phone with different ROMs like MIUI, Android ver 2.3.6, 4.03. etc.
Just now I have flashed using odin CF Root Kernel. Then I have used USB JIG for resetting binary counter. Now my boot logo change, I want to make as original. How can I?
Do you mean you want the original boot logo/animation you had with your original stock rom ?
If so, you need to flash the original stock firmware that was on your phone. Might want to head over to Sammobile.com to find your original firmware & then flash it in Odin following whatever instructions Sammobile have for flashing firmware downloaded from their site.
If you mean/are asking something else, please clarify what that is
Related
After rooting my phone everything was great but then my usb port started to malfunction so to get it repaired i needed to remove root and CWM, after flashing the stock rom (XWKI4) root still shows under kernel version and CWM and superuser still remain.
Am i doing something wrong? I have CF-root with CWM mod my phone info is...
PDA:I9100XWKI4
PHONE:I9100XXKI1
CSC:I9100CPWKH1
any help much appreciated...
Factory reset and or flash a stock kernel .
jje
I've tried factory reset and flashed stock via Odin. :-( I'm using XWKI4 pda
Then you are doing something wrong as stock flash changes kernel and removes a rooted kernel . use a different download or firmware .
jje
Should I be using just the pda section of odin or csc and phone too?
Should I try a different firmware for my phone to see if that works?
bubba949 said:
Should I be using just the pda section of odin or csc and phone too?
Follow the instructions from the relevant thread you are getting the firmware from depending upon how many parts are to be flashed .
Should I try a different firmware for my phone to see if that works?
YES
jje
Click to expand...
Click to collapse
Hi
Here is the case:
I have problems on my SGS2, and going to rma it.The reason for the rma is that I have usb problems an battery problems.
So now I need to get back to stock rom, unroot an remove CMW recovery. How can I do that?
I can not use Odin because of my usb problems. So I believe the solution will be flashing to stock rom using cwm recovery (and in the same prosses unroot)? Is that possible?
If so, where can i download a stock rom (nordic version) for flashing in cwm?
How do I later remove CWM recovery to get stock recovery?
(Sorry for my bad english)
jfm91 said:
Hi
Here is the case:
I have problems on my SGS2, and going to rma it.The reason for the rma is that I hav usb problems an battery problems.
So now I need to get back to stock rom, unroot an remove CMW recovery. How can I do that?
I can not use Odin because of my usb problems. So I belive the solution will be flashing to stock rom using cwm recovery (and in the same prosses unroot)? Is that possible?
If so, where can i download a stock rom (nordic version) for flashing in cwm?
How do I later remove CWM recovery to get stock recovery?
(Sorry for my bad english)
Click to expand...
Click to collapse
Stock rom thread or Sammobile .com .
Use Mobile Odin to flash firmware from SD card that will remove root and CWM .
jje
Mobile Odin would be a more sensible choice. If you currently have a custom binary count in download mode and no option of USB jig due to whatever problems you're having, a long winded convoluted method of resetting it would be to flash an ICS ROM (again with Mobile Odin, making sure to use a CF-root kernel in the process), use Triangle Away, then revert to a stock GB ROM.
I won't be elaborating on any of those things before you ask.
oinkylicious said:
Mobile Odin would be a more sensible choice. If you currently have a custom binary count in download mode and no option of USB jig due to whatever problems you're having, a long winded convoluted method of resetting it would be to flash an ICS ROM (again with Mobile Odin, making sure to use a CF-root kernel in the process), use Triangle Away, then revert to a stock GB ROM.
I won't be elaborating on any of those things before you ask.
Click to expand...
Click to collapse
I have 0 custom binary count. And I have ann usb jig, so thats no problem
Hi Guys,
I have a samsung s2 with some version 4.1.2(I don't remember).
I wanted to upgrade it to JB 4.2.1
I went to some links which mentioned that I should install CWM recovery before going for flashing of ROM.
However what mistake i did is I tried to load GT-I9100_ICS_ClockworkMod-Recovery_5.5.0.4.tar on the phone using ODIN (which I think is an ICS version).
With this...problem is I am able to go to download mode, also I can go to CWM recovery mode with errors like unable to mount the sd card.
But the phone does not start.
It boots to the start-up screen and shows a yellow warning triangle below and shuts down.
I am not able to use the phone at all.
Need some help. Is there a way to go to stock firmware or to remove this CWM recovery to take it to whatever android stock firmware version it was.
Please help.
Download stock rom from Samfirmware, flash with Odin (How ? Thread stickied near top of Q&A has all the info you need). Clean slate.
Then flash custom kernel to root your phone & give you CWM. Flash custom rom/kernel of your choice.
MistahBungle said:
Download stock rom from Samfirmware, flash with Odin (How ? Thread stickied near top of Q&A has all the info you need). Clean slate.
Then flash custom kernel to root your phone & give you CWM. Flash custom rom/kernel of your choice.
Click to expand...
Click to collapse
I don't know the stock rom in my case. my SSN number is I9100GSMH. Can you please help.
In case if I want to upgrade from stock ROM to custom ROM jelly bean 4.2.2, then can you suggest steps for that or give me link for that...
guys my samsung sgs2 wont boot up stuck on the sII logo screen and shuts down but working on recovery mode and i also tried restoring my back up but still the same happens.
my s2 is rooted and running beanstalk 4.4.2
Recovery mode = factory reset. If that doesn't work, stock rom from Samfirmware, flash with Odin. Problems with Odin flash ? Hopper8's 'Odin troubleshooting' thread stickied in General has all the info you need to get a successful flash (you may need to do a factory reset as well after the Odin flash if you end up doing this). Once you've done that, re-root your phone & try restoring your nandroid, or reinstall custom rom/kernel & start from scratch.
MistahBungle said:
Recovery mode = factory reset. If that doesn't work, stock rom from Samfirmware, flash with Odin. Problems with Odin flash ? Hopper8's 'Odin troubleshooting' thread stickied in General has all the info you need to get a successful flash (you may need to do a factory reset as well after the Odin flash if you end up doing this). Once you've done that, re-root your phone & try restoring your nandroid, or reinstall custom rom/kernel & start from scratch.
Click to expand...
Click to collapse
already factory reset and tried flashing my custom rom again but still that happens.
can you give me the link where to download the stock rom? but i dont know my baseband version.
Samfirmware (Google it). You don't need to know whatever baseband you have (it's irrelevant anyway), download any stock rom for your carrier/country (not 4.0.4) given you'll be going back to a custom rom anyway.
MistahBungle said:
Samfirmware (Google it). You don't need to know whatever baseband you have (it's irrelevant anyway), download any stock rom for your carrier/country (not 4.0.4) given you'll be going back to a custom rom anyway.
Click to expand...
Click to collapse
my s2 was bought in las palmas spain. and im on philippines now.
will i download those 4.1.2 version??
'download any stock rom for your carrier/country (not 4.0.4) given you'll be going back to a custom rom anyway'.
Won't be repeating myself in this thread again. You should already know this stuff if you're modding your phone in any way.
Hi I want to know how to flash the stock ROM on the SM-G965U. Where should I download the firmware and what should I use to flash it?
Download the firmware on sammobile and flash it using odin.
or alternatively use the 'samfirm' program (google it) and plug in your phone...click the find firmware and DL it. Then odin it back to stock.
Is their a one ui firmware for g965usqs3arg8
There're 2. Which type is yours. Please do not upgrade from custom. Flash ARG8 official then upgrade.
ARG8