[Q] Issue with Odin and i9100 bootloader - Galaxy S II Q&A, Help & Troubleshooting

<ID:0/005> Added!!
<OSM> Enter CS for MD5..
<OSM> Check MD5.. Do not unplug the cable..
<OSM> Please wait..
<OSM> I9100XXLPQ_I9100OXALPQ_I9100XXLPQ_HOME.tar.md5 is valid.
<OSM> Checking MD5 finished Sucessfully..
<OSM> Leave CS..
<ID:0/005> Odin v.3 engine (ID:5)..
<ID:0/005> File analysis..
<ID:0/005> SetupConnection..
<ID:0/005> Initialzation..
<ID:0/005> Get PIT for mapping..
<ID:0/005> Firmware update start..
<ID:0/005> boot.bin
<ID:0/005> NAND Write Start!!
<ID:0/005> Sbl.bin
I flashed rom through Odin and its return is like this.
The Sbl.bin is likely to be related to the bootloader.
I cannot access to the recovery or normally reboot.
What can I do?? I tried flashing for several times.
Zillions of thanks if you guys can help me!!!!

---

What is your device?

---

aceofclubs said:
What is your device?
Click to expand...
Click to collapse
i9100 of course.

---

superfan' said:
i9100 of course.
Click to expand...
Click to collapse
Why did you start a new thread? You already had a perfectly good thread going for the same problem here: http://forum.xda-developers.com/showthread.php?p=24175814.
And you've apparently decided to ignore all the advice in that thread that said to flash back to a stock GINGERBREAD firmware, since you again are trying to flash LPQ, which is one of the earlier ICS releases.

---

superfan' said:
i9100 of course.
Click to expand...
Click to collapse
Not of course. Because the problem you describe is what happens when you try to flash I9100 firmware on a model like I9100G or others that are called SGS2 but are different hardware. Only true way to tell is read the sticker under the battery.
Anyway forget this thread and take the advice in the other thread and report back there.
Good luck.

---

ctomgee said:
Why did you start a new thread? You already had a perfectly good thread going for the same problem here: http://forum.xda-developers.com/showthread.php?p=24175814.
And you've apparently decided to ignore all the advice in that thread that said to flash back to a stock GINGERBREAD firmware, since you again are trying to flash LPQ, which is one of the earlier ICS releases.
Click to expand...
Click to collapse
I tried to flash KI3, the gingerbread, it still fails. I think it is a new problem, and it is related to the NAND rw corruption mentioned by others. Therefore, I started a new post but not ignoring others' advice.
If you can help me with my problem, zillions of thanks then.

---

Flash a stock GB rom and see what happens .
jje

---

Given you say you've tried everything suggested, and given you think it's a bootloader issue, there are literally dozens and dozens of posts on here about same.
Do a Google search (rather than using XDA search), and append 'XDA' to whatever your search terms are.
This problem you're having is not common, and you're not going to find a fix easily for this (as you're discovering) short of having it JTAG'd or sending it to a Samsung service center.

---

Is samsung customer service accepted to handle this, even i have some custom binary no?
Or if i pay some money, they wll fix that for me??
Sent from my GT-P7500 using XDA

---

Yep. They'll fix it, but you'll more than likely end up paying for it. A JTAG repair might be a cheaper option. Here's one in the US, I'm sure there are many others around the world (maybe near you, search Google).

---

Can you still enter download-mode (Vol. down + Home Button + Power Button)? If so, you can try these steps in this Guide here
Be careful with Re-Partition..i ruined my device some days ago with it after try to fix nand rw corruption.

---

I have tried all of those before. But i even can't flash things through. Even vthe kernel, recovery and bootloaders.
Sent from my GT-P7500 using XDA

---

So when you try to flash a 3-Part Firmware (without Re-Partition) it stucked again?
PS: Be very careful .. I has a very similar problem and with Re-Partition I shoot it up -.- (http://forum.xda-developers.com/showthread.php?p=24115788#post24115788)

---

What have you done to shoot it up??
I stucked even i flashed a three part firware without repartition and pit file
Sent from my GT-P7500 using XDA

---

Hey,
I'm sorry but i didn't solve the problem for me. With "shoot it up" I mean "i killed my phone". Sorry for that mistake!
I followed the guide too but at first step I flashed with Re-Partition and PIT file. Odin stucked at "Partitioning" so after 10min I closed Odin and restart S2...after that my device was completly dead. Screen stays black. Sorry don't know how to fix it. My S2 is on the way to rapaircenter now.

---

Aur0r4 said:
Hey,
I'm sorry but i didn't solve the problem for me. With "shoot it up" I mean "i killed my phone". Sorry for that mistake!
I followed the guide too but at first step I flashed with Re-Partition and PIT file. Odin stucked at "Partitioning" so after 10min I closed Odin and restart S2...after that my device was completly dead. Screen stays black. Sorry don't know how to fix it. My S2 is on the way to rapaircenter now.
Click to expand...
Click to collapse
I can access to the download mode but I can't flash anything through my beloved s2.
I am going to send it to the repair centre, u suggest me to send them to Samsung's or others??

---

Go into recoverymode and install a rom in ur memory internal or extaernal

---

Just do that turn off phone...and them volume up+power+home button u will enter in recovery mode not in download mode...now just search the rom ...notice u do this if its rooted... Look if u just put insecure kernel by odin i sugere u take sd card out download a rom by computer to sd card. input again in phone and turn on in recovery mode... i think will works im not responsabile for nothing can happened but im pass the same like i write...tell something
Sent from my GT-I9100 using XDA

---

Look the guy up say to you a dificult way to do and also u may brick ur phone...u do somethings in odin i just never do...i just saw now otherwise u already fix it if i put this earlier
Sent from my GT-I9100 using XDA