After doing a load of work on my x8, I decided to fix my x10 mini that's been lying around.
The first problem I encountered was the fact that it automatically boots up when it's been shut off, being the reason I stopped using it.
Second problem is that I can't seem to boot it in flash mode. The problems may be connected.
I've installed the drivers needed through flashtool and it works fine for my x8, but when I shut down my x10 mini and hold back, it just wont connect. The screen stays black and nothing happens...
I've searched for a while and haven't found anything, but then again I'm not known for being a thorough lurker.
Any help would be appreciated.
I'm a bit confused here.. your phone automatically restarts when you turn it off, but when you try to connect it in flash-mode it does nothing? not even start?
Anyway, to me it sounds like your powerbutton gets stuck a bit every now and then, which might explain it automatically restarting after you turn it off, and if it's stuck it might prevent you from entering flash-mode too. My two cents...
Related
Hi, I have a Xperia x10 mini and I turned it off so I could charge it up. After it had charged I turned it on but as soon as it turned on I started to use it and it turned off. Ever since then it keeps turning on, getting to the Sony Ericsson Logo switching off then rebooting again. I have literally tried everything. I tried to reboot it by holding down the middle button and the power button. I've tried to reinstall the firmware using PC companion. By the way it is rooted as well.
Is this phone completely messed up?
Hey guys, don't worry I fixed it by doing a complete restore.
Hi,
my Xperia SP got under a stream of water recently, and since then I've been fighting to bring it back to life.
I had a problem with the hard power-off button being constantly in pressed state, but I fixed it somehow.
Right now I am able to access fastboot and flashmode, however the phone gets stuck at the bootloader screen when I try to turn it on (kernel recovery isn't accessible, leds don't light up).
One weird thing I noticed is that when I just plug USB to the phone, instead of going to "charge-mode", it just enters flashmode?
I tried re-flashing the kernel, and the whole ROM, but it didn't change anything.
Is there anything else I could try?
Any help much appreciated.
Hi. My xperia Neo crashed, I tried to send a photo via bluetooth and the phone just turned off. I tried to turn it on, it appears the "SONY" screen, then the "XPERIA" screen, and then it restarts, over and over again with the same 2 screens. I searched topics, they say that I have to flash it, but I can't start the phone in flash mode, with power and back buttons, any software (Companion, flashtool) don't detect the phone. Is there any solution?
Just like death
adrianoancea said:
Hi. My xperia Neo crashed, I tried to send a photo via bluetooth and the phone just turned off. I tried to turn it on, it appears the "SONY" screen, then the "XPERIA" screen, and then it restarts, over and over again with the same 2 screens. I searched topics, they say that I have to flash it, but I can't start the phone in flash mode, with power and back buttons, any software (Companion, flashtool) don't detect the phone. Is there any solution?
Click to expand...
Click to collapse
Hi, I´ve got similar problem. A year ago my Neo V went dead (I thought so). Just for fun, I tried to connect it to PC yesterday and what happened? It started charging and after few minutes I started it (YAAAY)! So I thought It was just some bug that disapiered after discharging. So I did a hard reset, to gain factory settings, repair the firmware via PCcompanion, everything was OK until I shove a memory card inside. After that it died again. Its not charging, no reaction after connecting to PC, no reaction on ON/OFF button, no reaction for button-hard-reset, no response while trying flashing with EMMA or FLASHTOOL, nothing... Does anybody knows what to do with it or do I have to wait again until it discharge and pray it would work after that?
help
I have the same problem as you did it to solve? :crying:
Hello,
This is my first post so i hope that this is the right place.
I have a serious problem. My K910 is endlessly rebooting.
It all started after i updated android from 4.2.2 to 4.4.2 When device rebooted after installation it never came further than lenovo logo.
When phone turns on, it vibrates, then lenovo logo comes out for 2-3 seconds then it dissapears and the loop starts again.
it shuts down only when i push power button and volume- button multiple times.
I have tried to enter recovery/safe mode, but with no results phone keeps rebooting.
I reinstalled battery but still as i turn the phone on, same problem occurs.
As soon as i connect my phone to pc phone turns on and endless loop starts again.
Questions:
How can i change to stock ROM or connect to PC in this situation since it keeps on rebooting my pc doesnt see added device?
What can i do to fix this situation?
Please Help.
I promise $feedback if this thing can be fixed
trusis16 said:
Hello,
This is my first post so i hope that this is the right place.
I have a serious problem. My K910 is endlessly rebooting.
It all started after i updated android from 4.2.2 to 4.4.2 When device rebooted after installation it never came further than lenovo logo.
When phone turns on, it vibrates, then lenovo logo comes out for 2-3 seconds then it dissapears and the loop starts again.
it shuts down only when i push power button and volume- button multiple times.
I have tried to enter recovery/safe mode, but with no results phone keeps rebooting.
I reinstalled battery but still as i turn the phone on, same problem occurs.
As soon as i connect my phone to pc phone turns on and endless loop starts again.
Questions:
How can i change to stock ROM or connect to PC in this situation since it keeps on rebooting my pc doesnt see added device?
What can i do to fix this situation?
Please Help.
I promise $feedback if this thing can be fixed
Click to expand...
Click to collapse
That means your phone is in bootloop. Try opening recovery and wipe cache/data . If you got a custom recovery, then its much better.
Hello,
Also i experienced similar problem with a defective battery,
after i removed it too much,
fixed by replacing it,
hope it helps.
Hi guys, I have a samsung galaxy j600fn/ds, tryed to flash twrp, something went wrong and now I'm locked on the ''Samsung'' logo screen
I guess it is brick, though I'm totally stuck at the screen, the phone won't even turn off, so I don't know how to acces download mode to install stock firmware.. anyone can be of help?
EDIT: solved.. of course the solution was just to wait for the battery to be completley depleted, I just got scared there not beeing able to do anything
Wait-
So you just let your phone in bootloop all night (?), then you charge it without turning it on,
waited till 30%, and then you put it in download mode and installed the firmwere?
Does it really work? 'cause I tried to do that before, and the bootloop stopped. I tought I ended up into an hard brick.
I pressed powen and tried to put the phone into download mode, but nothing.
I put the usb on my pc, and odin was actually reading it, so I tried again and again to get into the download mode.
Afret 30 minutes, i pressed power again, (and finally) the boorloop restarted.
Well um.. the phone now is probably at 60%.. I hope it wont stop again, and I hope this method will work.