i have a titan 2 and the screen seems very loose. i can put my finger in between the bezel part and the glass screen and it takes almost no effort to pry it out and move it around. if i press anywhere on the screen, even just lightly, the light "wave effect goes through the entire screen and its very annoying. anyone else have this?
anyone?
I don't have a Titan 2, but I doubt this is more of a generic issue. If it's not been water damaged or dropped, I think you've been supplied one of the faulty pieces. The wave effect through out the screen could be your digitizer.
Related
Capacitive Buttons on my phone seem to not always work, sometimes takes 2-3 presses anyone else experience this? Is it my screen protector? Defective phone or just "part of the phone"?
I'd say it's the screen protector. I sometimes accidentally press mine twice because I only draw my finger back a little bit, thinking it's off the screen(It's not.)
I got used to hard buttons and a resistive touchscreen, so I'm still getting used to exactly how sensitive this screen is.
Point is- I'd take off the screen protector. Unless you bathe your pockets in tungsten, diamonds, or sand, your screen isn't going to scratch. I've tested mine with pocket knives, keys, razor blades, and everything else I can think of that would scratch my old phone. Nothing. It's tempered glass- it's not going to scratch very easily at all. I've had mine for two weeks now, no protector, and there aren't even any tiny scratches, and I'm not careful with it at all. Heck, I have a silicone case on it, so I can actually drop it about a foot without worrying at all about the screen shattering. It's a very well built device. (I don't suggest dropping it, it deserves better, but I was testing.)
Ok so I was wondering if any one knows what this is. My dinc 2 screen will pretty much resist face oil and finger prints alright on the top half of my screen. But the bottom lower half gets extreamely smudgy. I can rub it across my face and I can see the the halves clearly. Not sure if some coating got taken off or what what it's really anoying. I've used all maner of screen cleaner on it and it wont fix the problem. thoughts?
The bottom half might have worn off due to higher usage of the bottom half, keyboard etc.
Just a thought
I recently changed the screen on my note 2. When I put the new glass on i noticed it looked like a water mark when I pressed on the screen. The top half works fine when I touch it and the entire screen works fine with the s pen. would the LCD glue fix the problem?
I'm pretty certain it would. You need adhesive between the digitizer/lcd combo and the glass screen. That's how it is stock.
I hope so.
I have the Le Max 2 X820. It's about 14 months old. Tonight I noticed light seeping from under the screen. It's then that I realized that the screen was separating from the frame.
I powered it off, used very thin tweezers, dipped super glue on the tip of the tweezers, and ran glue along the length of the frame of both the back of the screen and the frame. I then used a flat book to apply pressure to the screen to make the best seal possible. Unfortunately, a glass screen protection won't make a tight seal over the screen now. Everything is working mechanically though with the screen.
Hopefully, it'll hold. Has anyone else had the same issue with the screen separating on the Le Max 2?
Yes. But I doubt your solution to be helpful in the longtherm.
In my case it was the battery pressing the screen out of the frame, because of the cells inside inflating.
Maybe you should be thinking about changing the battery or starting with a battery health check.
My Poco fell out of my hand and luckily I had high quality tempered glass. Display was alright but tempered glass shattered So I removed it after examining the screen I noticed this single White Dot.
It's nothing, barely visible, but every time I see it I feel terrible. Is the screen broken or is it something else? Has anyone faced this problem? Please help.
That's a pressure point or dirt spot. I have a feeling something got displaced when you dropped it and is now adding pressure to the screen from behind. LCDs are very sensitive. Can also happen due to long term bending while in pant pockets.
Same can be seen on laptop screens as well. For example check the image attached of my laptop. Has been there due to pressure from bezel after a hinge break.
You can just go ahead and ignore it, imo.
tatiraju.rishabh said:
That's a pressure point or dirt spot. I have a feeling something got displaced when you dropped it and is now adding pressure to the screen from behind. LCDs are very sensitive. Can also happen due to long term bending while in pant pockets.
Same can be seen on laptop screens as well. For example check the image attached of my laptop. Has been there due to pressure from bezel after a hinge break.
You can just go ahead and ignore it, imo.
Click to expand...
Click to collapse
Thank you for helping me out; I really appreciate your support. I was about to open this device to fix this but I guess I'll just have to ignore it.