Would anybody happen to know how to lower the vibration intensity in CM9? It's kind of odd, but whenever the vibration is on, it's so loud that it rattles something up near the earpiece and it's just annoying when it's at it's highest setting. I've recently been using ROM's such as Alliance and Padawan and they both had a setting for Vibration Intensity in the settings and you were able to slide them to your desired intensity. But now that I switched to CM9 I kind of miss that feature. Lowering the intensity about 2 levels using the slider was perfect for me because it didn't vibrate loud enough to cause the phone to rattle.
Is there a way to edit the intensity settings for vibration in CM9? Perhaps through the build.prop or some other method? Thank you to whoever replies.
Related
As long as I've owned my phone (~ 1 month), my notification vibrate has been great. If it was on a hard table, it was loud enough to scare the crap out of me, but more importantly, I could easily feel it in my pocket. Recently, apparently after turning off the notification vibrate for a little while (so that I could leave it on a table without jumping), the vibration intensity is extremely weak. I makes a small buzz on a table, and I can't even begin to feel it in my pocket unless the screen is facing out (which sounds like a great way to get a cracked screen).
Changing the vibration intensity under the settings only changes the haptic feedback intensity, not the notification intensity. I can't find a setting for that anywhere - has anyone else had this problem? Anyone know the solution?
apparently (from what i've gathered) the haptic feedback intensity controls the vibration intensity for the ENTIRE phone. So make sure your intensity is all the way up before you turn off haptic feedback otherwise your vibration will be extremely weak.
I saw that looking through old threads. I usually have haptic feedback on and the intensity set at about halfway, but maxing it has no effect on notifications.
One other note - it seems that my incoming call vibration is strong. Unfortunately, I'm not entirely sure if it had dropped and is now back to where it was, or if it stayed at the same level while my notification level dropped.
Opposite Effect
Anyone confirm this or is there some other way to adjust the global vibration? Mine is way too strong and rattles the volume buttons on my phone. My girlfriend and her two daughters also have Vibrants and I've compared mine with all of theirs. Mine is extremely intense. My girlfriend joked about borrowing it for a while.
Anyone know of anything I can do? A service menu or something? I've been searching and this thread is the best I could find.
Ive just got a samsung galaxy s 2, my question is has anyone else noticed that the vibration is really strong so much so that it creates another sound from the phone?
Sent from my GT-I9100 using XDA
Yes, at least for me, the phone turns into a pneumatic hammer when it vibrates... phone goes for repair :/
Oh yours sounds more serious i guess. It jus sounds as if the vibration is major strong. Like the sound is vibrating against the back panel or something i guess. Wondering if its just a characteristic when thd intensith is high. Ive lowered the intensity and downloaded a vibration app which together eliminate the problem
Sent from my GT-I9100 using XDA
This is usually not a harware fault, but the way the software was created.
In some ROMs you can go to settings>sound and change the intensity of the harptic feadback or just disable it completely.
the vibration on this particular phone is new to me, i dont get any back panel vibrations in the haptic feedback setting,but when i use rotary lockscreen and move the rotary slowly to put it on silent mode it makes a strong vibration and makes a distorted humming sound.
Yea thats right repub, using the haptic feedback is nice but when you lower the volume to vibrate mode or use a toggle switch wudget to vibrate mode theres like a vibrate noise aswell as sonethibg else right? This is the noise of how strong the vibration is i think bouncing off the back panel or battery etc
Sent from my GT-I9100 using XDA
I was wondering if anyone had the same problem or knows of a solution. Is there a way to control, through settings or an app you can download, the vibration intensity for notifications and calls. I've noticed at work that if I have my phone on my desk or pocket that the vibration is clearly audible and noticeable by people around me.
I've tried Vibe but it seems to only be for calls and focuses on vibration pattern.
I'm running HOX+ stock and unrooted.
Hey guys,
I'm using Slim Series PAC 4.2 but there is only one problem for me. It's vibration intensity. When my phone vibrates, it's making a noise, and vibration is really strong. How can I set vibration intensity? On Vibrate Config app, I can't. I think I can do it on build.prop or maybe something.
Thank you in advance.
Im having some problems with the vibration of incomming calls. Its to strong for vibration. And you can hear it. I looked in the settings if there is an intensity slider. But there is none. There is an intensity slider for the keyboard. So I figured out that it is possible to set the intensity. Not in the original settings I guess. So I add an app called vybe where you van choose your vibration length. But if the phone is in vibraton mode it plays the first vibration from the phone, and then it will play the vybe one. Sollution was to set viber on silent mode. That way I dont get the annoying very hard vibration from the phone. But I lost the Silent mode. Is there any way to adjust the vibration in an other way. Thanks in advance.