I have an issue with my i9001:
I installed CM9 (2 RCs) for a while but it was still buggy for me. Then I decided to go back to GB. Since I went back the wifi switches off immediately after switching it on. I switch it on. It starts scanning and it switches off again. The device does not connect to a wifi AP.
Currently it is running GIGABREAD+, but it did exactly the same with the original stock ROM which I saved on the SD card and installed again.
If I do a WiFi driver test (*#*#526#*#*) it states that the wireless driver loaded successful.
Han_Desire said:
I have an issue with my i9001:
I installed CM9 (2 RCs) for a while but it was still buggy for me. Then I decided to go back to GB. Since I went back the wifi switches off immediately after switching it on. I switch it on. It starts scanning and it switches off again. The device does not connect to a wifi AP.
Currently it is running GIGABREAD+, but it did exactly the same with the original stock ROM which I saved on the SD card and installed again.
If I do a WiFi driver test (*#*#526#*#*) it states that the wireless driver loaded successful.
Click to expand...
Click to collapse
What I also tried:
Remove all stored wifi APs
installed the broodkernel V1.2
issue is still the same, but with Wifi connection manager you actually see the available access points for a little while and then it switches off again before you can actually connect.
Han_Desire said:
What I also tried:
Remove all stored wifi APs
installed the broodkernel V1.2
issue is still the same, but with Wifi connection manager you actually see the available access points for a little while and then it switches off again before you can actually connect.
Click to expand...
Click to collapse
I think I found the solution in the end:
I recovered a backup with titanium backup. Not a full backup because I knew this would cause issues. However I did put the backup back of the stored AP's and that caused the Wifi to crash all the time. I installed the GIGABREAD+ Rom again and now without the backup recovery and it all works fine. Maybe this can help others with troubleshooting
Related
My legend's WIFI didn't work suddenly....
I haven't do any wrong on it, when I turn the wifi on, it indicated it was turned on but it search no network......
I have re-flashed the rom and it was not slove.......
how can I do??
FIXED!!!!
Infos?
Hi, can you indicate what ROM you're using?
on b 0.8.4 there is a patch needed for some phones. (just look in second post of the thread.
If you changed your ROM: do a wipe and cache clear (Backup before!)
greetz
alexkno said:
Hi, can you indicate what ROM you're using?
on b 0.8.4 there is a patch needed for some phones. (just look in second post of the thread.
If you changed your ROM: do a wipe and cache clear (Backup before!)
greetz
Click to expand...
Click to collapse
I am using CM7, it works fine before, and I haven't update until I get this problem. So I update the rom from nightly to stable one. But the problem still exist
What can I do to fix it??
seifer007 said:
I am using CM7, it works fine before, and I haven't update until I get this problem. So I update the rom from nightly to stable one. But the problem still exist
What can I do to fix it??
Click to expand...
Click to collapse
Me and a few others had the same problem - try rebooting your router.
finally fixed, I wipe all the data and cache, then re-flash the CM7.
you guys can try~~
maybe it should have been enough only to delete and re-establish the WIFI connection. I had the same issue when I added a another WiFI connection. After deleting all my connection points via the CM settings there was no problem anymore.
So, just if it happens again
alexkno said:
maybe it should have been enough only to delete and re-establish the WIFI connection. I had the same issue when I added a another WiFI connection. After deleting all my connection points via the CM settings there was no problem anymore.
So, just if it happens again
Click to expand...
Click to collapse
i have a threat sbout wifi issues on my legend cm7. But im trying to resolve. i didn´t know about that tip on cm settings.
yesterday i connect to a network, todsy i didn´t see again. but i did clean install... but really it isn´t working 100% my wifi.
I like cm7, gps is good now, but wifi is buged.
Edit: where is the option to delete wifi connections?
Settings - Wireless and network - Wi-Fi Settings - Long press on SSID name and select "Forget network"
Then get in range and reconfigure your wi-fi connection.
maybe also changing the range of wifi channels may help (settings/networks/wifi-settings - then menü button - advanced/ domain) of course only with active wifi working.
Hi,
Hope someone can help. My Hp TouchPad with webOS 3.0.4 has a problem with Wifi connection. The wireless networks at college is recognised and is connected when I try. My problem is that when I bring up an internet page it gives me an error message that says"No Internet Connection".I have a number of other devices connected to my college wifi and they are all fine.
Hope someone can help.
Regards,
kailash kaushik
Take a look at this thread: http://forum.xda-developers.com/showthread.php?t=1494458
I assume you are running CM9? I flashed the firmware update that can be found here (http://forum.xda-developers.com/show...3&postcount=61) and I haven't any any trouble since.
Different partches available
its been observed if repeated chaches wipes dont work.. then try restarting the touchpad helps. also sometimes "forget"your existing wifi connection and re-enter the password. Also there are plenty of patches released by each of the different versions of touchpad. without knowing your version its hard to focus on the solution. please specify the version you have flashed your tp.
Hope it helps
wipe and reinstall
I had this issue. When connected to 2.4GHz networks for the first time, it works fine untill either the wifi radio is turned off/on again it does not connect. I would have to forget the network. turn off the wifi. turn on wifi. it would then recognize all networks, including 5Ghz, and then I can connect to the 2.4GHz networks again by entering the password. This happens when I reboot my HP Touchpad as well.
One simple fix, surprisingly, is not on the HP Touchpad itself. It is on your home wireless router. I changed my router's broadcast radio channel from 11 to 1. Issue resolved. Try changing your router radio channel to something different from what it is now.
If that does not work, then leave it at the new channel. backup everything and wipe/restore. I enabled the google account backup. after a restore, it downloaded all my apps automagically. My saved games were not saved however, so make a NANDROID if you're OCD about your saved games. My pictures were still on there tho.
download the latest KANG nightly build into a folder such as CMINSTALL when you initially installed CM9. reboot to clockwork mod and do a factory restore. under advance menu, wipe the dalvik cache and all cache. reinstall the KANG nightly build you downloaded and start fresh. the unit should automagically download all your apps. make sure you enable non-market app installations if you have non-mark apps installed. AKA from unkown sources.
Ok, have 2 problems.
Rom=Polish Blood
Kernel=sirkay's latest kernel
-----------------
1) My WiFi stopped working, it goes in loop; Connecting->Autentification->obtaining IP adress, and so on few loop's, and after few loops it shows "Avoided poor Internet connection"
2) app for voice record, which is set to start on each reboot, stopped starting, I can start it manually and it works, but it wont start itself.
-----------------
Kernel is not the issue, router is not an issue, looks like something messed up in rom.
I tried flashing kernel again(switching to old version) no help, old nandroid backup working fine.
Reinstalled voice app, no help.
Tried deleting /modules folder before boot, as I understand that folder is filled from kernel on boot, and after that modules are pushed to /sys/module, right? again, no help.
Tried cleaning dalvik-cache, cache, no help.
-----------------
I could easily switch back to nandroid backup, but that's not the point would love to see where is problem in all this..
-----------------
-----------------
1) WiFi problems solved by turning off WiFi, deleting everything in data/misc/dhcp, turning wifi on.
2) app for recording stopped working after su binary update
For Nr.2 did you move the app to the SD card? Cuz you should never move anything that needs to start at boot to the SD card.
SCHUMI_4EVER said:
For Nr.2 did you move the app to the SD card? Cuz you should never move anything that needs to start at boot to the SD card.
Click to expand...
Click to collapse
Thanks for the try, but no, I never move any app to sd.
I was playing a game before sleep, and after exiting game, I noticed that app was turned off, I thought game killed it from memory, because it needed some ram. And it happened before, but after some time, or after restart, app would turn on, but not this time.
I recently restored my old inactive CMDA Sprint Evo 3D back to stock 2.17.
After booting it up, I connected to WiFi and successfully obtained an IP and connected.
I am restored to fully stock with S-Off with a Locked bootloader.
When I try to open the market or web browser I don't have internet.
The web browser says "Web page not available".
I am connected to the WiFi network on other phones and this computer, so internet is working.
Tried multiple PG86 .zip restores and RUU .exe restores.
Even wiped /Data, /System, /Cache and then restored using the PG86 .zip, so there were no files that might be left behind causing issues.
Can anyone help me fix my WiFi issue?
More info please
Thank you for the reply but that's really all that I have.
It's a Sprint CDMA Evo 3D currently restored to stock using RUU_Shooter_ICS_35_S_Sprint_WWE_2.89.651.2_Radio_1.09.00.0706__NV_NV_SPCS_1.43_release_271101_signed.exe.
During setup, I connect to my WiFi and it connects successfully and shows full WiFi bars in the notification bar. I also tried skipping wifi during setup then connecting normally from the wifi in the settings menu.
When I try to use the internet, nothing will connect. Browser wont load a page and play store wont connect, wont even log into my google account.
Feels like the phone is blocking internet access, like though a firewall or hosts, but it doesn't have any additional apps installed and the hosts file is original stock since my /system partition is locked from the restore.
I just did the HTC official bootloader unlock, thinking the wire trick unlock may have been causing it, but it didn't help.
What other info would be useful?
EDIT: Just flashed CyanogenMod 11 with Android 4.4.4 and WiFi is working. No idea why stock won't work but AOSP does.
So, the weirdest thing happened to me... I installed an app named WiFi Connection Manager from roamingsoft to play around, and I asked this app to blacklist my home wifi.
I then asked to un-blacklist it, but that failed, and ever since I cannot connect to my home wifi anymore: when I insert password it lists my wifi as "saved" but it won't connect.
Things I tried that did not work:
change wifi name
change wifi password
change wifi channel
reset bits and piece all the way down to factory reset the phone, install a different rom* and go back to original rom
* more on that below
Things I tried that did work:
change rom to lineage OS
change rom from android 9 to 8 (both original android one rom from the phone brand) (but going back to the original rom version 9 fails again, even tho I flashed form a newly downloaded file with nothing to do with the version I did somehow corrupt, and before I even logged in to android, so the phone did not even know it was the same user)
change the security of my wireless from wpa2 to something else (wpa/wpa2 for example)
oddly enough if I change wifi settings to have the same wifi name shared between my 2.4ghz and my 5ghz wifi, my phone will connect to the wifi, and it will connect using the 5ghz (the problematic one).
---
i also have the feeling a corruption to my nfc happened at the same time, but I don't know for sure, in case someone knows of a connection between the two problems let me know, but the nfc never worked on other roms.
When I flash a new image I flash a number of partitions including one named bluetooth, so I can't imagine which partition I am leaving untouched that has the blacklist in it...
Does anyone have an idea how an app -even if it had root privileges- could cause such low level damage, and more importantly how I could fix it?