Hello guys,something terrible happened to my phone, i pulled it out of my pocket and surprise!! broken display, no drops, no scratch,just appear damaged for no reason, actually the phone has a case, its the verizzon version, I would like to ask you if the warranty covers this kind of damage or where I can buy the original display no OEM version because i think dont have the same quiality than the original display, please help me, any kind of information will be appreciated, thanks so much,
Just the display, the cover, and the Screen Digitizer are intact
sorry for my terrible English
Related
Hello, my friend recently dropped her S3 from a very low height and the touch screen no longer responds and now looks like this
"attached picture"
I dont want to take apart the phone unless it is a possibility that it is just a loose connector. If it for sure needs a LCD replacement, I might as well send it off to samsung as it would cost the same for the part anyways and leave the phone a virgin.
Thanks for any input!!
not a loose connector, send it in
Hi, I'm new here and sorry to bother ya all, but I have a problem that I have discovered lately with my Prime. One section of the touch screen seemed to be unresponsive to touch, it's only about 1cm from the left bezel when viewed in landscape mode, for some reason it just won't respond to touch anymore, is this a software problem or something's wrong with the hardware? I'm very reluctant to send it for repairs because I needed it. Would appreciate any kind of help, my prime is running on Android 4.1.1, stock Asus software. Thanks
Probably hardware. Try a factory reset but I doubt it would work. ASUS will replace the screen for you under warranty. The screens are very bad quality. Mine has been replaced twice in RMA. Also a new motherboard, casing, 2x batteries, camera, wifi pcb's. Pretty much a new device.
Hey all,
In advance I am sorry if this post is in the wrong section, I noticed there isn't a section dedicated to my particular phone so I just guessed this would be the best of the worst.
So here's the problem. A few days ago my phone fell on the street and the LCD screen got distorted on the left side. It is kinda hard to explain but the problem is that the pixels of the left side of the screen refresh very slowly (if at all). The problem is worse when you get to the edges of the left side of the screen. I attached some pictures so you can see what exactly the problem is.
So obviously my phone needs to be repaired and I would like to do it myself but, as the noob that I am, I don't quite know "what" should or could be repaired.
So here is the first questions:
- If you look at the photo's, do you think the LCD screen is the only thing that is broken?
For the follow-up question is a bit of extra information required. My phone is a strange model so I actually can take out the LCD screen because it is not glued to the touch screen. I've done a bit of experimenting and I already took the phone apart quite easily and dismantled the LCD screen.
So here is the follow-up question:
Is there a way to repair the LCD screen (assuming that it is the only thing that is broken)? Or do I need to replace it?
Thanks in advance,
Tyred Mayfly
Good evening!
My S3 has just fallen down. Now only physical buttons, back and menu are working. Screen has no physical damage but the digitalizer is not getting ANY of my touch. This makes me thing that it can be the internal connections. If it was broken I believe some screen zones would be still recognised. Then, I believe (and hope) digitalizer is in a well state. What are your thoughts about this?
Apart from this, how can I open the phone to check the connection. I've seen videos in which they replace the screen but I don't know if I can follow this procedure since, if it is still working, I don't know if I could re-glue it again.
Please, what can I do?
Thanks!
paco_ramirez said:
Good evening!
My S3 has just fallen down. Now only physical buttons, back and menu are working. Screen has no physical damage but the digitalizer is not getting ANY of my touch. This makes me thing that it can be the internal connections. If it was broken I believe some screen zones would be still recognised. Then, I believe (and hope) digitalizer is in a well state. What are your thoughts about this?
Apart from this, how can I open the phone to check the connection. I've seen videos in which they replace the screen but I don't know if I can follow this procedure since, if it is still working, I don't know if I could re-glue it again.
Please, what can I do?
Thanks!
Click to expand...
Click to collapse
It is very possibly your digitizer can be broken but not show any physical damage. If it happened right after a fall then this is a real possibility.
Do not try to pull the screen sections apart you will damage it. Get a new whole screen assembly
Thank you very much for the answer!. Could you please send me a reference of the whole screen assembly I need? You mean digitalizer plus lcd? just digitalizer? Could you provide me a good but cheap one?.
paco_ramirez said:
Thank you very much for the answer!. Could you please send me a reference of the whole screen assembly I need? You mean digitalizer plus lcd? just digitalizer? Could you provide me a good but cheap one?.
Click to expand...
Click to collapse
You will need the glass, lcd and digitizer. The term "whole screen assembly" should be enough.
Thanks for the info. I've seen prices of this replacement set and it's about 100$ (80€). I don't think I should pay so much for a 2-year phone. I am thinking about taking a Xiaomi redmi note 4g for 169€.
paco_ramirez said:
Thanks for the info. I've seen prices of this replacement set and it's about 100$ (80€). I don't think I should pay so much for a 2-year phone. I am thinking about taking a Xiaomi redmi note 4g for 169€.
Click to expand...
Click to collapse
Yer it is pricey, atleast in my country almost just as expensive to by a new s3 rather than get a new screen when you way up the aspects of a new phone plus the warranty
Hi
My friend broke his Z2 and asked me to try and fix the screen...
I already did this procedure a few times on other phones (Galaxy S3). I'm pretty confident I can do this easily, I have a few questions though.
I should just get him the full LCD/glass/digitizer assembly right? Although his LCD display seems to still function. The other stuff seems like a pain in the ass to install (although his LCD display seems to still work...)
He shattered the back panel too and doesn't care about that. But I'll have to replace the back glass anyway right? You have to remove it to change the front glass LCD etc right?
I never had a Z2 in my life so if you have any tips or info I probably don't know about this repair I'll take it
Thanks.
you have to dissasmble the entire phone, very difficult.
see here: https://www.ifixit.com/Guide/Sony+Xperia+Z2+Display+Assembly+Replacement/34650