[Q] Poor wifi signal - Droid Razr Maxx (XT912) - Motorola Droid RAZR

I know this question has been asked a lot of times, but I just want to know if this is a hardware problem that will always be here, or if this is a software bug.
My WiFi signal strength is full if I'm directly next to my router. For every step I take, I loose 1 stripe. So if I'm 5-6 meters awy from ym router, I don't have a signal at all. This is not my router, I've tested it with 2 other routers and a number of AP on campus - all the same problem.
I have the latest CM 11 spyder nightly build, I tried to disbale 5GHz (without any luck). My "Avoid poor connections" is obviously disabled. I deleted everything in data/misc/WiFi and also tried running wifical.sh without any improvements.
Does anyone know why this happens? Is there and fix/patch for this?

I am also having this same problem.
Find a fix yet?

Solved
Hi,
I found a way to fix it, days ago I changed the loud speaker of my xt916 , and after this my signal of wireless don't pass one bar, so I open him again and forced the two contacts beside the speaker to take a higher and lean better in the antenna's contact. After this my wirelles take the 3-4 bars as well.
Sorry about the English, i'm learning.

Related

[Q] Wifi roaming not working

Can anybody confirm, that wifi (wlan) roaming, between different access points on the same SSID network and different channels, is working?
I have at home 2 access point (one is on channel 1 and another is on channel 6) and my SGS2 wouldn't switch from one AP to another when I walk in the house. My son has SGS1 and wifi roaming works for him. Before I had Nokia N95 and I had no problems with wifi roaming. The same thing, when I'm at work. We have 3 AP's (all three Cisco) in the house and switching between them doesn't work. In order to switch between AP's I toggle WiFi off then back on again.
I went from KE2 to KE7, now I'm on Litening ROM 1.5, but it's all the same.
I tried everything, I can think off (set AP/router to b/g/n, only b, only g, only n, set different channels, set different security,...tried also flashing different modems on the phone...) but for me wifi roaming is not working...
Any ideas?
Anybody?
Nobody? Realy?
That's realy strange...
Nobody?
I really can't believe.... almost 90 views and no answer...
I'm I the only one with this problem?
While you are moving round your house do you lose connection, i think that your phone will be connected to the strongest signal.
mine loses signal when i leave home and auto picks up an usecured signal down the road.
I don't quite understand, what you mean...
When I walk in my house from basement to the top floor, my SGS2 is always connected to the router in the basement. When I come to the 2nd floor, where I have another Access point, it should switch to that AP, but it wouldn't. Instead, it's still connected to the router in the basement, which (in the Wifi Analyzer) shows -90 db (and the AP on the 2nd floor shows -30). When I switch off Wifi on my SGS2 and then back on, then it will connect to the AP in the 2nd floor. But then, when I walk back, down to the basement, it stays connected to the AP on the 2nd floor, even when I stand next to the router in the basement and Wifi Analyzer shows -28 db on the router.
I can confirm that wifi roaming is not working (at least for me). The phone stays connected to the same old AP all the time even with really poor signal quality.
Unless it loses the connection it doesn't connect to the best AP available.
Tried it on several ROMs (multiple stock roms and now I am on Cognition 1.20), same behaviour every time.
Exactly the same with my SGS2.
I also tried several ROM's, from original KE7 to latest KG3, now I'm on Lite'ning 3.2, and it doesn't work...
That's really strange...
Exact same issue here. Tried three different stock ROMs and a couple of modified ROMs and no change.
I'm even running Cyanogenmod now and the problem persists! How does that work? Does Cyanogen use the Samsung source-code for the Wifi driver?
It's really pissing me off. I basically cant use Wifi on the end of the house I use it most in without cycling the Wifi on/off switch as I pass a different AP on my way into the house to get there!
The most strangest thing is, that nothing can be found on the web about this issue (only one on code.google.com)...
And also here, on XDA, millions of posts, but nothing about wifi roaming...
Are people not using more then one AP/router?
zxcslo said:
The most strangest thing is, that nothing can be found on the web about this issue (only one on code.google.com)...
And also here, on XDA, millions of posts, but nothing about wifi roaming...
Are people not using more then one AP/router?
Click to expand...
Click to collapse
Yes, I am sure most people use one AP/router - that is why you are not seeing too many responses. The source code is from the samsung source drop, the drivers were written by broadcom. We at teamhacksung have not modified them for CM7, so the behavior would be the same across all ROMs that are using the drivers unmodified.
So, that means, we are stuck with this, until Samsung fix it?
I still can't believe, that the best phone on the world (at the moment... ) has such a flaw...
What about trying driver for Wifi from SGS1? On SGS1 wifi roaming works beautiful (my son has one and he is laughing at me all the time ).
Is there much difference between SGS1 and SGS2 in the wifi handling?
Wow - this is an annoying issue to have. Yup, i have 2 routers too, and it really sux to be in an 'overlapping' zone and see the SGS2 connect to the router that is further away.
Is there nothing that can be done about this?
MorRoquen said:
Wow - this is an annoying issue to have. Yup, i have 2 routers too, and it really sux to be in an 'overlapping' zone and see the SGS2 connect to the router that is further away.
Is there nothing that can be done about this?
Click to expand...
Click to collapse
I'm very pis..... angry, when I'm in my room/office, and see, that my phone is connected to the AP, which is in my son's room, two floors above me... and I'm sitting 1m away from router...
Yesterday I tried in my office with 3 AP's with my friend's SGS2 with original stock ROM KE2 (he didn't change nothing on the phone).
Result:....... the same as with my SGS2.... wifi roaming not working....
Any news about wifi roaming?
How annoying!
I'm having similar problems at work.
At home connectivity's fine with just 1 AP. Here at work there are about 10 Cisco APs. Every now and then I have to turn WiFi off and on again and I use the original stock rom.
I have exactly the same problem, it always connects to the same AP, not the one with the better signal... very annoying! How difficult is it to fix that?
Morghus85 said:
I have exactly the same problem, it always connects to the same AP, not the one with the better signal... very annoying! How difficult is it to fix that?
Click to expand...
Click to collapse
Which channel does this AP have?

Very bad wifi signal strength

Hey Guys
I was wondering. Is the bad wifi signal strength on the HTC legend unfixable ?
I am currently standing 5 meters away from my Wireless router and only getting "good" sometimes "fair" reception when i got 2 meters to the left and into my kitchen whereas with my laptop I can go out into the yard of my appartment complex and still get "good" reception - out there the legend can't even pick op the signal.
I'm running CM 7.0.3.
(And also has problems with getting a gps fix even when lots of satellites. And overly exposed flash photos - but that's another story - maybe these will be fixed in the next CM)
Have you tried different radios?
As far as I have been told the radio firmware is for the GPS since the WIFI is on a separate chip ?
But have tried several deffirent radios to try to fix the GPS issue I also have without any luck.

Possible solution to the wifi signal strength issue

I had tried every possible setting on my router to increase the signal strength on the razr but none worked......however surprisingly and inexplicably when I changed the placement of my router and kept it on the floor i.e. around 6ft below the razr, the wifi signal suddenly jumped....hence I took this idea a little further and after some experimentation I saw that placing the router a few feet below the razr actually dramatically improves the reception even if you are at a significant distance away from the router and my problem is solved...
Just thought I should share this bit of information as it might help all those who are facing wifi reception issues with the razr
Sent from my XT910 using XDA App
Your router is support G or N ?
Try to change the method security, for example WEB or WAP .
medo18 said:
Your router is support G or N ?
Try to change the method security, for example WEB or WAP .
Click to expand...
Click to collapse
i tried everything...changing the security, switching wireless "N" Off...every possible thing but the signal strength just dint improve...and it was the same at home and office with diff routers...
Great tip JainB, thanks.
This problem before OTA or after ?
-Try with another router.
OR-
-Dont touch the device and look the signal strength during the contacting.
What is difference between touch and non touch.
medo18 said:
This problem before OTA or after ?
-Try with another router.
OR-
-Dont touch the device and look the signal strength during the contacting.
What is difference between touch and non touch.
Click to expand...
Click to collapse
Diff between touch and non touch is generally 1 bar...Tried with Two Diff routers at home and office with no difference in signal strength...Elevation change worked like a charm giving me more signal strength than my BB Torch...
This problem before OTA or after ?

[Q] Razr wifi problem

Hi all ,
I met wifi problem with a dozen roms ... i flashed and wipe ... firstly I think is my phone hardware problem , but after I changed the channel of my rounter to channel 1 ... the problem solved...(so far)... I would like to ask if any razr owner have the same problem also ?
Hi mate,
I'm experiencing some WiFi problems with my RAZR and the home Linksys router as well. Haven't tried your solution with Channel 1 yet, though, but I'm gonna go and switch to it right away and report the outcome.
EDIT: Weird... Now my WiFi connection is almost lightning fast and no data losses. Well, thanks, hiha!
Speaking of Linksys routers... a While ago I changed my Linksys WAG120N router from G mode to N mode. Strangely, my RAZR started to reboot randomly. I switched the router back to G, and everything got back to normal.
Funny things are happening, it appears.
My Linksys E4200 is currently in Mixed mode and set on Channel 1 - this appears to be the optimal configuration for work with RAZR.
I also have problems with wifi. Really bad signal at home, like 5 meter away it drops to zero
I tried channel one, still same problem.
I noticed when u hold the phone and cover the right side wifi drops and dies constantly. Just like the iphone 4
Sent from my XT910 using XDA
I'm on my 2nd Razr Maxx (first one had a cracked screen), and neither has/had any issues with my Wifi network. My router is on the 2nd floor (FiOS Actiontec, mixed mode G N). I get a good signal throughout my entire house, and have never had a single problem.
I hope ics fixs the wifi signal, its horrible. I am now on 2.3.6
Sent from my MZ601 using XDA Premium HD app
romdroid. said:
the right side wifi drops and dies constantly. Just like the iphone 4
Sent from my XT910 using XDA
Click to expand...
Click to collapse
this is spot when wifi chip is and probobly antenna
when i have hand in that place signal is much weaker - 20dbm
wifi issue
My wife has a droid 3 and I have a razr. I am running netgear routers
with dd-wrt open source software. Both of these phones were unusable
when we first tried them. I logged into my router and set the qos settings
to enable and both phones now work flawlessly. It seems that the wifi chip
in these phones cycles on and off to conserve power. Without the proper handshaking between the two devices ,when the phone chip shuts down the
buffer overflows in the router and it disconnects because the data
is no longer valid. By eneabling the quality of service setting the router and
the wifi chip use a protocol to prevent this buffer overfllow.
If you search the microsoft knowledge base you will find that vista and win 7
had to have a software upgrade to address this same problem when they
first came out.
Some modems have the qos disabled by default to maintain a higher
throughput.
If you go to the dd-wrt wiki and search for qos it goes into more detail
as to how this works.
Wifi issues here too.
Forget low connectivity, my phone blatantly refuses to even connect to a connection secured with 802. 1x EAP. It is embarrassing to say the least.
I have issues where mobile connection and wifi go blue to grey after a while and no longer work. Possibly what the op refers to.
Also, similar to the iphone4 problems, holding my phone reduces both wifi and mobile data signals drastically. Is this a general device issue?
I am wondering if its something the motorola ics release might address.
Sent from my XT910 using Tapatalk 2

Poco X3 - problem with signal strength

Hello all,
I started to have some problems with signal strength.
It's not ROM-related (currently the newest CrDroid).
If I cut my WiFi and set the phone to prefer LTE signal sometimes I'm not able to use data. It's constantly switching between LTE / LTE+.
Sometimes it will connect and it's fine but most of the time it isn't.
It only happens in places when the signal is poor.
If I set the phone to prefer 3G it works perfectly normal.
My gf got the same phone and didn't experience that issue.
I believe that for some time after I received this phone it worked normally.
Maybe it's firmware related issue?
I heard about an issue with the poor signal on this phone...
Thank You in the advance for your answers.

Categories

Resources