Here's my story: Was Running Hyperdrive RLS 19 and attempted to upgrade to RLS 20. I was running CWM 1.0.3.5 as my bootloader and had switched to a high capacity SD card that couldn't do FAT32, so it couldn't mount. Moved update.zip to internal storage and everything appeared to install just find in Aroma. After the initial installation it goes to the first flash screen (which says Samsung Custom and a picture of a padlock) and then the screen goes blank. I took out the battery after waiting 15-20 minutes after the screen went blank the first time.
Here's where I'm at: After I insert the battery, the flash screen comes up and goes dark immediately. I've tried holding Home+VolUp+Power which gets me some blue text above the flash screen, but still goes blank. One time I was able to make it to the actual OS, but it went blank and shut off shortly after. I was thinking it was a battery issue, but the battery read 67% or thereabouts before everything went dark. Additionally, the charging light isn't working when the phone is hooked up the the charger. I assume it's not charging, but I have no way to test that.
Here are the things I've tried:
booting with/without SD & SIM cards
Replacing battery with new one
Letting it sit all night
Inserting battery while holding Home+VolUp+Power
Inserting battery while holding VolDown - This gets me to a new screen, but shuts off after a couple secs
All of these yield the same thing. Any thoughts or help would be much appreciated. I'm pretty certain that I'm going to need to bite the bullet and get a new phone soon.
TLDR - Phone is going blank after 1-2 secs after botched rom flash. Tried a bunch of stuff. Am I SOL?
Can you get into "Download Mode"?
Power off the phone completely by removing its battery for 5 seconds.
Re-insert the battery back into its place.
Press and hold Volume Down, Home and Power buttons, all at the same time.
Release the buttons only when the ‘Warning!!’ message appears.
Next, press Volume Up button to confirm that you wish to enter Download Mode.
Your device will now show a green Android with the ‘Downloading… Do not turn off target’ text listed under it.
That’s it, now you can connect your device with your PC after you launch ODIN.
Thanks for the reply, but the screen still blanks out. After leaving phone on the charger all night the battery is totally drained and won't even turn on. May go into a store later this week to see if they have any suggestions. Otherwise I think it's time for a new phone. Thanks again for the tip.
Related
Hey,
Just got a g tablet this week and I've been playing around with trying to get VEGAn onto it.
After installing it from CWR, it rebooted to the boot screen (three parrots) and now it won't do ANYTHING. I can't even turn it off (holding down power for 10+ seconds doesn't do anything)
Has anyone seen this before? I see many threads about boot loop but I can't even get my tablet to turn off so I can reboot it into APX mode to use nvflash.
Should I just let it try to burn through the battery overnight and see what happens in the morning?
Just keep pressing the power button for 3 second of length, it will turn off
Yeah that usually does it, but this time it's stuck at the screen even if I hold the power button for minutes.
I guess I'll just wait to see if after having it shut off via draining the battery, it is in a usable state.
My tablet must have gotten itself in some very weird state.
After letting the battery drain, it came back to life this morning.
My 5.0 is hard bricked. Black screen, won't charge, won't turn on. When plugged into outlet or computer, still black screen.
I rooted it back in December with no problems until today. Decided to plug it into an outlet to charge it since battery was around 50%. After about 30 minutes, used it to check weather, etc., then I did a quick push of the on/off switch to turn off the screen. About 2 minutes later, went to turn it on and got the black screen. I decided to leave it plugged into an outlet for about 1 hour and still nothing.
Looking at other, similar, bricked posts for the 5.0, doesn't seem applicable to this completely dead device (wasn't installing a rom or doing anything unusual).
Any help is greatly appreciated.
Solved
I was able to fix the problem, without losing any data, by going into recovery. For others who may run into similar issues, I did the following:
Pressed the power and volume up key simultaneously for about 10 seconds until the SAMSUNG logo appeared.
Selected 'reboot system now' and pressed the home button.
Im on a trip, and my battery died. When I got to the hotel, I immediately plugged in my tablet. As soon as it got to 1%, it started booting up, but because of how much battery it uses just to boot, it basically died a second or two after it booted up. Then, it repeats. As soon as it gest 1%, it starts turning on again, then when it gets to the lockscreen, it powers down. It's like a bootloop, but I can't get out of it :crying:
Uclydde said:
Im on a trip, and my battery died. When I got to the hotel, I immediately plugged in my tablet. As soon as it got to 1%, it started booting up, but because of how much battery it uses just to boot, it basically died a second or two after it booted up. Then, it repeats. As soon as it gest 1%, it starts turning on again, then when it gets to the lockscreen, it powers down. It's like a bootloop, but I can't get out of it :crying:
Click to expand...
Click to collapse
You try holding the pwr button for about 10 seconds or maybe longer when it's trying to boot? It might force it to just shut down.
There's a "forced Shutdown" button right by the SD card slot (it's colored yellow in my sgp561, maybe different for other sub-models). Press that button for 10+ seconds using paper clip tip or similar pointed object and it will shutdown completely.
Another possible solution is to plug the charging usb cable to a high current usb charger (4 amp+) that should be able to supply the energy demand at close to 0% battery charge.
Another option will be to boot into bootloader. Bootloader uses barely any battery. When it's not plugged in and off, press and hold power+volume down. Then plug in. You could try to do that while plugged in, but likely not to work.
Hi,
I got hold of one of these tablets that appeared dead, left it charging overnight and it started without issue, the battery was at 67% at this point.
I then shut it down and held the Home + VolUp + Power to enter download mode as I wanted to install TWRP.
Nothing happened, but not only that, the tablet failed to boot again whatsoever. I took the back off and unplugged the battery, held the power button down for 30-40 seconds, reattached battery, still nothing, so I decided to leave it on charge for a bit more and try to figure it out later.
Later came along, and I picked up the tablet and for some reason pushed the home button 3 times and it displayed the battery icon, showing 100%, great!
It still won't boot though and I haven;t been able to reproduce whatever I did to get it to show the battery icon again.
I've tried every combination of holding down Home/VolUp/VolDown and Power that I can think of for different amounts of time and still nothing.
Had it plugged into the computer too and monitored dmesg for any signs of life and still nothing.
I'm thinking (but hoping not) that it might be a physical problem with the power button, but it feels fine when pressed.
Is there some magic trick that I don't know about that could help here?
Many thanks.,
g
EDIT: I have left it plugged in for a few hours and periodically the battery icon appears for a while (now at 99%), then disappears. Tried to switch it on with the power button while the icon is on the screen but no go, same with different button combos.
I was on the latest MIUI (9.something), boot-loader unlocked, redwolf recovery (v27), last seen battery was ~50% charged (before going off).
And, I was using my phone. Suddenly screen goes off and nothing comes up. I tried to restart, it doesn't work.
Finally I googled the problem and tried these things:
1) Press power button 5 times, then try to start the phone by long pressing power button.
Result: Screen open up, that initial screen with MIUI logo, I keep the button pressed, screen goes off and instantly starts again with booting started. Now, as soon as boot finishes, that *low-power* sound comes and it switches off.
2) Press power button 5 times, then try to start the phone by long pressing power button. This time when the screen comes up first time, I press (vol-up + power) to boot to recovery.
Result: As expected. That screen goes off and instantly another screen comes up with the recovery splash screen. Recovery comes up. There on the top, it shows two weird stats: (CPU temp 105 deg C, battery 0%).
3) Press power button 5 times, then try to start the phone by long pressing power button. This time don't press anything on the first screen.
Result: The screen goes off and that's it.
Some weird symptoms worth knowing:
1) Whenever I plug the charging cable (either with charger or, laptop) it just do not boot, neither to system nor to recovery.
2) The micro-USB port is damaged I guess. Last time (a day before all this), I tried to connect phone to my laptop but the socked seemed lose. It was just not connecting, rather fluctuating a bit.
3) Whenever I plug the charging/data cable (either with charger or, laptop) while booting or, while in recovery it suddenly switches off.
either your battery got badly damaged, or your device got fried.
First, I'd agree on the first commenter and support you taking the device to any android service center to check whether your battery or phone got fried. If it's done and proved nothing is wrong with my battery/phone I'd buy an EDL deep flash cable (I bought one for dirt cheap, 5 dollars) and try to solve my problem via deep flash, edl emergency download mode. There are tons of how to do tutorials on the official Xiaomi forums. Good luck with that, my friend!
I've updated something. Please see it.
How would I use edl if port is not working properly? See the original ques. again. I've updated it.