hello
i was so looking forward to getting my new x10 mini pro only to find a few faults some of which i can live with until 2.1 comes out (should really be 2.2 & sooner) but i cannt seem to connect to my wireless router.
i have tried several different methods, including going through all the wireless channels on the router, enable mac address filter and have only my x10 set, try all the differents security settings - but still i cannot get my phone to obtain an ip address before it gives me the unsuccessful message.
so went to mcdonalds tried their openzone and connected fine to their network.
now my next guess would be is my router is old (about 4 years maybe more) linksys WRT54GS so anyone know of any problems with specific routers at all?
i know i had problems setting up my godsons ipod touch with my router, but didnt dig any deeper on it as he wasnt fussed about it at the time - so think it could be that but will hold off rushing out to get a new router for a while yet, probably to test some other peoples routers first.
Is you SSID hidden?
I have found that on some routers, Android phones in general won't connect if the SSID is hidden.
clarkee013 said:
hello
i was so looking forward to getting my new x10 mini pro only to find a few faults some of which i can live with until 2.1 comes out (should really be 2.2 & sooner) but i cannt seem to connect to my wireless router.
i have tried several different methods, including going through all the wireless channels on the router, enable mac address filter and have only my x10 set, try all the differents security settings - but still i cannot get my phone to obtain an ip address before it gives me the unsuccessful message.
so went to mcdonalds tried their openzone and connected fine to their network.
now my next guess would be is my router is old (about 4 years maybe more) linksys WRT54GS so anyone know of any problems with specific routers at all?
i know i had problems setting up my godsons ipod touch with my router, but didnt dig any deeper on it as he wasnt fussed about it at the time - so think it could be that but will hold off rushing out to get a new router for a while yet, probably to test some other peoples routers first.
Click to expand...
Click to collapse
The WRT54GS should be a perfect router to use.
Make sure you are running latest dd-wrt firmware on it, setup wifi security as : WPA2 Personal Mixed, TKIP+AES
I have these settings and phone connects easily.
Its a good router, do as above poster advised and definitely get latest firmware on. Try going on just G mode if there's no B-only old wifi gadgets in your house.
Sent from my U20i using XDA App
I noticed my wife's X10 mini won't connect to Channels 12 and 13. If your router is on one of those channels, try moving it to 11.
I have difficulties connecting to my wifi router at home, SMC Barricade N2, WPA2 authentication, it works only after resetting the router.
Now after turning off TKIP cypher suite (only AES), it works perfectly
update: and also helped to enable static IP... but I am using wifi only @home
Had the same problem. Changed to Channels 11 and detected imediatly my wifi network.
Hi, I have a different problem with the wifi.
At work and some other connections I've seen to have an open wifi, which i can freely connect.
However, I am still unable to browse the internet as it requires some browser authentication.
I've seen other fones (Nokia and Iphone) have their browsers popup a webpage to input the credentials.
but my mini pro doesn't display this page.
i've already tried going directly to the login url manually but still doesn't display the login page.
someone told me that this might be a limitation of android but haven't seen any reports about it...
i also saw and tried 2 apps (Open Wifi Login and Browser Wifi Login) that should have solved this but did not.
Has anyone else had this experience?
Help please....
shameless self-bump
other fones seem to have the same issue but no solution...
http://forum.xda-developers.com/showthread.php?t=622326
help please
hi,
I've linksys wi-fi router model WRT54GH in my home & it has a good amount of signal strength to cover entire area.
My recently bought galaxy S2 is able to identify linksys wi-fi access point & connects too with the IP assigned to it, also at wi-fi settings connected being displayed.
Now when I try to access Internet (any url google/FB), it doesn't connect at all.
I tried almost everything about router configuration, restart etc. but with no success
can someone plz help on this ?
shantanu_d said:
hi,
I've linksys wi-fi router model WRT54GH in my home & it has a good amount of signal strength to cover entire area.
My recently bought galaxy S2 is able to identify linksys wi-fi access point & connects too with the IP assigned to it, also at wi-fi settings connected being displayed.
Now when I try to access Internet (any url google/FB), it doesn't connect at all.
I tried almost everything about router configuration, restart etc. but with no success
can someone plz help on this ?
Click to expand...
Click to collapse
In my case the problem was with frozen "WiFi sharing" in combination with juicy defenders "Location" fearure. It seems such combination is dangerous. Solutin (in my case):
1. defroze
2. remove all wifi networks
3. reboot (for "clean" frozing)
4. make WiFi sharing frozen
5. reboot again just for fun
Try to check your router's MAC address restrictions. In my router, as security, I have to add MAC addresses of each device to share internet. They take IP's, connects etc. but does not have accesses to internet
as above, check that there is no MAC filtering set up.
one other thing it may be is the security settings, if you have a WEP Key to access the router it may need the Hex conversion of your key depending on what level of security you have (64bit or 128bit for example)
shantanu_d said:
hi,
I've linksys wi-fi router model WRT54GH in my home & it has a good amount of signal strength to cover entire area.
My recently bought galaxy S2 is able to identify linksys wi-fi access point & connects too with the IP assigned to it, also at wi-fi settings connected being displayed.
Now when I try to access Internet (any url google/FB), it doesn't connect at all.
I tried almost everything about router configuration, restart etc. but with no success
can someone plz help on this ?
Click to expand...
Click to collapse
Try setting up a static IP address for your phone, I presume your network is a 192.168.1.0, go into router settings and LAN setup, give your phone the address in a static DHCP assignment of 192.168.1.5, or any other address in the same subnet your in. Some SGSII's have problems with dynamic DHCP for some reason, some NS had the same problem too,
Sent from my Sammy Galactic S2 Beastly Device
I have a similar problem and I fix mine temporarily by turning my wifi off, then in wifi settings > advanced, I change wifi sleep policy from 'never' to 'only when the screen is off'. However I have to do this every time I want to use wifi so it can become quite annoying sometimes.
So I can get through however only for a short period of time as it seems as long my Galaxy S2 keeps turning off my wifi even though it's on :/
I had exactly the same issue on Linksys E4200 with my laptop, could connect to network, even to router's attached storage, but not to internet. Restart helped
On SGS2, I couldn't connect to the router at all at first, but fixed this by switching from WPA2/WPA mixed mode access protocol to WPA2 private. But I guess this is not exactly your issue.
SiSL said:
Try to check your router's MAC address restrictions. In my router, as security, I have to add MAC addresses of each device to share internet. They take IP's, connects etc. but does not have accesses to internet
Click to expand...
Click to collapse
Thanks for the suggestion but MAC restriction is already disabled at router
Robsso said:
I had exactly the same issue on Linksys E4200 with my laptop, could connect to network, even to router's attached storage, but not to internet. Restart helped
On SGS2, I couldn't connect to the router at all at first, but fixed this by switching from WPA2/WPA mixed mode access protocol to WPA2 private. But I guess this is not exactly your issue.
Click to expand...
Click to collapse
Yes, you are right this is not an issue for me.
In fact my SG2 being assigned with an IP address from 192.168.1.xx subnet.
Also at a same time my laptop connected with an IP from same subnet able to ping SG2.
OccasionalDroid said:
Try setting up a static IP address for your phone, I presume your network is a 192.168.1.0, go into router settings and LAN setup, give your phone the address in a static DHCP assignment of 192.168.1.5, or any other address in the same subnet your in. Some SGSII's have problems with dynamic DHCP for some reason, some NS had the same problem too,
Sent from my Sammy Galactic S2 Beastly Device
Click to expand...
Click to collapse
My SG2 being assigned with an IP address from 192.168.1.xx subnet.
So I think IP addressing may not be an issue.
Also another thing I tried was, at a same time my laptop connected with an IP from same subnet able to ping SG2.
So wi-fi router may not be an issue here, whats say ???
Even I am facing the same issue at my office network. I am able to connect to the wireless network but if I try to access any app I cannot browse. This is really frustrating looks like some issue with the modem drivers.
I was able to browse on another wifi created virtually by mobile tethering. This looks like a major bug with the current firmware. Another interesting thing to note is that the Wifi network has a hidden SSID and uses WPA2 auth scheme.
I have seen a Galaxy S able to connect to the same n/w without any issues.
Has anyone figured out a solution to this one ?
Hi, thanks for your reply.
I am yet to figure out a solution for this
Even I am also agree on the probable issue with modem driver.
I've D-link modem.
Are you aware of anything about this modem that can be reconfigured to get this worked ... ?? pl let me know
The wifi router at my office is Cisco Aironet 1200 Series, anyone else facing this issue ?
I'm having the same problem at work connecting my SGS2 with v2.3.3 Official Firmware (customized for Orange service provider) to a Cisco Aironet 1130 AP. I can see that the Galaxy authenticates with the AP correctly and gets IP from the DHCP server, but it cannot send or receive any traffic, although the phone stays connected and authenticated. At home, I use an Atheros based Fonera with DD-WRT without any problem.
As I'm the company's network administrator, I will try to further investigate this problem, but it seems like some kind of incompatibility between the devices or misconfiguration ....
Basuk said:
The wifi router at my office is Cisco Aironet 1200 Series, anyone else facing this issue ?
Click to expand...
Click to collapse
try turn off the wifi, turn off the mobile data and turn on the wifi again
It seems the SGS2 sometimes has problems with DNS.
Try a static IP and use 8.8.8.8 as second DNS server, which is a free Google DNS server.
This fixed MY problems
I rooted my SGS2 and voila wifi worked at my office finally I have been able to find a solution.. love my SGS2 the Beast...
I'm having this same problem..
I think I've tried all the solutions above, but one (Sorry - noob question):
Rooted?
is there a firmware patch or something that I should know about?
Anyone got any other ideas?
ETA:
I can connect to hotspots (DHCP) and at home (Have to set it to static tho)
No internet
AP works - Laptop and i8910 (had to set static and advanced settigs etc). I've rebooted it a few times, set DHCP on and off. DHCP seems to be running on the router
viqles said:
I'm having this same problem..
I think I've tried all the solutions above, but one (Sorry - noob question):
Rooted?
is there a firmware patch or something that I should know about?
Anyone got any other ideas?
Click to expand...
Click to collapse
This is an issue with SGS2 with wifi server using authentication protocol TPIK, if you use AES as encryption then it will work without any issues.
That should be a setting in my AP? I can't see it...
If I get a new non-crappy AP is that likely to solve my problem?
ETA:
Ah - that's a WPA thing? Mine only seems to do WEP - is that right?
Hi,
For starters, the android version is 2.3.3.
I have a wifi problem with the x10i. At home, there is no connection problem. I connect to my router which uses WPA (TKIP+AES). But at work, I can't connect to the wifi that uses a WPA/WPA2 PSK. This is what I see on the phone. I thought that there was a compatibility problem. So, I created a connection using my iMac that uses a WEP protection. But I still wasn't able to use the wifi. Finally, I disabled the WEP protection and then I could connect. But I don't want the wifi connection to remain unprotected.
I tried looking up this on google but could't find a solution. So, I apologize if this problem has already been adressed here.
Thanx.
Hello
I'm issuing some problems connecting a universal repeater with my X10. As I said, I have a universal repeater (TP-LINK W500G) repeating my main wireless connection at home. This connection works on every device I have at home, as 2 laptops, ipod touch, but on my android phones, it says Limited Conectivity or even dont connect (on a Samsung Galaxy Gio).
If I activate the DHCP on the repeater, would it work, or is it a Android problem?
Best Regards