Hello all
I have bricked my Lenovo A6000
When i connect it to pc It is Connected as qualcomm hs-usb qdloader 9008
Please help me to Unbrick it
I also bricked my Lenovo A6000
kkt890 said:
Hello all
I have bricked my Lenovo A6000
When i connect it to pc It is Connected as qualcomm hs-usb qdloader 9008
Please help me to Unbrick it
Click to expand...
Click to collapse
how you bricked it and how you able to connect it in Qualcomm HS-USB Qdloader 9008 mode
if you did able to connect it in Qualcomm HS-USB Qdloader 9008 there is good chances of unbricking it.
In my case i am not able to connect it any mode like Qualcomm HS-USB Qdloader 9008 or Qualcomm HS-USB Qdloader 9006
there i a tutorial on net you try this
and let me know if you succeeded. and help me too.
the same problem here too if u succeed please help
hey... i was installing it for the 5th time and unfortunately my phone got unpluged while installing and now it is not even switching on.. so im warning everyone that not to touch the wire or the phone while installation
Strange Issue
Hello,
I tried flashing the stock rom of a6000+ using twrp but after that my phone got bricked.
i am not able to boot in recovery mode. My device is not getting recognized in adb.
in the device manager section it show TP-Link Android Device->Android Bootloader Interface.
Please Help Me Unbrick My Phone.
the phone just restarts itself even if it is connected to computer.
email:[email protected]
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
plz help me too. my lenovo a6000 aalso got bricked and is in bootloop. its shows nothing when i connected to my lpatop
Related
**************Flashing Hard Bricked Redmi 3 SnapDragon***********
This IS the Guide to Flash hard Bricked Redmi 3, using Deep flash mod, No Fastboot, No Edl, No Test point, very easy and simple, Hit :good: if this helpful for you,
Instructions-
First of all Prepare Deep Flash Cable using Below Guide
Attached Both Coper Wire and then connect this cable with your pc
Now connect your Device to usb [Make Sure Your phone is switched Off]
On Pc go To Device manager and Look on port, {No Available] Don't Worry]
Pull the attached Wire and look Device Manager a New port Is Available HS-USB Diagnostic 9008[ com5, com17 etc]
Ok your Device is ready For Flashing
Run mi Flash click on Browse and Load Fastboot Rom Folder
Click Refresh and Then Flash Done, wait a few Seconds While flashing IS complete ,
Done,
Bought a Deep Flash Cable @ AliExpress (for about 5€/5US$). It has a button to enable Qualcomm HS-USB QDLoader 9008 and for me is more secure then trying to risk to kill your mainboard via USB.
P.S.: I'm not good at DIY.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
plz sent me a cable at my village, lol, Delivery system Not Available For all Areas or this guide for that person,
Does this work with Redmi Pro?
So, my lg g5 h850eu one day started turning on and off when finally show screen like this
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
.
So i downloaded minimal adb and fastbooot and typed "fastboot reboot". After this commend phone turned off and never displayed anything. In device manager show qualcomm hs-usb QDLoader 9008 (com3) and in minimal shows error: no devices/emulators found. I wanted use lgup to flash stock firmware but shows no handset connected.
What can i do in this situation?
Unfortunately, this isn't possible to fix this in my experience since the firehose and required program and rawprogram0.xml files do not work with the G5. The only solution is to replace the motherboard.
najak223 said:
So, my lg g5 h850eu one day started turning on and off when finally show screen like this
.
So i downloaded minimal adb and fastbooot and typed "fastboot reboot". After this commend phone turned off and never displayed anything. In device manager show qualcomm hs-usb QDLoader 9008 (com3) and in minimal shows error: no devices/emulators found. I wanted use lgup to flash stock firmware but shows no handset connected.
What can i do in this situation?
Click to expand...
Click to collapse
The same thing happened to me yesterday. First the stock camera started to hang, clearing data solved that, but at night it began to restart until the "fastboot" escreen appeared. Then I removed the battery, put the reserve one (a new one) and it never gave again a life signal...:crying:
Good day. The phone LG G3 VS985WK worked, but the Internet distribution via the SIM card of another operator was not available. I used a program SALT FWUL loaded from a USB flash (Live USB) drive to remove AntiRollBack. Through the inoperability of the Internet distribution, I also deleted the system partitions using the program SALT FWUL loaded from a USB flash (Live USB). After that, the program SALT FWUL does not detect the device, recovery does not start and no Download Mode. Moved the phone to Qualcomm HS-USB QDLoader 9008. When restoring the phone with the program BoardDiag (AP Check), an error appears "No response from the device. Check PMIC first and if stiil boot problem, replace AP". If you choose settings AP Check+EMMC Test or PMIC ON, then "Device was not found in dload trying flash programmer". Settings B2 (MSM8974AC) or G2 (MSM8974) and versions BoardDiag 2.99a or BoardDiag 3.99c do not affect, the error is the same.The program https://www.androidbrick.com/unbrick-recover-your-dead-lg-g3-g2-all-variants/ restores the phone, but only one port LGE AndroidNet USB Serial Port and one modem LGE AndroidNet USB Modem appears. I use Windows 7 SP1 Ultimate x64. Please help me recover the phone. I understand Russian and English.
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Buy a new phone m8. VS985 are cheap.
Hello,
I hope someone can offer an idea of how to solve issue I'm facing atm.
I have FZ-X1 phone and it's came simlocked from Japan.
I want to run "fastboot oem clearsimlock 0".
I'm trying to communicate to it using fastboot but the problem I have is that once I boot the phone into its stock bootloader, my PC cannot see connected phone in Device Manager:
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
Once phone is fully booted into UI, I can see it recognised running command "adb devices":
I tried both latest Google and original Panasonic ADB drivers available for download. I use Windows 7 x32 version - it shouldn't have issue with drivers signature, right?
Have no clue how to overcome this obstacle. Any ideas or suggestions are very appreciated.
Thanks!
Remove the Google USB driver and the Panasonic ADB driver: All you have to do is to install the proper OEM USB driver suitable for your device:
Download Qualcomm HS-USB QDloader 9008 driver for Windows - 32-bit / 64-bit
You can now download Qualcomm QDLoader HS-USB Driver of 32-bit & 64-bit Installer. We have put up the entire installation process for you.
www.getdroidtips.com
Thank you for your reply! I tried that - unfortunately the phone still not detected by Windows 7 once connected to PC.
Hello, Need help. ZTE Nubia red magic 6R, flashed firmware from ZTE Nubia red magic 6 Pro. Fastboot does not enter, black display! The device automatically connects to the PC as Qualcomm HS-USB Qdloader 9008. I can not find the service firmware for recovery! Can anyone help me? Thank you in advance!
this can fix but maybe will have imei issure if full flash fw or another device
KobyZero said:
สวัสดี ต้องการความช่วยเหลือ ZTE Nubia red magic 6R แฟลชเฟิร์มแวร์จาก ZTE Nubia red magic 6 Pro Fastboot ไม่เข้า จอดำ! อุปกรณ์เชื่อมต่อกับพีซีโดยอัตโนมัติเป็น Qualcomm HS-USB Qdloader 9008 ฉันไม่พบเฟิร์มแวร์บริการสำหรับการกู้คืน! ใครสามารถช่วยฉันได้บ้าง ขอบคุณล่วงหน้า!
Click to expand...
Click to collapse
inbox me
{
"lightbox_close": "Close",
"lightbox_next": "Next",
"lightbox_previous": "Previous",
"lightbox_error": "The requested content cannot be loaded. Please try again later.",
"lightbox_start_slideshow": "Start slideshow",
"lightbox_stop_slideshow": "Stop slideshow",
"lightbox_full_screen": "Full screen",
"lightbox_thumbnails": "Thumbnails",
"lightbox_download": "Download",
"lightbox_share": "Share",
"lightbox_zoom": "Zoom",
"lightbox_new_window": "New window",
"lightbox_toggle_sidebar": "Toggle sidebar"
}
apangmasaleh said:
inbox me
Click to expand...
Click to collapse
Do you know how to downgrade rom ver?
KobyZero said:
Hello, Need help. ZTE Nubia red magic 6R, flashed firmware from ZTE Nubia red magic 6 Pro. Fastboot does not enter, black display! The device automatically connects to the PC as Qualcomm HS-USB Qdloader 9008. I can not find the service firmware for recovery! Can anyone help me? Thank you in advance!
Click to expand...
Click to collapse
Have you found any solution, my phone stuck in FTM mode