hey Guys ,
I have recently installed the BLISSPOP 5.1.1 ROM for my galaxy grand and it install well but when i come to install gapps the error is coming that installation is aborted and is not coming further so please help me this . even i try 5.1 , 5.0 , 4.2.2 gapps but they are just not working same problem is coming .
From i install ROM and Gapps (not working) : http://forum.xda-developers.com/galaxy-grand-duos/development/rom-t2968342/page61
Hi all
I need some help.
i was on stock (rooted) with TWRP recovery and wanted to have paranoid android 5.1.
i downloaded the lasted from the paranoid android site and tried to flash. after flashing it gets stuck in bootloop.
i have tried almost all previous versions of paranoid android 5.1 but all have same results.
then i tried to get an older version of paranoid android 4.41. which went fine. still i'm not able to upgrade it to 5.1 as OTA is giving error and flashing result in same bootloop
please guide me
regards
bilal
@bkhaliq: read Paranoid-thread from post 449 to the end.
thanks ... i'll check
Is ur cwm or twrp up to date. I had problems installing kit kat and lollipop. Then I updated to latest and All was fine just a thought
Boot to recovery
Wipe data, cache, dalvik cache
Flash latest Paranoid Android found here: http://get.aospa.co/legacy/i9300
Flash Boeffla kernel alpha 3 found here: http://boeffla.df-kunde.de/sgs3/boe...ernel-4.0-alpha3-CM12.1-NG-i9300.recovery.zip
Flash latest gapps found here: http://opengapps.org/
Reboot and rejoice
Hello all
Im french so excuse my bad english
I was on the hybrid Concept ROM 5.1.1 for ZU then yesterday i've flashed the Résurrection Remix 6.0
When ROM has booted , Google play was not installed
I try to flash another gapps but impossible to have Google play service . Even if i try to install Google play apk , the problem still the same.
So i decide to reinstall another ROM . but i can't because twrp was replaced by CM recovery ans flashing other ROM than 6.0 is impossible....
Does someone can explain me how reinstall twrp or another recovery and go back on 5.1. Custom ROM ?
Thanks to all
ingi28 said:
Hello all
Im french so excuse my bad english
I was on the hybrid Concept ROM 5.1.1 for ZU then yesterday i've flashed the Résurrection Remix 6.0
When ROM has booted , Google play was not installed
I try to flash another gapps but impossible to have Google play service . Even if i try to install Google play apk , the problem still the same.
So i decide to reinstall another ROM . but i can't because twrp was replaced by CM recovery ans flashing other ROM than 6.0 is impossible....
Does someone can explain me how reinstall twrp or another recovery and go back on 5.1. Custom ROM ?
Thanks to all
Click to expand...
Click to collapse
you need reflash twrp recovery 3.0.0 (ex fastboot flash boot twrp-3.0.0-0-togari.img) if you have botloader unlocked
Or use Flashtool
It works fine. Thanx you bro
Flash twrp recovery one more time
Done. Working fine now
Hey guys, I am thinking of flashing cm 13 rom based on android 6.0.1 on my moto e (1st Generation). my question is that all you guys who have upgraded to the cm13 rom on their moto e, how is your experience now?facing any problems or is it just great from the stock rom experience. Please help and share.
AbhinavIsgrt said:
Hey guys, I am thinking of flashing cm 13 rom based on android 6.0.1 on my moto e (1st Generation). my question is that all you guys who have upgraded to the cm13 rom on their moto e, how is your experience now?facing any problems or is it just great from the stock rom experience. Please help and share.
Click to expand...
Click to collapse
You will get performance close to deodexed KitKat stock rom .. No problems so far .. surely upgrade your device to cm13 :good:
definitely no problems.. just great.
latest nightly works flawlessly..
there is plethora of feature in marshmallow and in being cyanogenmod
I am also thinking in flashing CM13 rom based on android 6.0.1 on my Moto-E (1st Generation) XT1021...
I am currently using the following 5.1 ROM:
Retail US 5.1 ROM (Optimized) v1.0a (311mb)Non-Deodexed:
http://forum.xda-developers.com/devdb/project/dl/?id=14437
That I Found in the following post:
http://forum.xda-developers.com/moto-e/development/rom-stock-motorola-lollipop-rom-t3167111
So, I would like to know if I can safely flash directly the CM13 ROM, on top of my current v5.1 ?
And if anyone here could give me the correct link to download the CM13 ROM that works best on the Moto-E XT-1021 ?
Thanks in advance for helping me !
ulises.rodriguez said:
I am also thinking in flashing CM13 rom based on android 6.0.1 on my Moto-E (1st Generation) XT1021...
I am currently using the following 5.1 ROM:
Retail US 5.1 ROM (Optimized) v1.0a (311mb)Non-Deodexed:
http://forum.xda-developers.com/devdb/project/dl/?id=14437
That I Found in the following post:
http://forum.xda-developers.com/moto-e/development/rom-stock-motorola-lollipop-rom-t3167111
So, I would like to know if I can safely flash directly the CM13 ROM, on top of my current v5.1 ?
And if anyone here could give me the correct link to download the CM13 ROM that works best on the Moto-E XT-1021 ?
Thanks in advance for helping me !
Click to expand...
Click to collapse
Yes you can directly clean flash cm13 .. make sure you use gapps 6.0 .. and flash cm13 and gapps in a single session
https://download.cyanogenmod.org/?device=condor
Here is the link to official nightlies
ABSathe said:
Yes you can directly clean flash cm13 .. make sure you use gapps 6.0 .. and flash cm13 and gapps in a single session
https://download.cyanogenmod.org/?device=condor
Here is the link to official nightlies
Click to expand...
Click to collapse
ABSathe, 1000 Thanks for the quick reply, for letting me know that I can directly clean flash cm13 over 5.1 and for the link to official nightlies !
Please confirm if this is the correct method to flash the CM13 ROM:
1) Boot into latest TWRP and Format Data: Wipe > Format DATA > Yes
2) Transfer ROM to SDCARD or Internal Storage: CM13 ROM + gapps 6.0
3) TWRP > Wipe > Factory reset and flash CM13 ROM, and then Flash gapps 6.0 (flash cm13 and gapps in a single session)
4) Reboot.
However, since I have already installed in my Moto-T, the version 2.8.7 of TWRP ( http://forum.xda-developers.com/mot...recovery-twrp-2-8-6-0-touch-recovery-t3100879 ), I would like to know if is better and also you recommended me to install first ( using fastboot flash recovery) the cm-13.0-20160810-NIGHTLY-condor-recovery.img (instead of TWRP 2.8.7) ? :
CyanogenMod Recovery:
https://download.cyanogenmod.org/get/jenkins/173585/cm-13.0-20160810-NIGHTLY-condor-recovery.img
And then the:
CyanogenMod Build
cm-13.0-20160810-NIGHTLY-condor.zip (322.76 MB)
https://download.cyanogenmod.org/get/jenkins/173585/cm-13.0-20160810-NIGHTLY-condor.zip
And Finally - Flash gapps 6.0:
http://forum.xda-developers.com/android/general/gapps-gapps-6-0-1-minimal-t3276606
https://www.androidfilehost.com/?fid=24533103863139560
One last question, since I know that the CM13 is not based in an official Motorola release, I would like to know what is working flawlessly, and what is not working with in the Moto-E if I use this CM13 ROM ?
Please excuse all the questions, but I will like to be fully sure of the method and the correct files, that I have to use to successfully flash my Moto-E to CM13, to avoid future problems.
Thanks again for all your help !!
@ulises.rodriguez
I would recommend following steps
1)Download latest twrp (3.0.2) from twrp official website
2) Reboot into recovery and choose downloaded recovery image and then select recovery partition
(Twrp updated .. u can reboot for file transfer)
3)Transfer rom and gapps6.0 to sd card
4)Reboot into twrp and wipe /system,/data,/cache,/dalvikcache partitions (internal storage is optional )
5)choose rom zip (latest from cm downloads)
6)after rom zip is flashed successfully .. choose gapps zip (use open gapps Pico)
7)After successfully flashing both files .. reboot into system and enjoy new rom on moto e
Cm13 today's nightly working flawless for me
(And regarding your first sentence of post(1000 thanks ) .. I can't see them on my profile XD (Just joking .. hit thanks only if u want ))
Ignore any English grammatical mistakes in the post
ABSathe said:
@ulises.rodriguez
I would recommend following steps
1)Download latest twrp (3.0.2) from twrp official website
2) Reboot into recovery and choose downloaded recovery image and then select recovery partition
(Twrp updated .. u can reboot for file transfer)
3)Transfer rom and gapps6.0 to sd card
4)Reboot into twrp and wipe /system,/data,/cache,/dalvikcache partitions (internal storage is optional )
5)choose rom zip (latest from cm downloads)
6)after rom zip is flashed successfully .. choose gapps zip (use open gapps Pico)
7)After successfully flashing both files .. reboot into system and enjoy new rom on moto e
Cm13 today's nightly working flawless for me
(And regarding your first sentence of post(1000 thanks ) .. I can't see them on my profile XD (Just joking .. hit thanks only if u want ))
Ignore any English grammatical mistakes in the post
Click to expand...
Click to collapse
ABSathe, thanks again for your fast response and also valuable help !
Is this the open gapps6.0 Pico that you have installed in your Moto-E ? :
open_gapps-arm-6.0-pico-20160810.zip
http://opengapps.org/?download=true&arch=arm&api=6.0&variant=pico
With regard to my question about how well it is currently working the CM13 in the Moto-E, and what is not working yet...
I was asking because I've heard that as the CM13 was not based on a official version of Motorola, some features of the Moto-E did not work very well...
So, I would like to know, if the proximity sensor, Phone Signal Bluetooth, Camera, Gyroscope and all other sensors, if all of them are working well, or if any have some limitations ?
Are there any features that you have found that work best with the CM13, than with the official ROMs from Motorola for the Moto-E ?
Thanks again for helping me and always answer all my requests !
ulises.rodriguez said:
ABSathe, thanks again for your fast response and also valuable help !
Is this the open gapps6.0 Pico that you have installed in your Moto-E ? :
open_gapps-arm-6.0-pico-20160810.zip
http://opengapps.org/?download=true&arch=arm&api=6.0&variant=pico
With regard to my question about how well it is currently working the CM13 in the Moto-E, and what is not working yet...
I was asking because I've heard that as the CM13 was not based on a official version of Motorola, some features of the Moto-E did not work very well...
So, I would like to know, if the proximity sensor, Phone Signal Bluetooth, Camera, Gyroscope and all other sensors, if all of them are working well, or if any have some limitations ?
Are there any features that you have found that work best with the CM13, than with the official ROMs from Motorola for the Moto-E ?
Thanks again for helping me and always answer all my requests !
Click to expand...
Click to collapse
All the sensors are working perfectly
And regarding gapps .. I have installed older package (which I downloaded in July) .. but the latest one will just work fine
And latest nightly of cm13 is working perfectly for me.. so go for it
Sent from my Nexus 5X using XDA Labs
I have a little problem maybe Big problem ;o( ..
I have now a KatshMallow-6.0_TF201_029 version (Very very nice Rom !!) Thkz lot @TacoNikky .. Dirty install, V26 before ;o) .. I lost my root on my version 29 in my wonderful TF201.
When I want flash to V29 in my V26 ...
I have to proceder in TWRP 3.0.0-0 :
Dirty install V29 in V26
- Clean cache and dalvik cache
- Flash rom KatshMallow-6.0_TF201_029.zip
- Gapps (open_gapps-arm-6.0-pico-20160320)
- BETA-SuperSU-v2.52 Install no problem ;o) .....
Then reboot
But Supersu is not install in my tf201 and my root is faded away ..
Root Checker : no root ...
Titanium Backup PRO :Root ok ???!!
Supersu is not installed ...
Please HELP Me ;o)
Ps:
Really sorry for my bad english
Hi,
why don't you go back to TWRP,
wipe all partitions,
install with Katkiss 7.1, SuperSU LATEST STABLE then OpenGapps Pico 7.1 ?
See my tutorial and keep in touch