Hi guys, my phone is acting erratically where it turns on then it turns off instantly after 2 seconds where you can see the LED backlight turning on but it's completely black. I have reflashed the Stock 2.1.1.A.0.6 ftf to my device using Windows 10 but the problem persists on. The bootloader is unlocked and has a manufacturing date of 10W35. I was previously on GingerDX and I locked the phone and when I unlocked it, there was nothing on the screen. I took out the battery and reinserted it and it wouldn't turn on so I reflashed the stock 2.1 FTF to the device but it still persisted on. There were no error logs on Flashtool and it said it flashed the device successfully. I suspect the NAND is failing but if it failed I wouldn't be able to flash the device. Does anyone know how to revive the device or is it permanently dead?
Related
i have xperia x10i 2.1 then updated it to Gingerbread using PC companion yesterday, the download and update was successful but when i tried to power it on it just give me a green LED blink then vibrate but won't boot up, i know booting after update may take several minutes but it took me almost 2hours waiting but nothing happens,
i tried removing the battery for 30sec then put it back, it blinks then vibrate but still wont boot up, after 5sec it just vibrates continuously, you have to remove the battery to make it stop.
i also tried SEUS , updated successfully but still wont boot up, it just vibrates continuously.
i tried to downgrade to 1.6 , flashing was successful but still wont boot, pressed the power button then after 30min it started vibrating continuously
i also tried reflashing with 2.1 generic but same result as above
then, again i used SEUS repair, download and update was successful but still wont boot, this time i waited several hours but nothing happens even vibration did not happend, after 5hours it started to blink Red LED
pls help me
how much percentage was on your battery before u doing all this flahses?
i made sure that i have 50%+ battery before flashing
but u done a lot of flashing after the 2.3 update right?... try charge your phone offline .. see if it's charging
BTW i manage to borrow x10i from a friend,
i tried charging it using wall socket, but it gives me green LED light immediately, as if its going to flash mode, (i remove my battery and inserted it to the borrowed x10i and its charging well)
then i tried to run SEUS again, the update runned without pressing the back key, update was successful but stil wont boot only vibrates continuously.
okay... i have been in this situation... firstly, charge your battery through your friend's phone, then flash the 2.1 firmware through flashtool
charging now, feedback later
thank you
cheers!!!!!!!!!!!!!!!!!!!
still doesn't work ... any more suggestions?
hi, i have the same problem with my x10a, any solution? can some one help me?
Hi i had x10 mini pro with unlocked bootloader, naA kernel and gingersony ROM. It was working fine for couple of weeks after unlocking bootloader and flashing new ROM, but now it didn't turn on (red light flashed three times and thats it) then i tried holding power + back key then led changed to orange, but it still didn't turn on. Then charged the battery for 2h the led turned to green, tried to turn on the phone vibrated the green led flashed once, but the black screen just keeps turning on with no logo and it's like in bootloop (i can hear the device being recognised by computer when USB is plugged in). Don't know tried Flashing original firmware with flashtool, original kernel, tried locking the bootloader, PC companion and SEUS they both download the software and everything flashes fine, but same bootloop is happening and i need to pull the battery out to stop it. Dont know what else i can do?
anndrius said:
Hi i had x10 mini pro with unlocked bootloader, naA kernel and gingersony ROM. It was working fine for couple of weeks after unlocking bootloader and flashing new ROM, but now it didn't turn on (red light flashed three times and thats it) then i tried holding power + back key then led changed to orange, but it still didn't turn on. Then charged the battery for 2h the led turned to green, tried to turn on the phone vibrated the green led flashed once, but the black screen just keeps turning on with no logo and it's like in bootloop (i can hear the device being recognised by computer when USB is plugged in). Don't know tried Flashing original firmware with flashtool, original kernel, tried locking the bootloader, PC companion and SEUS they both download the software and everything flashes fine, but same bootloop is happening and i need to pull the battery out to stop it. Dont know what else i can do?
Click to expand...
Click to collapse
3 red flashes = low battery.
your symptoms sounds wierd are you sure you did all that correctly?
Flash stock firmware and leave it to charge for about a day.
Well, when i remove my sd card exaclt that happens to me, until i return the SD, or use repair on PC companion
Sent from my Sony Tablet S using xda premium
i think the bootloader is broken, when i turn on the phone from cold restart the phone vibrates and the black screen turn on and off... I can flash with flashtool and PC companion and SEUS, but nothing helps, the same bootloop repeats. I don't know what else i can try i think it's hardbricked. What else i can try?
check with s1 tool if there is a small r if so just flash stock rom
Sent from my E10i using xda app-developers app
the s1tools show "R" i have flashed with SEUS and PC companion and flashtool but nothing helps. The phone shows black screen for 10 sec and then reboots and same black screen, no logo nothing. How can i revive it?
Your battery is discharged, change it for other to test.
Sent from my U20i using xda premium
you have to unlock your bootloder with flash toll
Sent from my E10i using xda app-developers app
i don't have another battery and tried without battery with charger plugged in, but it's the same. I have flashed with unlocked bootloader and with locked, but nothing helps. Is it hard bricked? no hope?
I had the same problem, and only i changed the battery for my K850i.
Try to charge the battery with a universal charger.
Other solution is flash stock kernel, beacuse nAa kernel i think dont work off charge.
you flashed a costuom kernel without unlocking your bootloder
unlock your bootloder
and than flash back to stock rom
Sent from my E10i using xda app-developers app
anndrius said:
i don't have another battery and tried without battery with charger plugged in, but it's the same. I have flashed with unlocked bootloader and with locked, but nothing helps. Is it hard bricked? no hope?
Click to expand...
Click to collapse
This same issue has happened to me several times while installing custom ROM. One of your SW component is broken, when you dont know what went wrong, you should revert back to SE default rom using PC companion. Go to software update and then reset device. Follow the instructions. Once your device is back start with your R&D.
The issue seems to be because your device has custom ROM running on SEMC kernel.
You need to unlock your bootloader. Install nAa GB kernel and
Install the GB ROM. Let me know if you need the links.
i have tried unlocking bootloader, but it doesnt work, in flashtoold there's no option in plugins>unlock/run and msm7227_semc.bat doesn't work. Maybe i got it locked with nAa kernel, but i tried locking the bootloader after i have tried SEUS, flashtool and PC companion. Maybe i can flash something with flashtool to revive it?
I was UNLOCKED bootloader in my x10 by ( qsd8250.7z )
after 2 weeks it stopped to work
Now when I press the power button, the phone vibrates for half a second, the screen brightens up but does not show anything but a black screen
I tried to connect it to the PC, and PC Companion not finds the device.
I tried to turn off the phone for some time by removing the battery, but as soon as I put the battery back on, the phone's screen brightens and stays that way forever
I am restored My X10i by using SEUS and Flashtool ,, Roms 2.3 and 1.6
but same the problem !!!
Help me
I fleshed Rom 2.1 and Kernel downgrade then Kernel upgrade for unlocked bootloader by qsd8250.7z
but does not work
please help me
Hi. My xperia Neo crashed, I tried to send a photo via bluetooth and the phone just turned off. I tried to turn it on, it appears the "SONY" screen, then the "XPERIA" screen, and then it restarts, over and over again with the same 2 screens. I searched topics, they say that I have to flash it, but I can't start the phone in flash mode, with power and back buttons, any software (Companion, flashtool) don't detect the phone. Is there any solution?
Just like death
adrianoancea said:
Hi. My xperia Neo crashed, I tried to send a photo via bluetooth and the phone just turned off. I tried to turn it on, it appears the "SONY" screen, then the "XPERIA" screen, and then it restarts, over and over again with the same 2 screens. I searched topics, they say that I have to flash it, but I can't start the phone in flash mode, with power and back buttons, any software (Companion, flashtool) don't detect the phone. Is there any solution?
Click to expand...
Click to collapse
Hi, I´ve got similar problem. A year ago my Neo V went dead (I thought so). Just for fun, I tried to connect it to PC yesterday and what happened? It started charging and after few minutes I started it (YAAAY)! So I thought It was just some bug that disapiered after discharging. So I did a hard reset, to gain factory settings, repair the firmware via PCcompanion, everything was OK until I shove a memory card inside. After that it died again. Its not charging, no reaction after connecting to PC, no reaction on ON/OFF button, no reaction for button-hard-reset, no response while trying flashing with EMMA or FLASHTOOL, nothing... Does anybody knows what to do with it or do I have to wait again until it discharge and pray it would work after that?
help
I have the same problem as you did it to solve? :crying:
Hi,
It seems like I f****d my phone up :/
I tried to unlock the bootloader and root my phone according to the instructions (http://forum.xda-developers.com/m4-aqua/general/recovery-twrp-command-line-t3198973).
I'm pretty sure the unlocking process ended without errors (at least flashtool told me so), then I flashed the recovery.img. Now my phone is stuck in a bootloop. Everytime I try to turn it on it vibrates one time, shows the SONY XPERIA-logo and goes black. Than it turns itself on again and displays the logo. This cycle continues for hours. Sometimes the red LED is flashing, too. The next morning the LED was red without flashing and the phone was off, despite being on a charger the whole time.
I tried to reflash the stock-firmware with flashtool and xperifirm, but it still won't boot properly. I also tried to repair the phone using Sony PC-Companion (after relocking it), the problem still exists.
I'm able to boot into fastboot and flashmode, but not into ADB.
Does anybody has an idea how to get the phone working again?
Reflash firmware, use flashtool.
As already said, flashing the firmware via flashboot does not work. I'm still in a bootloop.
How did you unlock it? Where did you get the unlock code?