hi i was trying to flash cwm into samsung galaxy core gt i8262 via odin
instead of showing pass or fail it showed me something else i forgot may be "reset"
when i reboot there was caution sign below the samsung logo this time but device worked properly
but i was unable to go into cwm. but as i did factory reset device went into cwm mode and not comming out of it
my device was not rooted at the time of installing cwm
pls help me
Stuck into booting into CWM every time after factory reset (Samsung Galaxy GT-I8262)
Peace!
Don't worry, dude! I had the same problem with my Galaxy Core I8262 when I factory-reset it from the Settings menu. I had the ClockworkMod Recovery installed already. It was stuck into booting CWM every time. Odin was unable to detect it either. So, here's how I managed it.
1. Restart Windows. And if it's stuck at the shutdown menu too, then force-shutdown it (by pressing the power button or turning off the power supply) and then start if manually.
2. After booting into Windows, reinstall Samsung drivers by completely uninstalling them first.
3. After successful installation, restart Windows once again.
4. Run Odin and connect your Android in Download Mode (Volume down + Home + Power). This time Odin must detect it, trust me!
5. Flash the CWM Recovery again via Odin (using the recovery.tar file).
6. Now you'll be able to boot into CWM as well as the ROM. But if you see your Android not going beyond the Samsung model logo then you'll need to download an official firmware file for your Galaxy Core and flash it via Odin.
I also used the 'format /system' option in CWM which might have wiped my system files. Let me know if the above procedure helps you.
Shees Hassan
[email protected]
Related
Hello everyone
I need the help of some professionals around here
I just made a mistake while trying to root my Galaxy Tab 10.1 (P7500) with Stock ICS (4.04) on it. I did the following:
I followed this a Tutorial to root the tablet with Odin.
1) I booted the tablet into download mode
2) Then I used odin to update the bootloader
3) Instead of clicking the "PDA" button in Odin I clicked the "Bootloader" button and started the flash process - which was the mistake
3) After this the tablet restartet
The problem is now the following. I cannot boot into the download mode anymore (the normal system still boots fine). When I press volume up + power the selection screen appears. When I then choose download mode, the screen turns black and the tablet restarts. I seem to have destroyed the bootloader.
So all methods to root the tablet with ODIN for flashing a new bootloader fail because I cannot get into download mode anymore.
So I tried the root method by copying the Rooting-Samsung-Galaxy-Tab-10.1.zip to the root directory. Then I went to the stock recovery mode and choose the option "update from external sd card" to install the root. Unfortunately I get the following message: "E:unknown volume for path [/sdcard]". I cannot find any way to choose a file. I read the the mount point in ICS to /sdcard is set during the boot process so its not available in the stock recovery mode.
So I am kind of stuck now because I cannot use Odin and also cannot use the stock recovery mode to do anything.
I also tried the following:
Reset to factory defaults - Didnt helpt still cannot get into download mode
Install Mobile Odin to flash a stock bootloader - did not work because there is no root
Does anyone of you have an idea? I am really stuck at the moment and would appreciate any help.
Try the emergency firmware recovery or re initialization tools in Kies and see how you get on. Never used them myself though so don't know how they're supposed to work. (May just try to invoke download mode?! I dunno!)
Sent from my GT-I9300
Sv: [Q] Bootloader destroyed - download mode stopped working
I would try a comple, and I mean a COMPLETE drain of the battery. It'll take a week but maybe that's your best option
http://forum.xda-developers.com/showthread.php?t=1478361
Regatds
~~~~~~~~~~~~~~~~~~~~~~~~~
Jader13254 brought me Ultimate HD for my Xperia Arc S.
Wedgess brought me LuPus kernel for the same.
Pershoot and the rest of the beloved CyanogenMod gang brought me CM10.1 for my Galaxy Tab 10.1
The community makes it all possible. THANK YOU ALL
saesch_swiss said:
I also tried the following:
Reset to factory defaults - Didnt helpt still cannot get into download mode
Install Mobile Odin to flash a stock bootloader - did not work because there is no root
Does anyone of you have an idea? I am really stuck at the moment and would appreciate any help.
Click to expand...
Click to collapse
If you've got Clockwork Mod recovery installed, you should be able to install superuser to give you root permission.
Or are you still running stock recovery?
Hi. I'm new to here so please i appreciate any help you can give .
So the story is... I own a samsung galaxy gio S5660 (i have Android 2.2.1 ) and i wanted to flash a custom rom on it. Well i forgot that i had to root it, so i just flashed the CWM recovery on it and now i cant get into the recovery, the samsung logo just stays. The phone works, it boots up but only not in the recovery mode :s. Also, i cant root from the pc either because i get unknown device, i installed kies, reinstalled the drivers... I get the error : Windows has stopped this device because it has reported problems. (Code 43). It charges via usb but doesnt connect as storage or something like that :/ i cant figure out what to do. The root programs dont recognize/find the device so am i screwed or what :s. I know i was stupid that i didnt think about the root. I've done the rooting on a tablet many times so i dont know why i forgot to do it :s
Thank you for reading. Hope i get an answer
BUMP BUMP-
I did a factory reset with the code from the phone and now its stuck on the samsung logo :s. It enters download mode and fastboot but the most important problem is that the pc doesnt recognize the device so i cant use odin or any similar program to flash a new recovery on it :s. Is there anything i could do?
I tried reinstalling the drivers multiple times.
I tried on 2 laptops and 1 desktop but it's all the same :S.
BUMP.
Help please
BUMP T_T
jaja
Prepare ODIN with the firmware you want to flash (in my case was Gingerbread 2.3.4) and get it ready to go.
-
Remove battery, wait for a bit. Insert battery again.
-
Flash a recovery with your specific filesystem (EXT4 or RFS)-(If you have EXT4, download ext4 only, don't get ext4+rfs)
-
Enter recovery & Wipe | Format:
System
Data
Cache
Dalvik Cache
Have ODIN ready. Connect phone to PC.
-
Reboot to Download Mode
Hold Volume down + Power + Home button at the same time.
-
At this point Odin should have detected your Galaxy Gio (Yellow rectangle should appear).
-
Insert the Stock Rom or Custom Rom.
-
Click Start button in Odin and wait about 5 min.
-
Reboot and wait
Method 2: http://forum.xda-developers.com/showthread.php?t=1153310
Method 3: using usb jig: http://www.youtube.com/watch?v=METM3teG5rI
It's not my fault if you hard brick your phone using this methods.
Thanks for answering, but i cant enter recovery as i mentioned early and also odin doesnt detect my phone in download mode :s. When the samsung logo just stays i plug also the usb in then the pc says it cannot recognize the device and its listed as unknown which i before also mentioned. When i attempt to enter recovery it just also stays at the samsung logo and isnt entering it :s..
Bumpbumppp
Guys i still dont got the answer :c
(Please excuse my poor English)
I have a Galaxy S3 i9300. OS is Android 4.3, rooted, and old version CWM recovery installed.
I can't remember exact OS and CWM recovery versions, because I had installed them years ago.
Today, I had decided to upgrade my old CWM recovery. I installed ROM Manager apps from
Google Play Store. (I installed and used the Rom Manager app for the first time)
I ran the Rom Manager app and upgraded CWM recovery as the app instructed. No errors were
reported. Then I chose "Reboot into Recovery".
Then the big trouble happend.
1. Normal "Samsung GALAXY S III GT-I9300" boot message appeared
2. Small Hat image and "ClockworkMode Recovery v6.0.4.6" message appeared
3. Screen blacked out.
4. Repeat 1~3 infinitely.
When I tried to connect via USB, my Windows7 PC could not recognize the i9300 at all.
I cannot use the i9300 as phone, too. I cannot do anything at all.
How can I fix this big trouble?
I have the same problem with TWRP recovery, keeps rebooting over and over again, sometimes the recovery menu appearing and reboots after some seconds automatically, please help
I had the same problem with my i9300 with CWM recovery it kept booting back to recovery no mather what i did i can recoment 2 things
1.flash new recovery with odin(did not try this but xould help
2. Flash original samsung firmware also with odin (this helped me)
My advice i olny flash recovery with odin roms with recovery
Thank you. I could fix the problem by flashing another kind of recovery app.
1. Enter the odin mode (press volume_down + home + power when power up , http://forum.xda-developers.com/wiki/Odin_mode )
2. Connect i9300 to PC via USB
3. Flash another kind of recovery app using Odin (in my case. CWMs are not work, but TWRPs are good)
I have a Tmobile GS6 Edge,My problem is this I was restoring a TWRP backup, coming from [ROM][5.1.1][OF8] OZOP EDGE. I used this Backup numerous times. But the last restore sent me into bootloop. I'm on OF8 but I ran an OF6 tar file through odin (it's the only one I can get to pass and run successfully). Heres what happened I connected my phone to computer, odin recognized it. hit start. ran successfully. rebooted, android guy came up briefly and said installing system update, then it changed to "Erasing..." then it rebooted again. Now I'm stuck in bootloop. I can boot to recovery and it says installing system update each time I boot to recovery, but selecting reboot system there shows a no command error. I force the phone to power off... power on again to bootloops.
smart switch didn't recognize the phone for a reset so I decided to go with the ODIN method and now i'm lost. I read to reboot to recovery, factory reset in recovery, power down option in recovery but I'm still in bootloop Hell. Just flashed G925TUVU3DOI1 with ODIN, same issue, wont boot past Samsung logo and now I am stuck with OI1 firmware. It will not allow me to downgrade to OF8 or OF6 for example. I have created and flashed successfully my own bootloader.img.tar file with Modem.img.tar.file as suggested. And yes im still stuck at Samsung logo. Any ideas? Please help. Update: I used the emergecy recovery option with Samsung smart switch and..... Blinking logo as usuall
Hello guys and thank you for reading this post. I have successfuly rooted my phone yesterday and tried to install Xposed framework. First I installed Xposed framework zip file and then apk. After that i enter recovery mode and flashed zip file. And my sad story starts now. After i flashed zip file i my phone get stucked at bootloop. So every time i try to power on my phone there only appear samsung logo and got stucked at that point. Then went in recovery mode to Advanced-File Manager and deleted xposed zip file. Then i tried to power on my phone but there i get stucked on samsung logo again. After that I back up all files. Then i wiped all Dalvik,System,Data,Internal Storage,Cache after that when i try to power on my phone it always enter recovery mode (it is not stucked at samsung logo)...I think i deleted my OS. I restore my back up data and tought that i will be at same point as before wiping but i am not. It keeps to enter recovery mode every time i try to power on phone. I don't know what to do now. Please help me! I have a problem with connecting my phone to PC too. :crying:
Please help...
Anyone? :crying:
Backup personal data -> factory reset -> reflash ROM -> restore data -> profit
But as said above, a little more information would be helpful. Device name, model number, what recovery, what version of android, blood type, social security number, you know, the normal stuff
How to reflash ROM?
Samsung Galaxy J5 (2016)
I can only enter Downloading mode and TWRP recovery.
Model: SM-J510FN
SNN: -J510FNGSMH