My phone is NOT on bootloop or brick. But instead every time I restart or on my phone the Samsung logo blinks for a while(1-2min) before it boots up. Tried looking up but cannnot find any answer. I am on Cyanogenmod ver. 10.
I tried to go in to recovery but cannot it keeps flashing on samsung logo. (all my buttons are working fine) I have CWM recovery. Just it just flash/blink for a while then restart again.
Is it a Hardware problem ? Please help!
You turned off your phone till it vibrates/pull out battery and then volume up+home+power button for about 20 minutes?
Sent from my iPad using Tapatalk
Sounds like it can also be because of software problem, most likely some form of corruption that causes the Samsung boot logo to reappear continuously. Try flashing a different rom and see if it helps or clean install the rom again
Regards, gsstudios
Related
Hey everyone, here's my problem
The device:
Galaxy S3 running Android 4.1.2
I'm running the Samsung based firmware, I have rooted the phone long before.
The problem:
My phone keeps randomly crashing / rebooting into a boot loop.
Once the phone crashes, it shows the boot screen saying "Samsung Galaxy S3 GT-I9300". Usually, this screen remains while "Samsung Galaxy S3 GT-I9300" keeps flashing.
Sometimes, pressing the power button while the boot screen is flashing helps and the phone starts.
Sometimes, I have to take the battery out to turn off the phone. Once the phone is off, pressing the power button helps and the phone starts.
So far I've tried the following to no avail:
* Enter recovery mode and clear cache
* Enter recovery mode and wipe all data
Any idea how to fix this? I'm pretty surprised that wiping all data didn't help. Any help would be greatly appreciated.
Factory reset you should try
Sent from my GT-I9300 using Tapatalk
I have done factory reset..even tried other rom to know whether rom causes problem!
on one thread i found its the power button is causing as it is faulty !
Can power button cause infinite boot loop ( i mean that samsung logo keep on blinking, after removing battery it will work ) ?
You are posting in the wrong forum.
Multiple Bootloop posts use search before posting .
Suggest you wipe phone flash stock rom and test but read the faqs and guides first .
Ok, so one night I was using my phone normally (Browsing. Watching YouTube, Playing Games) like everyone else does. Then all of a sudden it shuts off, but immediately turns on again without me pressing a button. (So basically it suddenly auto restarts on its own) This occured maybe 2-4 times (all in one night) until one time, it shuts off but doesn't turn on again (basically an automatic shutdown), so I tried turning it on again (Power button), then I got shocked because all of a sudden it enters a boot loop (Screen displaying this sequence : Samsung Galaxy S4 screen, my carrier logo screen, The encrypted screen (where you have to enter your encryption password) then again the Samsung logo but this time with the colors splashing from the background, then it shuts off again.) Sometimes after the boot loop sequence, it vibrates but never turns on again, sometimes it just turns off after the sequence. And as I try and try to get away from the boot loop, the sequence became shorter. So I'm guessing it's a battery problem, BUT my battery isn't bloated or deformed. I tried clearing the cache first, again the sequence got shorter (never going up to the carrier logo screen), then I tried formatting the data, still to no avail. Now, when I turn it on, It shows the Samsung logo screen for 2 seconds and shuts down.
I tried flashing it with ODIN thru Download mode BUT (HERE'S where another problem occured) :
My phone never get pass on the system.img.ext4 dialogue and my screen just goes blank. But ODIN still recognizes my phone. And when I remove the USB cable, ODIN says FAIL.
I'm sure the cable is working. I downloaded the firmware for my carrier (Tre 3).
What could be the real problem here?
Here is the description of my device :
Samsung Galaxy GT-I9505
Bought from Italy, Tre 3 carrier
Can I download a different region/carrier for my I9505 phone?
Advanced thanks for anyone who comments and I'm very sorry for my English. Thanks!
I would install TWRP recovery, boot to it, and use it to format data, which will remove the encryption. Then I would either push a rom to the phone via recovery or try to reinstall the stock firmware with Odin. Make sure that you run Odin as admin as well. The firmware must be the same version or newer. If you still have the stock recovery and can boot to it, then I think the build number of the currently installed firmware will be visible there. You should be able to use that to Google the correct version you need.
Hey it's me. Just posting a quick reply.
Thanks for replying to my post. Yesterday I successfully flash a rom to my GT-I9505 (Version 5.0.1 Italy HUI 3G). However it still didn't boot up. At first try it booted up to the first setup screen then just randomly shuts down. Then as I try to boot it up again, It just shuts down after the first Samsung logo (with the GT-I9505 logo), I can't boot into recovery cause it shuts down. I'm sure it's not a battery issue cause when I boot into download mode, it can stay in that screen for like 10 minutes. What could be the issue? I'm planning to disassemble my S4 sooner to see if something's wrong inside. Thanks again for the reply
Hello,
This is my first post so i hope that this is the right place.
I have a serious problem. My K910 is endlessly rebooting.
It all started after i updated android from 4.2.2 to 4.4.2 When device rebooted after installation it never came further than lenovo logo.
When phone turns on, it vibrates, then lenovo logo comes out for 2-3 seconds then it dissapears and the loop starts again.
it shuts down only when i push power button and volume- button multiple times.
I have tried to enter recovery/safe mode, but with no results phone keeps rebooting.
I reinstalled battery but still as i turn the phone on, same problem occurs.
As soon as i connect my phone to pc phone turns on and endless loop starts again.
Questions:
How can i change to stock ROM or connect to PC in this situation since it keeps on rebooting my pc doesnt see added device?
What can i do to fix this situation?
Please Help.
I promise $feedback if this thing can be fixed
trusis16 said:
Hello,
This is my first post so i hope that this is the right place.
I have a serious problem. My K910 is endlessly rebooting.
It all started after i updated android from 4.2.2 to 4.4.2 When device rebooted after installation it never came further than lenovo logo.
When phone turns on, it vibrates, then lenovo logo comes out for 2-3 seconds then it dissapears and the loop starts again.
it shuts down only when i push power button and volume- button multiple times.
I have tried to enter recovery/safe mode, but with no results phone keeps rebooting.
I reinstalled battery but still as i turn the phone on, same problem occurs.
As soon as i connect my phone to pc phone turns on and endless loop starts again.
Questions:
How can i change to stock ROM or connect to PC in this situation since it keeps on rebooting my pc doesnt see added device?
What can i do to fix this situation?
Please Help.
I promise $feedback if this thing can be fixed
Click to expand...
Click to collapse
That means your phone is in bootloop. Try opening recovery and wipe cache/data . If you got a custom recovery, then its much better.
Hello,
Also i experienced similar problem with a defective battery,
after i removed it too much,
fixed by replacing it,
hope it helps.
I tried posting in the VZW Note 5 section but hardly any people on there anymore and no responses yet.
My bone stock note 5 is stuck in a bootloop. This happened randomly one day while I was just using the phone. When I turn the phone on, the samsung logo appears and then flashes the blue recovery screen for a split second, only to reboot and back to the samsung logo. This repeats itself endlessly.
What I've tried:
Downloaded the correct version of Odin and successfully flashed the newest firmware (QA1). It passes Odin fine. Phone reboots only to do the same thing as before.
Tried turning off "auto reboot" in Odin, flashed stock firmware again. Once successful, I shut down the phone (volume down + power button). I then hold down volume up, home and power button until samsung logo appears, release power button (to get into recovery). It again, flashes a blue recovery screen for a split second and starts the boot loop all over again.
I am no expert but it seems like something is corrupted in the recovery which is why I cannot get into it. Even after flashing the stock firmware. I'm trying to get into the recovery after flashing the firmware so I can wipe cache and do factory reset, but I cannot get in.
Any idea what I can try next?
Thanks for any help/suggestions!
Have you tried flashing another firmware?
Sent from my TECNO Camon CX using Tapatalk
I've tried several, I got it to boot up with QB9 but it stays stuck at the verizon logo
And it doesn't go into recovery too on QB9?
Sent from my TECNO Camon CX using Tapatalk
Hi All
I have a ulefone power 3 which isnt modified at all , my problem is its stuck in a boot loop and not sure what to do
when i hold up and power and go into recovery it just keeps rebooting so cannot do anything, kinda new to any kind of flashing but does anyone have any ideas on what i need to do please
thanks
I think you need to flash your phone like this : http://ulefone.com/download/power3.html
same with power 3s
UPDATE: It was possible to flash the phone, but now i have some "shifted" lines on my display
UPDATE2: After performing an wireless update, everything works fine again (without twrp)
Hi, I have the same problem,
Ulefon Power 3s, after i tried to install twrp (everything worked like in the deskription at https://forum.xda-developers.com/android/development/ulefone-power-3-twrp-3-2-1-0-root-t3741853)
The phone is stuck in a bootloop (Orange State like https://img.xda-cdn.com/2fPFK8gGwJxzn2rNTC6VzDxvLI8=/https://i.imgur.com/tLOV7sz.jpg?1)
When i press the power and volume up button the screen stays black and the phone still stays inthe bootloop.
Right now I am not able to stop this bootloop.
My tools are also to big to disconnect the batery.
I am not able to connect with my computer at this time.
I asked the smae at the twrp thread.
Any suggestions?
Thanks!
Hello i have the same problem i think this version of twrp do not work with the lastet firmwares from ulefone. I think the twrp have an issue with the rom version v40...
I also stuck in the bootloop and the only thing that i could do was a new flash...